Cree XQ-B White Series on Board

Cree XQ-B White Series on Board
Cree XQ-B White Series on Board
XLamp XQ-B LEDs delivers the unique combination of small size, reliability and
novel light distribution. This combination of features enable the next generation of
designs for applications that require broader light distribution, such as omnidirectional lamps and fixtures.
FEATURES
> Cree's smallest lighting class: 1.6 x 1.6 x 1.6 mm
> Wide viewing angle: 140°
> 300 mA maximum drive current
FLUX CHARACTERISTICS
COLOR
Cool White
Neutral White
Warm White
CHARACTERISTICS
Viewing angle (FWHM)
Thermal Resistance, Junction to Solder Point
ESD classification (HBM per Mil-Std-883D)
DC forward current
Reverse voltage
Forward voltage (@ 80 mA, 25 °C)
Temperature coefficient of voltage
APPLICATIONS
> Non-Directional
> Distributed
> Exterior Area
> Landscape
CCT (TYP.) MIN.FLUX (LM) @350MA KIT USED
30.6
6000K
L053
26.5
4000K
BXE5
26.5
3000K
BXE7
UNIT
degrees
°C/W
mA
V
V
mV/°C
MINIMUM
TYPICAL
140
17
Class 1
80
MAXIMUM
3
-2
It is highly recommended for the user to review the CREE Series page for additional and most recent technical data at:
http://www.cree.com/led-components-and-modules/products/xlamp/discrete-directional/xlamp-xqb
Global Headquarters, 3 Northway Lane North, Latham, NY 12110, USA www.marktechopto.com
TOLL FREE: 1-800-984-5337 • PHONE: 518-956-2980 • FAX: 518-785-4725 • EMAIL: [email protected]
300
-5
3.4
Cree XQ-B White Series on Board
* Exceeding maximum ratings may damage the LED and cause potential safety hazards.
* Elevated operating temperatures can be expected to negatively impact the service life (lumen output)
* All data is related to entire assembly. Data reflects statistical mean values. Actual data may differ depending on variances
in the manufacturing process.
* End users need to take into account the lumen depreciation as the temperature rises with various thermal solutions
installed.
Note 1: Using continuously under elevated loads (i.e. the application of high temperature/current/voltage or a significant
change in temperature, etc.) may cause this product to significantly decrease in reliability even if the operating conditions are
within the
absolute maximum ratings.
Note 2: The thermal resistance from the LED junction to ambient temperature, Rth(j-a), should be kept below 100C/W so that
the LED is not exposed to a condition beyond the absolute maximum ratings.
Note 3: The temperature of the LED assembly must be measured at the TC-point according to EN60598-1 in a thermally
constant status with a temperature sensor or a temperature sensitive label.
Hardware (not included)
> Mount with #4 Machine Screws.
> 16AWG Maximum Wire Gauge.
> Use only with constant current power supplies.
PCB Fabrication
> Layer Count: 1
> Core Material: 6061-T6 Aluminum
> Single Layer Copper Weight: 1oz
> Solder Mask: White
> Finishing Plating: Pb Free HASL
Global Headquarters, 3 Northway Lane North, Latham, NY 12110, USA www.marktechopto.com
TOLL FREE: 1-800-984-5337 • PHONE: 518-956-2980 • FAX: 518-785-4725 • EMAIL: [email protected]