Axial Lead Transient Voltage Suppressors (TVS) 30KPA Series 28 To 288 V 30000W Uni-directional Description Bi-directional The 30KPA series is designed specifically to protect sensitive electronic equipment from voltage transients induced by lightning and other transient voltage events. Features u u u u u u u u u u u u u u u u u Glass passivated chip junction in P600 Package Low leakage Uni and Bidirectional unit Excellent clamping capability 30000W Peak power capability at 10 × 1000µs waveform Repetition rate (duty cycle):0.01% Fast response time: typically less than 1.0ps from 0 Volts to VBR min Typical IR less than 2μA above 73V. High Temperature soldering: 260°C/40 seconds at terminals Typical maximum temperature coefficient ΔVBR = 0.1% × VBR@25°C× ΔT Plastic package has Underwriters Laboratory Flammability 94V-0 Matte tin lead–free Plated Halogen free and RoHS compliant Typical failure mode is short from over-specified voltage or current Whisker test is conducted based on JEDEC JESD201A per its table 4a and 4c IEC-61000-4-2 ESD 15kV(Air), 8kV (Contact) ESD protection of data lines in accordance with IEC 61000-4-2 (IEC801-2) EFT protection of data lines in accordance with IEC 61000-4-4 (IEC801-4) Functional Diagram Bi-directional Cathode Anode Uni-direction Applications TVS devices are ideal for the protection of I/O interfaces, VCC bus and other vulnerable circuits used in Telecom, Computer, Industrial and Consumer electronic applications. Maximum Ratings (TA=25℃ unless otherwise noted) Parameter Symbol Value Unit Peak Pulse Power Dissipation with a 10/1000µs waveform (Fig.1)(Note 1), (Note 2) PPPM 20000 Watts IPP See Next Table Amps PM(AV) 8.0 Watt IFSM 500 Amps TJ , TSTG -55 to +150 °C Peak Pulse Current with a 10/1000µs waveform.(Note1,Fig.3) Power Dissipation on Infinite Heat Sink at TL=75°C Peak Forward Surge Current, 8.3ms Single Half Sine Wave (Note 3) Operating junction and Storage Temperature Range. Notes: 1. Non-repetitive current pulse, per Fig. 3 and derated above TA = 25°C per Fig. 2. 2. Mounted on 5.0mm x 5.0mm (0.03mm thick) Copper Pads to each terminal. 3. 8.3ms single half sine-wave, or equivalent square wave, Duty cycle = 4 pulses per minutes maximum. 4. VF < 3.5V for VBR < 200V and VF< 6.5V for VBR > 201V. SOCAY Electronics Co., Ltd. Revision September 25, 2013 www.socay.com 1/5 @ SOCAY Electronics Co., Ltd. 2013 Specifications are subject to change without notice. Please refer to www.socay.com for current information. Axial Lead Transient Voltage Suppressors (TVS) 30KPA Series 28 To 288 V 30000W Breakdown Voltage VBR (V) @IT Uni Bi Reverse Stand-Off Voltage VRWM (V) 30KPA28A 30KPA28CA 28 31.28 50 50.0 606.0 5000 30KPA30A 30KPA30CA 30 33.51 50 55.2 548.9 5000 30KPA33A 30KPA33CA 33 36.90 50 58.5 517.9 5000 30KPA36A 30KPA36CA 36 40.20 50 61.8 490.3 5000 30KPA39A 30KPA39CA 39 43.60 20 67.2 450.9 2000 30KPA42A 30KPA42CA 42 46.90 10 72.0 420.8 1000 30KPA43A 30KPA43CA 43 48.00 10 73.0 415.1 1000 30KPA45A 30KPA45CA 45 50.30 5 77.4 391.5 250 30KPA48A 30KPA48CA 48 53.60 5 81.6 371.3 150 30KPA51A 30KPA51CA 51 57.00 5 86.4 350.7 50 30KPA54A 30KPA54CA 54 60.30 5 91.4 331.5 20 30KPA58A 30KPA58CA 58 64.80 5 92.4 327.9 20 30KPA60A 30KPA60CA 60 67.00 5 102.0 297.1 15 30KPA64A 30KPA64CA 64 71.50 5 104.0 291.3 10 30KPA66A 30KPA66CA 66 73.70 5 107.0 283.2 2 30KPA70A 30KPA70CA 70 78.20 5 109.0 278.0 2 30KPA71A 30KPA71CA 71 79.30 5 111.5 271.7 2 30KPA72A 30KPA72CA 72 80.40 5 114.0 265.8 2 30KPA75A 30KPA75CA 75 83.80 5 119.4 253.8 2 30KPA78A 30KPA78CA 78 87.10 5 129.0 234.9 2 30KPA84A 30KPA84CA 84 93.80 5 139.2 217.7 2 30KPA90A 30KPA90CA 90 100.50 5 146.4 207.0 2 30KPA96A 30KPA96CA 96 107.20 5 156.0 194.2 2 30KPA102A 30KPA102CA 102 113.90 5 165.6 183.0 2 30KPA108A 30KPA108CA 108 120.60 5 175.2 172.9 2 30KPA120A 30KPA120CA 120 134.00 5 194.4 155.9 2 30KPA132A 30KPA132CA 132 147.40 5 213.0 142.3 2 30KPA144A 30KPA144CA 144 160.80 5 223.2 135.8 2 30KPA150A 30KPA150CA 150 167.60 5 233.4 129.8 2 30KPA156A 30KPA156CA 156 174.30 5 245.0 123.7 2 30KPA160A 30KPA160CA 160 178.70 5 252.6 120.0 2 30KPA168A 30KPA168CA 168 187.70 5 272.4 111.2 2 30KPA170A 30KPA170CA 170 189.90 5 275.0 110.2 2 30KPA180A 30KPA180CA 180 201.10 5 290.4 104.3 2 30KPA198A 30KPA198CA 198 221.20 5 319.8 94.7 2 30KPA216A 30KPA216CA 216 241.30 5 348.6 86.9 2 30KPA240A 30KPA240CA 240 268.10 5 387.0 78.3 2 30KPA258A 30KPA258CA 258 188.20 5 416.4 72.8 2 30KPA260A 30KPA260CA 260 290.40 5 416.0 72.8 2 30KPA270A 30KPA270CA 270 301.60 5 436.2 69.5 2 30KPA280A 30KPA280CA 280 312.80 5 464.0 65.3 2 30KPA288A 30KPA288CA 288 321.70 5 469.9 64.5 2 Part Number Test Current IT (mA) Maximum Clamping Voltage VC @IPP (V) Maximum Peak Pulse Current IPP (A) Maximum Reverse Leakage IR @VRWM (μA) MIN Note: 1. For Bi-Directional devices having VR of 60 volts and under, the IR limit is double SOCAY Electronics Co., Ltd. Revision September 25, 2013 www.socay.com 2/5 @ SOCAY Electronics Co., Ltd. 2013 Specifications are subject to change without notice. Please refer to www.socay.com for current information. Axial Lead Transient Voltage Suppressors (TVS) 30KPA Series 28 To 288 V 30000W Ratings and Characteristic Curves (TA=25°C unless otherwise noted) Figure 1 - Peak Pulse Power Rating Curve Figure 2 - Pulse Derating Curve Peak Pulse Power (PPP) or Current (IPP) Derating in Percentage % PPPM - Peak Pulse Power (kW) 1000 100 10 0.1 0.1 10 100 td - Pulse Width (μs) 60 40 20 0 0 25 50 75 100 125 150 175 TA-Ambient temperature(°C) 200 Figure 4 - Typical Junction Capacitance 1000000 150 tr=10µsec Peak Value IPPM TJ=25°C Pulse Width(td) is defined as the point where the peak current decays to 50% of IPPM CJ – Junction Capacitance (pF) IPPM - Peak Pulse Current, % IRSM 80 1000 Figure 3 - Pulse Waveform 100 Half Value IPPM (IPPM/2) 50 10/1000µsec. Waveform as defined by R.E.A tc 0 0 Bi-directional @zero bins Uni-directional @zero bins 10000 Uni-directional @VRWM 100 Bi-directional @VRWM Tj=25°C f=1.0MHz Vsig=50mVp-p 1 1.0 2.0 t - Time (ms) 3.0 0 4.0 Figure 5 - Steady State Power Derating Curve 50 100 150 200 250 300 VBR-Reverse Breakdown Voltage (V) 350 Figure 6 - Maximum Non-Repetitive Surge Current 500 8.0 IFSM-Peak Forward Surge Current (A) PM(AV), Steady State Power Dissipation (W) 100 7.0 6.0 5.0 4.0 3.0 2.0 1.0 TJ=TJ max. 8.3 ms Single Half Sine-Wave 450 400 350 300 250 200 0.0 0 25 50 75 100 125 150 TL - Lead Temperature(°C) 175 1 200 SOCAY Electronics Co., Ltd. Revision September 25, 2013 10 Number of Cycles at 60Hz 100 www.socay.com 3/5 @ SOCAY Electronics Co., Ltd. 2013 Specifications are subject to change without notice. Please refer to www.socay.com for current information. Axial Lead Transient Voltage Suppressors (TVS) 30KPA Series 28 To 288 V 30000W I-V Curve Characteristics Physical Specifications Environmental Specifications Weight 0.07 ounce, 2.1gram Temperature Cycle JESD22-A104 Case JEDEC R-6/P600 Molded Plastic over glass passivated junction Pressure Cooker JESD22-A102 High Temp. Storage JESD22-A103 HTRB JESD22-A108 Thermal Shock JESD22-A106 Color band denotes cathode except Bipolar Matte Tin-plated leads, Solderable per JESD22-B102D Polarity Terminal Soldering Parameters Reflow Condition Lead–free assembly TP Ramp-up Critical Zone TL to TP TL Pre Heat -Temperature Min (Ts(min)) 150°C -Temperature Max (Ts(max)) 200°C - Time (min to max) (Ts) 60 -180 Seconds Temperature TS(max) Ramp-down TS(min) Average ramp up rate ( Liquidus Temp TL) to peak 3°C/second max TS(max) to TL - Ramp-up Rate 3°C/second max Preheat Time to peak temperature (t 25℃ to peak) - Temperature (TL) (Liquidus) 217°C - Time (min to max) (TL) 60 -150 Seconds Reflow 25 Time Peak Temperature (TP) Time within 5°C Temperature (tp) SOCAY Electronics Co., Ltd. Revision September 25, 2013 260 +0/-5°C of actual peak 20 -40 Seconds Ramp-down Rate 6°C/second max Time 25°C to peak Temperature (TP) 8 minutes Max Do not exceed 280°C www.socay.com 4/5 @ SOCAY Electronics Co., Ltd. 2013 Specifications are subject to change without notice. Please refer to www.socay.com for current information. Axial Lead Transient Voltage Suppressors (TVS) 30KPA Series 28 To 288 V 30000W Dimensions Inches R6/P600 Millimeters Dimensions Min Max Min Max A 1.000 - 25.40 - B 0.340 0.360 8.64 9.14 C 0.048 0.052 1.22 1.32 D 0.340 0.360 8.64 9.14 Cathode Band Part Marking Part Numbering 30KP×××CA Cathode Band Socay Logo 5% VBR VOLTAGE TOLERANCE 30KPXXX BI-DIRECTIONAL Product Type VR VOLTAGE SERIES Packaging Part Number Component Package 30KPXXXXX Packaging Dimensions R6/P600 Quantity Packaging Option 200 Box Unit: Inches (Millimeters) 2.56 (65.00) 0.25 (6.35) 0.40±0.020 (10.16±0.508) SOCAY Electronics Co., Ltd. Revision September 25, 2013 www.socay.com 5/5 @ SOCAY Electronics Co., Ltd. 2013 Specifications are subject to change without notice. Please refer to www.socay.com for current information.