RADIAL-TAPING SPECIFICATIONS FOR RECTIFIERS h h P P2 D h A h Insulation Coating P1 H1 H W2 L1 L W1 F W0 H0 Cathode A W t T D0 P0 detail A d Feeding direction Fig. Configuration of PANASERT CODING: 1N4001S-NAB ITEM Body diameter Body height COATING METHOD (A) PACKAGING METHOD (B) 0: NON-INSULATION COATING, LEAD FIRST OUT. 0: CATHODE UP, IN REEL PACKAGING. 1: INSULATION COATING, LEAD FIRST OUT. 1: CATHODE UP, IN BULK PACKAGING. 2: NON-INSULATION COATING, BODY FIRST OUT. 2: CATHODE DOWN, IN REEL PACKAGING. 3: INSULATION COATING, BODY FIRST OUT. 3: CATHODE DOWN, IN BULK PACKAGING. SYMBOL D A SPECIFICATIONS (mm) 2.7 max. 5.2+0.5 SPECIFICATIONS (inch) 0.107 max. 0.205+0.020 Lead wire diameter d 0.6+0.1 0.024+0.004 Component pitch P 12.7+1.0 0.500+0.040 Feed hole pitch P0 Component lead spacing F 12.7+0.3 +0.4 5.0 0.1 0.500+0.012 +0.016 0.197 0.004 0.0+0.040 h 0.0+1.0 Tape width W 18.0+0.5 0.709+0.020 Hold-down tape width W0 12.5 min. 0.492 min. Deflection +0.75 9.0 0.50 +0.030 0.020 Hole position W1 Length from seating plane H 19.5+1.0 0.768+0.040 Component height H1 32.25 max. 1.27 max. Feed hole diameter Total tape thickness D0 t 4.0+0.2 1.5 max. Cut out length L 11.0 max. 0.433 max. Lead wire (taped portion) 2.5 min. Lead protrution L1 T 0.098 min. 0.031 max. Lead wire clinch height H0 16.0+0.5 Feed hole center to lead P1 Center of seating plane location Adhesive tape position 0.354 0.157+0.008 0.059 max. 0.8 max. 0.630+0.020 P2 3.85+0.7 6.35+1.0 0.250+0.040 W2 0.5 max. 0.020 max. STANDARD PACKAGING(EA) 0.152+0.028 2K / AMMO BOX NOTES: 1. Packaging per EIA/JEDEC standard RS-468. Available only for A-405 product utilizing 0.6mm diameter leads. 2. Maximum cumulative pitch tolence: 1.0mm/20pitches. 3. An exposion of 1.5mm max. from body is allowed for lead insulation coating.