Ku-Band 400 W SuperLinear® Outdoor TWTA Plays in the Rain Provides 200 watts of linear power at the flange in a rugged and compact weatherproof package, digital ready, for wideband, single- and multicarrier satellite service in the 13.75 to 14.50 GHz frequency band (extended and narrower bands also available). Ideal for transportable and fixed earth station applications. Cost Effective and Highly Efficient As part of the SuperLinear TWTA product line, this is the most efficient and compact amplifer in its class. Both the tube and HPA are optimized for efficient operation at linear power output levels. Reliable Designed and built to survive in extremely adverse environmental conditions and features increased cooling margin for longer life. CAN-Bus architecture improves noise immunity and reliability. Simple to Operate User-friendly microprocessor-controlled logic with integrated Ethernet computer interface. Digital metering, pin diode attenuation and optional integrated linearizer for improved intermodulation performance. SNMP serial interface included. Model TL04UO 400 watt Ku-band SuperLinear TWTA for satellite uplink applications OPTIONS •Remote Control Panel •L-Band Block Upconverter (refer to TD-191 or contact CPI for specifications) •Integral Linearizer •Extended Frequency (12.75 - 14.50 GHz) •External Receive Band Reject Filter (Increases loss by by a minimum of 60 dB up to 12.7 GHz) •Redundant Subsystems •Integrated 1:1 Switch Control and Drive Global Applications Meets International Safety Standard EN-60215, Electromagnetic Compatibility 2004/108/EC and Harmonic Standard EN-61000-3-2 to satisfy worldwide requirements. Worldwide Support Backed by over 35 years of satellite communications experience, and CPI’sworldwide 24-hour customer support network that includes more than 20 regional factory service centers. 811 Hansen Way, PO Box 51625 Palo Alto, CA 94303 USA tel: +1 (650) 846-3803 fax: +1 (650) 424-1744 e-mail:[email protected] website:www.cpii.com/satcom Ku-Band Specifications 400 W Ku-band SupearLinear® Outdoor TWTA Specification Input Frequency Output Frequency Model TL04UO 0.95 to 1.70 GHz with BUC (0.95 to 1.95 GHz with wideband option). 14.00 to 14.50 GHz or 13.75 to 14.50 GHz (12.75 to 14.50 GHz optional) Output Power (min.) TWT CW Power at Flange Max. CW Flange Power 400 watts (56.0 dBm) peak 200 W (53.0 dBm) min. 220 W (53.4 dBm) Bandwidth Gain Gain Stability Small Signal Gain Slope Small Signal Gain Variation 500 or 750 MHz (1075 MHz optional) 67 dB min. at rated power, 70 dB typ. at small signal ±0.25 dB/24 hours max. (at constant drive and temperature) ±0.02 dB/MHz max. (±0.04 dB/MHz max. with BUC option) 1.0 dB pk-pk max. across any 80 MHz band; 3.0 dB pk-pk max. across any 500 MHz RF Level Adjust Range Input VSWR 30 dB typ. 1.3:1 max. (1.5:1 max. with BUC option) Output VSWR 2.0:1 max. Load VSWR 2.0:1 max. continuous operation; any value for operation without damage Phase Noise -10 dB below IESS-308/309; -42 dBc AC fundamental; -50 dBc sum of spurs Spurious AM/PM Conversion Harmonic Output Noise Density (at max. gain) Spectral Regrowth Intermodulation Group Delay Prime Power Power Consumption -60 dBc max. at rated output 2.0˚/dB max. up to 46 dBm output power (up to 53 dBm with optional linearizer) -65 dBc at rated power (-60 dBc at rated power with optional linearizer) <-150 dBW/4 kHz, 10.00 to 12.75 GHz; <-70 dBW/4 kHz, passband to 18 GHz (<-65 dBW/4 kHz with optional linearizer) -30 dBc max. @ 1.0 S.R. at 49 dBm output power (at 53 dBm output power with optional linearizer) -25 dBc max. with two equal carriers at total output power of 80 W (at 160 W with optional linearizer); -25 dBc max. with respect to the sum of both carriers at total output power of 100 W (at 200 W with optional linearizer) 0.01 ns/MHz linear max, 0.001 ns/MHz2 parabolic max, 1.0 ns pk-pk ripple max. in any 40 MHz band 100 to 240 VAC +/-10% single phase, 47-63 Hz 1000 VA max; 750 VA typ. at 160 W output power Power Factor 0.95 min. Amplitude and Phase Linearity Ambient Temperature Exceeds MIL-STD-188-164B Ambient Temperature -40°C to +60°C operating, plus solar loading; -54°C to +71°C non-operating Relative Humidity Altitude 100% condensing 10,000 ft. with standard adiabatic derating of 2°C/1000 ft., operating; 50,000 ft, non-operating Shock 20 g peak, 11 ms, 1/2 sine Vibration 2.1 grms, 5 to 500 Hz Acoustic Noise 65 dBA at 3 feet from amplifier Cooling Forced air with integral blower M&C Port Ethernet interface Input Connection RF Output Connection Type N female WR75 waveguide flange, grooved with UNC 2B 6-32 threaded holes RF Output Monitor Dimensions Type N Female 10.5 x 8.5 x 17.0 in. max. (267 x 216 x 432 mm) Weight 32 lbs (14.6 kg) typ. Quality Management System - ISO 9001:2008 For more detailed information, please refer to the corresponding CPI technical description if one has been published, or contact CPI. Specifications may change without notice as a result of additional data or product refinement. Please contact CPI before using this information for system design. MKT 322, ISSUE 8 dated JUN 2015