TOTAL POWER INT'L SP-750 750W Single Output Power Supply series Features : Universal AC input/Full range AC input active surge current limiting Built-in active PFC function,PF>0.95 Protections:Short circuit, overload, over voltage, over temperature Forced air cooling by built-in DC ball bearing fan 3 High power density 5.48/inch Built-in constant current limiting circuit With power good and fail signal output Built-in remote ON-OFF control Built-in remote sense function 3 years warranty SPECIFICATION MODEL OUTPUT SP-750-5 SP-750-12 SP-750-15 SP-750-24 SP-750-27 SP-750-48 DC VOLTAGE 5V 12V 15V 24V 27V 48V RATED CURRENT 120A 62.5A 50A 31.3A 27.8A 15.7A CURRENT RANGE 0 ~ 120A 0 ~ 62.5A 0 ~ 50A 0 ~ 31.3A 0 ~ 27.8A 0 ~ 15.7A RATED POWER 600W 750W 750W 751.2W 750.6W 753.6W 120mVp-p 120mVp-p 120mVp-p 120mVp-p 120mVp-p 13.5 ~ 16.5V 22 ~ 26.4V 24 ~ 30V 43 ~ 56V 1.0% 0.2% 0.5% 1.0% 0.2% 0.5% RIPPLE & NOISE (max.) Note.2 120mVp-p VOLTAGE ADJ. RANGE 4.75 ~ 5.5V VOLTAGE TOLERANCE Note.3 2.0% SETUP, RISE, HOLD TIME 10 ~ 13.5V 1.0% 0.5% 0.3% 2.0% 0.5% 1000ms, 50ms, 16ms/230VAC VOLTAGE RANGE 90 ~ 264VAC FREQUENCY RANGE 47 ~ 63Hz POWER FACTOR EFFICIENCY (Typ.) AC CURRENT 0.95/230VAC 81% LINE REGULATION LOAD REGULATION INPUT INRUSH CURRENT (max.) 11A/115VAC 30A/115VAC LEAKAGE CURRENT <2.0mA / 240VAC 1.0% 1.0% 0.3% 0.2% 0.5% 0.5% 1000ms, 50ms, 16ms/115VAC at full load 127 ~ 370VDC 0.96/115VAC at full load 86% 87% 89% 89% 90% 5.3A/230VAC 50A/230VAC 105~125% rated output power OVER LOAD PROTECTION OVER VOLTAGE OVER TEMPERATURE FUNCTION Protection type : Constant current limiting, unit will Hiccup after 3 sec. 5.75 ~ 6.3V 13.8 ~ 16.2V 18 ~ 21V 27.6 ~ 32.4V 31 ~ 36.5V 57.6 ~ 67.2V Protection type : Shut down o/p voltage, re-power on to recover 85 5 (TSW1 ) Detect on heatsink of power transistor 85 5 (TSW2 ) Detect on heatsink of power diode POWER GOOD/FAIL Protection type : Shut down o/p voltage, recovers automatically after temperature goes down 50ms/1ms REMOTE CONTROL RC+/RC- short power on, open power off WORKING TEMP. -20 ~ +60 (Refer to output load derating curve) 20~90% RH non-condensing WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY -40 ~ +85 , 10 ~ 95% RH TEMP. COEFFICIENT 0.05%/ (0 ~ 50 ) VIBRATION 10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes SAFETY STANDARDS UL60950-1, TUV EN60950-1 Approved WITHSTAND VOLTAGE I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC SAFETY & ISOLATION RESISTANCE EMI CONDUCTION & RADIATION Compliance to EN55011 (CISPR11), EN55022 (CISPR22) Class B EMC (Note 4) HARMONIC CURRENT Compliance to EN61000-3-2,-3 EMS IMMUNITY MTBF OTHERS DIMENSION PACKING NOTE Compliance to EN61000-4-2,3,4,5,6,8,11, ENV50204, EN55024, EN61000-6-2, EN61204-3 Heavy industry level, criteria A 769.3K hrs min. MIL-HDBK-217F (25 278*127*63.5mm (L*W*H) 2.9Kg; 6pcs / 18.4Kg / 0.98CUFT ) 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. Total Power Int'l 418 Bridge Street Lowell, MA 01850 PH: 978-453-7272 FX: 978-453-7395 Web: www.total-power.com Sales: [email protected] TOTAL POWER INT'L SP-750 750W Single Output Power Supply Mechanical Specification Case No.919A series Unit:mm 16 220 20 5 30 63.5 113 4-M3 4-M3 L=6 4-M3 O/P 1 2 240 251 278 5 40.5 51 62 73 84 24.75 30 CONTROL 240 1 2 3 7 7 10 I/P 39 113 127 Air flow direction 20 4-M3 220 16 TOP VIEW AC Input Terminal Pin. No. Assignment Pin No. 1 2 3 BOTTOM VIEW DC Output Terminal Pin. No Assignment Assignment AC/L AC/N FG Pin No. 1 2 Assignment DC OUTPUT +V DC OUTPUT -V Control Pin. No Assignment : MOLEX 5559-NP uses 5558male crimp terminal Pin No. 1 2 3 4 Assignment NC -S G RC- Terminal Pin No. Assignment Mating connector 5 NC MOLEX 5556 PF(Power fail signal) 6 MOLEX 5557-NR Female crimp Terminal +S 7 receptacle RC+ 8 Derating Curve Static Characteristics 100 OTHERS 100 90 80 85 70 5V LOAD (%) LOAD (%) 60 40 20 -20 60 50 40 0 10 20 30 40 45 50 AMBIENT TEMPERATURE ( ) 60 70 90 95 100 115 INPUT VOLTAGE (VAC) 60Hz Total Power Int'l 418 Bridge Street Lowell, MA 01850 PH: 978-453-7272 FX: 978-453-7395 Web: www.total-power.com Sales: [email protected] 260 7