Catalog: 1654001 Issue Date: 06.2011 Corcom Product Guide The CHAMELEON Adaptable Module for DC Applications P Series EN 60 950 UL Recognized CSA Certified TUV Certified P Series Specifications • Full flexibility of design in the most compact package • General purpose designed for DC applications • Mates with a standard MOLEX* connector (HCS Series) which prevents accidental connection to AC Power Ordering Information P S 0 0 0 D D3D (DC Version) Current Rating 3 = 3A 6 = 6A X = 10A Filter Type D = DC version Fuse Options D = Dual fuse S = Single fuse Input Voltage Select 0 = Single voltage Switch Options 0 = No switch Extender Options 0 = None Rated Voltage (max): 80 VDC Rated Current: 3 to 10A Fuseholder*: Terminals: 2250 VDC 1450 VDC .25 x 1.25” or 5 x 20 mm .187 x .032 [4.8 x .81] terminal tabs 4 Operating Ambient Temperature Range (at rated current Ir): -10°C to +40°C In an ambient temperature (Ta) higher than +40°C the maximum operating current (Io) is calculated as follows: Io = Ir (85-Ta)/45 DC Filters Shield Options D = Complete Shield Hipot rating (one minute): Line to Ground: LIne to Line: Electrical Schematic LINE LOAD Available Part Numbers PE000DD3D PE000DD6D PE000DDXD PE000SD3D PE000SD6D PE000SDXD Mounting Style E = Mounting ears S = Snap-in PS000DD3D PS000DD6D PS000DDXD PS000SD3D PS000SD6D PS000SDXD 223 Dimensions are in inches and millimeters unless otherwise specified. Values in italics are metric equivalents. Dimensions are shown for reference purposes only. Specifications subject to change. For email, phone or live chat, please go to te.com/help corcom.com Catalog: 1654001 Issue Date: 06.2011 Corcom Product Guide The CHAMELEON Adaptable Module for DC Applications (continued) P Series Case Styles Case Dimensions PE Part No. B C D E F PE C A PS Recommended Panel Cutouts F A .06 R Max. 1.52 B .07 1.78 min. Radius Ground connection PS E External Edge (1) .020 R Min. .508 C D B Note: The external edges (installation side) on the "D" sides of the cutout should have a minimum .020" radius. For optimal retention against extraction, the corresponding inner edge should be sharp, without paint or coatings. Edge coatings, including anodization are also discouraged for good shield contact. A Performance Data Accessories Minimum Insertion Loss Red Black Measured in closed 50 Ohm system Common Mode / Asymmetrical (Line to Ground) GA210 – (shown above) Pre-assembled connector housing with two 36” long 18 gauge wires to mate with P Series DC filters Differential Mode / Symmetrical (Line to Line) MOLEX Part Numbers: 03-12-1026 DC Connector housing for P Series 18-12-1222 Female terminals (2 per connector) 224 Dimensions are in inches and millimeters unless otherwise specified. Values in italics are metric equivalents. Dimensions are shown for reference purposes only. Specifications subject to change. For email, phone or live chat, please go to te.com/help corcom.com