Oscilent Corporation IF SAW Filter | 807-IF246.0M-B Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 807-IF246.0M-B 7.0 x 5.0 SMD Mobile Communication Jan. 01, 2007 . TYPE : IF SAW Filter PART NUMBER : 807-IF246.0M-B .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 246 - MHz Minimum Insertion Loss Fo +/- 50.0 kHz - 5.0 6.5 dB Stop Band Attenuation: Fo -25.00 ~ Fo-0.60 MHz 50.0 58.0 - Fo -0.60 ~ Fo -0.40 MHz 32.0 45.0 - Fo -0.40 ~ Fo -0.20 MHz 10.0 25.0 - Fo +0.20 ~ Fo +0.40 MHz 10.0 25.0 - Fo -0.40 ~ Fo -0.60 MHz 32.0 45.0 - Fo -0.60 ~ Fo -25.0 MHz 50.0 60.0 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm Fo +/- 50.0 kHz - 1.2 2.0 dBp-p Center Frequency (Fo) Amplitude Ripple * With Matching Network (Ref. Testing Environment Circuit as shown below) . PACKAGE OUTLINE (mm) dB Oscilent Corporation IF SAW Filter | 807-IF246.0M-B TEST FIXTURE TEST FIXTURE AND VALUES/SOURCE AND LOAD IMPEDANCE 50 ohm INPUT: L1: 68 nH; C1: 0.75pF OUTPUT: L2: 120 nH; C2: 0.5pF FREQUENCY RESPONSE Page 2 of 3 Oscilent Corporation IF SAW Filter | 807-IF246.0M-B Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 807-IF246.0M-B