QSB34GR, QSB34ZR, QSB34CGR, QSB34CZR Surface Mount Silicon Pin Photodiode Features ■ Daylight Filter (QSB34GR and QSB34ZR only) ■ Large Chip Size = 3mm x 3mm ■ Surface Mount Packages: ■ Sensitive Area - 2.55mm x 2.55mm – QSB34GR/QSB34CGR for overmount board – QSB34ZR/QSB34CZR for undermount board ■ Fast PIN Photodiode ■ Wide Reception Angle, 120° ■ High Sensitivity ■ Low Capacitance ■ Available in 0.470" (12mm) width tape on 7" (178mm) diameter reel; 1,000 units per reel Package Dimensions, QSB34GR 4.50 4.30 Anode Chip 1.70 1.50 4.00 3.80 0.90 0.70 1.50 Schematic 0.175 Package Center Chip Center ANODE Photosensitive surface 0.80 0.70 0.17 0.13 0.10 Min 0–5° 4.00 3.80 CATHODE 1.20 6.70 6.10 Notes: 1.Dimensions for all drawings are in mm. 2.Tolerance of ±.0.13 on all non-nominal dimensions unless otherwise specified. ©2000 Fairchild Semiconductor Corporation QSB34GR, QSB34ZR, QSB34CGR, QSB34CZR Rev. 1.0.3 www.fairchildsemi.com QSB34GR, QSB34ZR, QSB34CGR, QSB34CZR — Surface Mount Silicon Pin Photodiode August 2008 Stresses exceeding the absolute maximum ratings may damage the device. The device may not function or be operable above the recommended operating conditions and stressing the parts to these levels is not recommended. In addition, extended exposure to stresses above the recommended operating conditions may affect device reliability. The absolute maximum ratings are stress ratings only. Symbol Rating Unit TOPR Operating Temperature Parameter -25 to +85 °C TSTG Storage Temperature -40 to +85 °C TSOL Soldering Temperature 260 °C VR Reverse Voltage 32 V PC Power Dissipation at (or below) 25°C Free Air Temperature 150 mW Note: 1. Soldering time ≤ 5 seconds Electrical/Optical Characteristics (TA =25°C unless otherwise specified) The Recommended Operating Conditions table defines the conditions for actual device operation. Recommended operating conditions are specified to ensure optimal performance to the datasheet specifications. Fairchild does not recommend exceeding them or designing to absolute maximum ratings. Symbol Parameter VR Test Conditions Reverse Voltage IR = 0.1mA IR(D) Dark Reverse Current VR = 10V λPK Peak Sensitivity VR = 5V Θ IPH Min. Typ. Max. Units 30 nA 32 Reception Angle @ 1/2 Power 1.0mW/cm2, VCE nm ±60 ° Photo Current Ee = 37 µA Capacitance VR = 3V 25 pF tr Rise Time VR = 10V, RL = 50Ω 50 ns tf Fall Time VR = 10V, RL = 50Ω 50 ns Spectral Sensitivity QSB34GR, QSB34ZR QSB34CGR, QSB34CZR ©2000 Fairchild Semiconductor Corporation QSB34GR, QSB34ZR, QSB34CGR, QSB34CZR Rev. 1.0.3 25 940 C λ0.5 = 5V(4) V 730 400 1100 1100 nm www.fairchildsemi.com 2 QSB34GR, QSB34ZR, QSB34CGR, QSB34CZR — Surface Mount Silicon Pin Photodiode Absolute Maximum Ratings (TA = 25°C unless otherwise specified) Fig. 1 Relative Spectral Sensitivity vs. Wavelength 80 QSB34CGR, QSB34CZR ISC - SHORT CIRCUIR CURRENT (µA) RELATIVE SPECTRAL SENSITIVITY 1.0 Fig. 2 Short Circuit Current vs. Irradiance 0.8 0.6 0.4 0.2 QSB34GR, QSB34ZR 0 100 300 60 40 20 VR = 5V λ = 940nm Ta = 25°C 500 700 0 900 1100 0 1300 0.5 1.0 1.5 Ee - IRRADIANCE (mW/cm2) λ – WAVELENGTH (nm) Fig. 3 Capacitance vs. Reverse Voltage Fig. 4 Dark Current vs. Temperature 1000 80 f = 1 MHz H = 0mW/cm2 IR - DARK CURRENT (nA) CAPACITANCE (pF) 60 40 20 100 10 VR = 10 V Ee = 0mV/cm2 0 1 0.1 1 10 100 20 40 VR - REVERSE VOLTAGE (V) Fig. 5 Dark Current vs. Reverse Voltage 60 80 TA -TEMPERATURE (°C) 100 Fig. 6 Response Time vs. Load Resistance 101 1200 VR = 10V TA = 25°C Ee = 0mV/cm2 100 RESPONSE TIME tr, ff (µs) IR -DARK CURRENT (pA) 1000 800 600 400 200 0 0 2 4 6 8 10 12 14 16 18 10-2 10-3 101 20 102 103 104 105 LOAD RESISTANCE RL (Ω) VR - REVERSE VOLTAGE (V) ©2000 Fairchild Semiconductor Corporation QSB34GR, QSB34ZR, QSB34CGR, QSB34CZR Rev. 1.0.3 10-1 www.fairchildsemi.com 3 QSB34GR, QSB34ZR, QSB34CGR, QSB34CZR — Surface Mount Silicon Pin Photodiode Typical Performance Curves 4.50 4.30 Anode Chip Recommended Solder Screen Pattern (For Reference Only) 1.70 1.50 7.4 4.3 4.00 3.80 0.90 0.70 1.8 1.50 Package Center 0.175 1.55 Note: 1. All dimensions in mm 2. Pattern applies to both QSB34GR and QSB34ZR Chip Center 6.70 6.10 Photosensitive surface 0.20 0.10 1.10 0.90 0.10 0–5° 1.20 0.012 (0.30) Note: 1. Dimensions for all drawings are in mm. 2. Tolerance of ±.0.13 on all non-nominal dimensions unless otherwise specified. Recommend IR Reflow Soldering Profile 1 ~ 3°C/sec. 260°C Max. 10sec. Max. 1 ~ 3°C/sec. Pre-heating 180 ~ 200°C 60sec. Max. Above 220°C 120sec. Max. ©2000 Fairchild Semiconductor Corporation QSB34GR, QSB34ZR, QSB34CGR, QSB34CZR Rev. 1.0.3 www.fairchildsemi.com 4 QSB34GR, QSB34ZR, QSB34CGR, QSB34CZR — Surface Mount Silicon Pin Photodiode Package Dimensions, QSB34ZR Package Dimensions QSB34GR, QSB34ZR, QSB34CGR, QSB34CZR — Surface Mount Silicon Pin Photodiode Ordering Information Option Description QSB34GR Gullwing, 1000 units per reel QSB34ZR Z-Bend reversed, 1000 units per reel QSB34CGR Gullwing, 1000 units per reel QSB34CZR Z-Bend reversed, 1000 units per reel Tape & Reel Dimensions Ø178±1.0 2.5 0± 0 .5 0.5 0± 2.5 Ø60.2±0.5 Ø13±0.5 13.2±1.5 4.0±0.10 2.0±0.05 Ø1.5±0.1 Ø1.50±0.25 4.20±0.10 8.0±0.10 6.90±0.10 5.5±0.05 COVER TAPE 12 +0.3 –0.1 9° CATHODE 1.75±0.10 16.0±0.2 1.45±0.10 Unit: mm ©2000 Fairchild Semiconductor Corporation QSB34GR, QSB34ZR, QSB34CGR, QSB34CZR Rev. 1.0.3 www.fairchildsemi.com 5 PDP SPM™ Power-SPM™ PowerTrench® Programmable Active Droop™ QFET® QS™ Quiet Series™ RapidConfigure™ Saving our world, 1mW at a time™ SmartMax™ SMART START™ SPM® STEALTH™ SuperFET™ SuperSOT™-3 SuperSOT™-6 SuperSOT™-8 SupreMOS™ SyncFET™ FPS™ F-PFS™ FRFET® SM Global Power Resource Green FPS™ Green FPS™e-Series™ GTO™ IntelliMAX™ ISOPLANAR™ MegaBuck™ MICROCOUPLER™ MicroFET™ MicroPak™ MillerDrive™ MotionMax™ Motion-SPM™ OPTOLOGIC® OPTOPLANAR® Build it Now™ CorePLUS™ CorePOWER™ CROSSVOLT™ CTL™ Current Transfer Logic™ EcoSPARK® EfficentMax™ EZSWITCH™ * ™ ® Fairchild® ® Fairchild Semiconductor FACT Quiet Series™ FACT® FAST® FastvCore™ FlashWriter® * ® ® The Power Franchise TinyBoost™ TinyBuck™ ® TinyLogic TINYOPTO™ TinyPower™ TinyPWM™ TinyWire™ µSerDes™ UHC® Ultra FRFET™ UniFET™ VCX™ VisualMax™ ® * EZSWITCH™ and FlashWriter® are trademarks of System General Corporation, used under license by Fairchild Semiconductor. DISCLAIMER FAIRCHILD SEMICONDUCTOR RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION, OR DESIGN. FAIRCHILD DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESCRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS. THESE SPECIFICATIONS DO NOT EXPAND THE TERMS OF FAIRCHILD’S WORLDWIDE TERMS AND CONDITIONS, SPECIFICALLY THE WARRANTY THEREIN, WHICH COVERS THESE PRODUCTS. LIFE SUPPORT POLICY FAIRCHILD’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF FAIRCHILD SEMICONDUCTOR CORPORATION. As used herein: 1. Life support devices or systems are devices or systems which, (a) are intended for surgical implant into the body or (b) support or sustain life, and (c) whose failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in a significant injury of the user. 2. A critical component in any component of a life support, device, or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness. ANTI-COUNTERFEITING POLICY Fairchild Semiconductor Corporation's Anti-Counterfeiting Policy. Fairchild's Anti-Counterfeiting Policy is also stated on our external website, www.fairchildsemi.com, under Sales Support. Counterfeiting of semiconductor parts is a growing problem in the industry. All manufacturers of semiconductor products are experiencing counterfeiting of their parts. Customers who inadvertently purchase counterfeit parts experience many problems such as loss of brand reputation, substandard performance, failed applications, and increased cost of production and manufacturing delays. Fairchild is taking strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. Fairchild strongly encourages customers to purchase Fairchild parts either directly from Fairchild or from Authorized Fairchild Distributors who are listed by country on our web page cited above. Products customers buy either from Fairchild directly or from Authorized Fairchild Distributors are genuine parts, have full traceability, meet Fairchild's quality standards for handling and storage and provide access to Fairchild's full range of up-to-date technical and product information. Fairchild and our Authorized Distributors will stand behind all warranties and will appropriately address any warranty issues that may arise. Fairchild will not provide any warranty coverage or other assistance for parts bought from Unauthorized Sources. Fairchild is committed to combat this global problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized distributors. PRODUCT STATUS DEFINITIONS Definition of Terms Datasheet Identification Product Status Advance Information Formative / In Design Preliminary First Production No Identification Needed Full Production Obsolete Not In Production Definition Datasheet contains the design specifications for product development. Specifications may change in any manner without notice. Datasheet contains preliminary data; supplementary data will be published at a later date. Fairchild Semiconductor reserves the right to make changes at any time without notice to improve design. Datasheet contains final specifications. Fairchild Semiconductor reserves the right to make changes at any time without notice to improve the design. Datasheet contains specifications on a product that is discontinued by Fairchild Semiconductor. The datasheet is for reference information only. Rev. I35 ©2000 Fairchild Semiconductor Corporation QSB34GR, QSB34ZR, QSB34CGR, QSB34CZR Rev. 1.0.3 www.fairchildsemi.com 6 QSB34GR, QSB34ZR, QSB34CGR, QSB34CZR — Surface Mount Silicon Pin Photodiode TRADEMARKS The following includes registered and unregistered trademarks and service marks, owned by Fairchild Semiconductor and/or its global subsidiaries, and is not intended to be an exhaustive list of all such trademarks.