100GbE 100m CFP Transceiver

100GbE 100m CFP Transceiver
Product Description
The CFP1C0XSRC000E1G transceiver is a hot pluggable fiber optic transceiver in
the CFP form factor. Integrating 10 independent channels of 10G transmitting
and receiving functions makes it ideally suited for 100G very short reach
applications where cost effective high bandwidth is needed. The diagnostic and
control functions are integrated into the design via a set of non-data hardware
signal pins and Management Date Input/Output (MDIO) interface per the CFP
Multi-Source Agreement (MSA) Management Interface Specification draft 1.4.
The transceiver supports an aggregate bandwidth of 100G over 100 meters of
optical fiber. Each lane transmits and receives data streams at typical data rate
of 10.3125Gbps. The CFP transceiver has a single MPO port which connects
to an industry standard 2x12 multi-mode fiber cable. It provides an excellent
solution for 100GbE data transmission at 850nm over up to 100m multimode
mode ribbon cables. The product is designed and tested in accordance with
industry safety standards. The transceiver is Class 1 Laser product per U.S. FDA/
CDRH and international IEC-60825 standards.
The CFP1C0XSRC000E1G transceiver connects to standard 148-pin CFP
connectors for hot plug capability. This allows the system designer to make
configuration changes or maintenance by simply plugging in different
transceivers without removing the power supply from the host system. The
transmitter and receiver DATA interfaces are internally AC-coupled. LV-CMOS
Transmitter Disable control input and Loss of Signal (LOS) output interfaces are
also provided.
The transceiver can be conveniently assembled into and released from the host
system through the railing system specified in the CFP MSA.
The transceiver operates from a single +3.3V power supply over an operating
case temperature range of 0°C to +70°C. The housing is made of metal for EMI
 Integrated 10 independent full duplex
 Transmission distance up to 100m (MM fiber)
 Support CFP MSA and CAUI electrical interface
 Compliant to IEEE 802.3ba 100Gbase-SR10
 Control functions through the CFP
management interface
 CFP Power Class 1(<8W)
 RoHS 6/6 compliant
Ordering Information
Model Name
An Oplink Company
Operating Temperature
- 5°C to +70°C
Norminal Wavelength
S0300. Rev.01. 2012-02-16
CONTACT  46335 Landing Pkwy  Fremont  CA  94538  TEL : +1 (510) 933-7200  FAX : +1 (510) 933-7300  EMAIL : [email protected]  www.OPLINK.com 