PO3B10A www.potatosemi.com 2-Channel, 2:1 Mux/DeMux Switch w/ Single Enable High Bandwidth Potato Chip FEATURES: DESCRIPTION: • Patented technology • High signal -3db passing bandwidth at 3.5Gbps or 1.75GHz • Near-Zero propagation delay • VCC = 1.65V to 3.6V • Ultra-Low Quiescent Power: 0.1µA typical • Ideally suited for low power applications • Industrial operating temperature: -40°C to +85°C • Available in 12pin DFN package Potato Semiconductor’s PO3B10A is designed for world top performance using submicron CMOS technology to achieve GHz high bandwidth. The PO3B10A is a 2-channel, 2:1 Multiplexer / Demultiplexer with 3-state outputs. The switch introduces no additional ground bounce noise or propagation delay. Pin Configuration Block Diagram GND 1 12 0l0 VDD 2 11 1I0 Y0 3 10 0I1 Y1 4 9 1I1 GND 5 8 VDD SEL 6 7 GND Y0 Y1 0I0 1I0 0I1 1I1 SEL Truth Table Function SEL Yn to nIo L Yn to nI1 H Potato Semiconductor Corporation 1 01/01/10 PO3B10A www.potatosemi.com 2-Channel, 2:1 Mux/DeMux Switch w/ Single Enable High Bandwidth Potato Chip Maximum Ratings (Above which the useful life may be impaired. For user guidelines, not tested.) Storage Temperature ................................................ –65°C to +150°C Ambient Temperature with Power Applied ............... –40°C to +85°C Supply Voltage to Ground Potential ........................... –0.5V to +4.6V DC Input Voltage ........................................................ –0.5V to +Vcc DC Output Current................................................................... 120mA Power Dissipation ....................................................................... 0.5W Note: Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability. DC Electrical Characteristics, 3.3V Supply (Over the Operating Range, TA = –40°C to +85°C, VCC = 3.3V ±10%) Parameters Description Min. Typ. Test Conditions Max. VIH Input HIGH Voltage Guaranteed Logic HIGH Level VIL Input LOW Voltage Guaranteed Logic LOW Level 0.8 IIH Input HIGH Current VCC = Max., VIN = VCC ±1 IIL Input LOW Current VCC = Max., VIN = GND ±1 IOZH High Impedance Output Current 0 Y, In 2.0 VCC ION = -48 mA or -64mA Switch On-Resistance V A ±1 VCC = Min., VIN = 0.0V, RON Units VCC = Min., VIN = VCC , ION = -15 mA 14 18 16 20 DC Electrical Characteristics, 2.5V Supply (Over Operating Range, TA = –40°C to +85°C, VCC = 2.5V ± 10%) Parameters Description Test Conditions Min. Typ. Max. VIH Input HIGH Voltage Guaranteed Logic HIGH Level 1.8 VCC + 0.3 VIL Inout LOW Voltage Guaranteed Logic LOW Level –0.3 0.8 IIH Input HIGH Current VCC = Max., VIN = VCC ±1 IIL Input LOW Current VCC = Max., VIN = GND ±1 IOZH High Impedance Current 0 ±1 RON Switch On Resistance Potato Semiconductor Corporation Y, In VCC VCC = Min., VIN = 0.0V, ION = –48mA 18 22 VCC = Min., VIN = Vcc, ION = -15mA 18 22 2 Units V A 01/01/10 PO3B10A www.potatosemi.com 2-Channel, 2:1 Mux/DeMux Switch w/ Single Enable High Bandwidth Potato Chip Power Supply Characteristics Symbol Description Quiescent Power Supply Current Icc Test Conditions (1) Min Typ Vcc=Max, Vin=Vcc or GND - 0.1 Max Unit 3 uA Notes: 1. 2. 3. 4. 5. For conditions shown as Max. or Min., use appropriate value specified under Electrical Characteristics for the applicable device type. Typical values are at Vcc = 3.3V, 25°C ambient. This parameter is guaranteed but not tested. Not more than one output should be shorted at one time. Duration of the test should not exceed one second. VoH = Vcc – 0.6V at rated current Capacitance (TA = 25°C f = 1 MHz) Parameters Description Test Conditions CIN Input Capacitance COFF Port I Capacitance, Switch OFF CON Switch Capacitance, Switch ON Typ. Units 3.0 VIN = 0V 5.0 pF 10.0 Dynamic Electrical Characteristics Over the Operating Range (TA = -40º to +85º, VCC = 3.3V ± 10%) Parameter Description Test Condition Typ. XTALK Crosstalk RL = 100 -60 OIRR Off-Isolation RL = 100 -60 BW -3dB Bandwidth RL = 100 1.75 Units dB GHz Switching Characteristics over 3.3V Operating Range Parameters Description tPLH tPHL Propogation Delay tPZH tPZL Bus Enable Time tPHZ tPLZ Bus Disable Time Conditions See Test Diagram Max. Units 0.3 2.0 ns See Test Diagram Potato Semiconductor Corporation 3.0 3 01/01/10 PO3B10A www.potatosemi.com 2-Channel, 2:1 Mux/DeMux Switch w/ Single Enable High Bandwidth Potato Chip Switching Characteristics over 2.5V Operating Range Parameters Description tPLH tPHL Propogation Delay tPZH tPZL Bus Enable Time tPHZ tPLZ Bus Disable Time Max. Conditions See Test Diagram Units 0.3 2.0 ns See Test Diagram 3.0 Test Circuit for Electrical Characteristics Switch Positions Test Switch tPLZ, tPZL 6.0V tPHZ, tPZH GND Prop Delay Open 6.0V VCC 200-ohm Pulse Generator VOUT VIN D.U.T 10pF CL RT 200-ohm Switching Waveforms SEL 2.5V Input Output 3.5V 2.5V tPLH tPHL 2.5V 2.5V 1.5V Output VOH VOL Voltage Waveforms Propagation Delay Times Potato Semiconductor Corporation 1.25V 1.25V tPZL VDD/2 VDD/2 0V VOH VOL +0.3V tPHZ tPZH Output tPLZ 2.5V VOH –0.3V VOL VOH VOL Voltage Waveforms Enable and Disable Times 4 01/01/10 PO3B10A www.potatosemi.com 2-Channel, 2:1 Mux/DeMux Switch w/ Single Enable High Bandwidth Potato Chip Packaging Mechanical Drawing: 12 pin DFN 6 1 7 12 1 12 2 3 11 10 4 5 6 9 8 7 IC Ordering Information Ordering Code Package PO3B10ADR for Tape & Reel 12-pin DFN Top-Marking Pb-free & Green PO3B10AD TA -40°C to 85°C IC Package Information PACKAGE CODE D PACKAGE TYPE 12-pin DFN Potato Semiconductor Corporation TAPE WIDTH (mm) TAPE PITCH (mm) 12 8 PIN 1 LOCATION TAPE TRAILER LENGTH Top Left Corner 26 (12”) 5 QTY PER REEL 3000 TAPE LEADER LENGTH 64 (20”) QTY PER TUBE N/A 01/01/10