RL151 THRU RL157 SILICON RECTIFIER VOLTAGE RANGE 50 to 1000 Volts CURRENT 1.5 Amperes FEATURES * * * * Low cost Low leakage Low forward voltage drop High current capability DO-15 MECHANICAL DATA * * * * * Case: Molded plastic Epoxy: Device has UL flammability classification 94V-O Lead: MIL-STD-202E method 208C guaranteed Mounting position: Any Weight: 0.38 grams .034 (0.9) 1.0 (25.4) .028 (0.7) DIA. MIN. .300 (7.6) .230 (5.8) .140 (3.6) .104 (2.6) DIA. 1.0 (25.4) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS MIN. Ratings at 25 o C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. Dimensions in inches and (millimeters) MAXIMUM RATINGS (@ TA=25 OC unless otherwise noted) SYMBOL RL151 RL152 RL153 RL154 RL155 RL156 RL157 UNITS Maximum Recurrent Peak Reverse Voltage RATINGS VRRM 50 100 200 400 600 800 1000 Volts Maximum RMS Voltage VRMS 35 70 140 280 420 560 700 Volts VDC 50 100 200 400 600 800 1000 Volts Maximum DC Blocking Voltage Maximum Average Forward Rectified Current at T A = 75 o C Peak Forward Surge Current 8.3 ms single half sine-wave superimposed on rated load (JEDEC method) Typical Thermal Resistance (Note 3) Typical Junction Capacitance (Note 2) Operating and Storage Temperature Range IO 1.5 Amps I FSM 60 Amps R q JA 50 R q JL 20 CJ 20 T J, T STG -55 to + 150 0 C/ W pF 0 C ELECTRICAL CHARACTERISTICS (@TA=25 C unless otherwise noted) O CHARACTERISTICS Maximum Instantaneous Forward Voltage at 1.5A DC Maximum DC Reverse Current at Rated DC Blocking Voltage SYMBOL RL151 VF @T A = 25 o C @T A = 100 o C RL152 RL153 RL154 1.1 RL155 RL156 RL157 UNITS Volts 5 IR Maximum Fully Load Reverse Current Average, Fully Cycle .375" (9.5mm) lead length at T L =75 OC NOTES : 1. Measured at 1 MHz and applied reverse voltage of 4.0 volts. 2. Typical Thermal Resistance : At 9.5mm lead lengths,PCB mounted. 3. "Fully ROHS complaint", "100% Sn plating (Pb-free)" 50 uAmps 30 2007-09 INSTANTANEOUS REVERSE CURRENT, (uA) RATING AND CHARACTERISTICS CURVES ( RL151 THRU RL157 ) AVERAGE FORWARD CURRENT, (A) 2.5 2.0 1.5 1.0 Single Phase Half Wave 60Hz Resistive or Inductive Load 0.5 0 0 25 50 75 100 125 150 175 1000 100 TA = 100 OC 10 TA = 75 OC TA = 25 OC 1.0 0.1 0 LEAD TEMPERATURE, ( C) PEAK FORWARD SURGE CURRENT, (A) TJ = 25 C O 3.0 1.0 0.3 0.1 0.03 0.01 Pulse Width=300uS 1% Duty Cycle 0 0.5 1.0 1.5 2.0 40 60 2.5 3.0 3.5 200 100 120 140 8.3ms Single Half Sine-Wave (JEDED Method) 100 50 30 20 10 1 5 10 100 FIG.4 MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT 200 TJ = 25 OC 100 60 40 20 10 6 4 2 0.1 0.2 50 NUMBER OF CYCLES AT 60Hz FIG.3 TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS 1 80 FIG.2 TYPICAL REVERSE CHARACTERISTICS INSTANTANEOUS FORWARD VOLTAGE, (V) JUNCTION CAPACITANCE, (pF) INSTANTANEOUS FORWARD CURRENT, (A) FIG.1 TYPICAL FORWARD CURRENT DERATING CURVE 20 10 20 PERCENT OF RATED PEAK REVERSE VOLTAGE, (%) O 0.4 1.0 2 4 10 20 40 REVERSE VOLTAGE, (V) FIG.5 TYPICAL JUNCTION CAPACITANCE 100 DISCLAIMER NOTICE Rectron Inc reserves the right to make changes without notice to any product specification herein, to make corrections, modifications, enhancements or other changes. Rectron Inc or anyone on its behalf assumes no responsibility or liability for any errors or inaccuracies. Data sheet specifications and its information contained are intended to provide a product description only. "Typical" parameters which may be included on RECTRON data sheets and/ or specifications can and do vary in different applications and actual performance may vary over time. Rectron Inc does not assume any liability arising out of the application or use of any product or circuit. Rectron products are not designed, intended or authorized for use in medical, life-saving implant or other applications intended for life-sustaining or other related applications where a failure or malfunction of component or circuitry may directly or indirectly cause injury or threaten a life without expressed written approval of Rectron Inc. Customers using or selling Rectron components for use in such applications do so at their own risk and shall agree to fully indemnify Rectron Inc and its subsidiaries harmless against all claims, damages and expenditures.