MASWCC0006
GaAs SP6T Switch, Absorptive, Single Supply
DC - 4.0 GHz
Features
Operates DC - 4 GHz on Single Supply
ASIC TTL / CMOS Driver
Leadless 4 x 7 mm Chip Scale Plastic Package
Low DC Power Consumption
50 Ohm Nominal Impedance
Test Boards are Available
Tape and Reel are Available
Lead-Free CSP-2 Package
100% Matte Tin Plating over Copper
Halogen-Free “Green” Mold Compound
260°C Reflow Compatible
RoHS* Compliant Version of SW90-0004A
Rev. V4
Pin Configuration1,2,3,4
Pin No.
Function
Pin No.
Function
1
CP2
19
GND
2
VEE
20
NC
3
NC
21
GND
4
C6
22
RFC
5
C5
23
GND
6
C4
24
GND
7
C3
25
RF4
8
C2
26
GND
9
C1
27
RF5
10
NC
28
GND
11
GND
29
RF6
12
NC
30
GND
13
GND
31
NC
14
RF1
32
VEE
15
GND
33
Vcc
16
RF2
34
NC
17
GND
35
Vcc
18
RF3
36
CP1
Description
M/A-COM's MASWCC0006 is a SP6T absorptive
pHEMT switch with integral TTL driver. This device
is in an MLP plastic surface mount package. This
switch offers excellent broadband performance and
repeatability from DC to 4 GHz, while maintaining
low DC power dissipation. The MASWCC0006 is
ideally suited for wireless infrastructure applications.
1.
2.
Ordering Information
Part Number
Package
MASWCC0006
Bulk Packaging
MASWCC0006TR
1000 piece reel
MASWCC0006-TB
Sample Test Board
3.
4.
NC = No Connection
For single supply operation VEE is internally generated
and must remain isolated from external power supplies.
Generated noise is typical of switching DC-DC Converters.
Connections and external components shown in functional
schematic are required. 0.1µF Capacitors need to be located near pins 32 & 33.
The exposed pad centered on the package bottom must be
connected to RF and DC ground. (For MLF Packages)
Note: Reference Application Note M513 for reel size
information.
* Restrictions on Hazardous Substances, European Union Directive 2002/95/EC.
1
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
https://www.macom.com/support
MASWCC0006
GaAs SP6T Switch, Absorptive, Single Supply
DC - 4.0 GHz
Rev. V4
Electrical Specifications: TA = 25°C
Parameter
Test Conditions
Frequency
Units
Min.
Typ.
Max.
Insertion Loss
RFC-RF1, 2, 3, 4, 5, 6
DC - 3.0 GHz
3.0 - 4.0 GHz
dB
dB
—
—
—
—
2.1
2.4
Isolation
—
DC - 4.0 GHz
dB
25
—
—
VSWR
On (RFC, RF1-RF6)
Logic per Truth Table
Off (RF1-RF6)
Logic per Truth Table
DC - 4.0 GHz
Ratio
—
—
2.0:1
DC - 4.0 GHz
Ratio
—
—
2.0:1
1 dB Compression
—
—
50 MHz
0.5 - 4.0 GHz
dBm
dBm
—
—
15
27
—
—
Input IP3
Two-tone inputs up to +5 dBm
50 MHz
0.5-4.0 GHz
dBm
dBm
—
—
30
40
—
—
Switching Speed
Ton (50% Control to 90% RF)
—
ns
—
20
—
Toff (50% Control to 10% RF)
—
ns
—
15
—
Trise (10% to 90% RF)
—
ns
—
5
—
Tfall (90% to 10% RF)
—
ns
—
2
—
Vcc
—
—
V
4.5
5.0
5.5
VIL
VIH
LOW-level input voltage
HIGH-level input voltage
—
—
V
V
0.0
2.0
—
—
0.8
5.0
lin (Input Leakage Current)
Vin = VCC or GND
—
uA
-1.0
—
1.0
Icc
5,7
Vcc min to max, Logic “0” or “1”
—
mA
—
5
8
Icc8
(Quiescent Supply Current)
Vcntrl = VCC or GND
—
uA
—
250
400
Turn-on Current6
For guaranteed start-up
—
mA
—
—
125
ΔIcc
(Additional Supply Current
Per TTL Input Pin)
VCC = Max, Vcntrl = VCC - 2.1 V
—
mA
—
—
1.0
Switching Noise
Generated from
DC-DC Converter with
recommended capacitors
3.5 MHz
dBm
—
-93
—
Thermal Resistance θjc
—
—
°C/W
—
15
—
5.
6.
7.
8.
During turn-on, the device requires an initial start up current (Icc) specified as “Turn-on Current”. Once operational, Icc will drop to the specified levels. This is not applicable to dual supply operation.
The DC-DC converter is guaranteed to start in 100 µs as long as the power supplies have the maximum turn-on current available for startup.
For single supply operation
For dual supply operation
Truth Table (Switch)
C1
2
1
0
0
0
0
0
Control Inputs
"0" is TTL Low, "1" is TTL High
C2
C3
C4
C5
0
1
0
0
0
0
0
0
1
0
0
0
0
0
0
1
0
0
0
0
0
0
1
0
C6
RF1
0
0
0
0
0
1
On
Off
Off
Off
Off
Off
Condition of Switch
RF Common to Each RF Port
RF2
RF3
RF4
RF5
Off
On
Off
Off
Off
Off
Off
Off
On
Off
Off
Off
Off
Off
Off
On
Off
Off
Off
Off
Off
Off
On
Off
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
https://www.macom.com/support
RF6
Off
Off
Off
Off
Off
On
MASWCC0006
GaAs SP6T Switch, Absorptive, Single Supply
DC - 4.0 GHz
Absolute Maximum Ratings 9,10
Parameter
Recommended PCB Configuration
Absolute Maximum
Max. Input Power
0.05 GHz
0.5 - 4.0 GHz11
+27 dBm
+34 dBm
VCC7
-0.5V ≤ VCC ≤ +6.0V
VCC8
-0.5V ≤ VCC ≤ +7.0V
VEE8
VCC - VEE
Rev. V4
-8.5V ≤ VEE ≤ +0.5V
8
-0.5V ≤ VCC - VEE ≤ 14.5V
12
Vin
-0.5V ≤ Vin ≤ VCC + 0.5V
Operating Temperature
-40ºC to +85ºC
Storage Temperature
-65ºC to +125ºC
9.
Exceeding any one or combination of these limits may cause
permanent damage to this device.
10. M/A-COM does not recommend sustained operation near
these survivability limits.
11. When the RF input is applied to the terminated port, the
absolute maximum power is +30 dBm.
12. Standard CMOS TTL interface, latch-up will occur if logic
signal is applied prior to power supply.
Typical Performance Curves
Insertion Loss vs. Frequency
- 4 0 °C
Please observe the following precautions to avoid
damage:
2.5
Static Sensitivity
Gallium Arsenide Integrated Circuits are sensitive
to electrostatic discharge (ESD) and can be
damaged by static electricity. Proper ESD control
techniques should be used when handling these
devices.
Isolation (dB) vs. Frequency
Insertion Loss (dB)
Handling Procedures
3.0
+ 2 5 °C
2.0
1.5
1.0
0.5
0.0
0
1000
2000
Frequency (MHz)
3000
4000
On VSWR vs. Frequency
R F OU T
R F n- R F m, R F C - R F n
90
2.00
75
1.80
60
VSWR
Isolation (dB)
+ 8 5 °C
45
RFC
1.60
1.40
30
1.20
15
1.00
0
0
0
3
1000
2000
Frequency (MHz)
3000
4000
1000
2000
3000
Frequency (MHz)
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
https://www.macom.com/support
4000
MASWCC0006
GaAs SP6T Switch, Absorptive, Single Supply
DC - 4.0 GHz
Rev. V4
Typical Performance Curves
IP3 Results 11
VSWR (Terminations) vs. Frequency
R F OU T
45
IP3 (dBm)
2.00
VSWR
1.80
1.60
1.40
40
35
30
25
20
15
1.20
0
1.00
0
1000
2000
Frequency (MHz)
3000
4000
500
1000
1500
2000
Frequency
11. All testing done with the second tone 5 MHz above the
frequency on the plot, except for the 10 MHz point, where
the second tone is at 11 MHz. Both tones are +5 dBm.
Functional Schematic
4
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
https://www.macom.com/support
MASWCC0006
GaAs SP6T Switch, Absorptive, Single Supply
DC - 4.0 GHz
Rev. V4
CSP-2, Lead-Free 4 x 7 mm, 36-lead
PQFN†
†
Reference Application Note M538 for lead-free solder reflow
recommendations.
5
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
https://www.macom.com/support
MASWCC0006
GaAs SP6T Switch, Absorptive, Single Supply
DC - 4.0 GHz
Rev. V4
M/A-COM Technology Solutions Inc. All rights reserved.
Information in this document is provided in connection with M/A-COM Technology Solutions Inc ("MACOM")
products. These materials are provided by MACOM as a service to its customers and may be used for
informational purposes only. Except as provided in MACOM's Terms and Conditions of Sale for such products or
in any separate agreement related to this document, MACOM assumes no liability whatsoever. MACOM
assumes no responsibility for errors or omissions in these materials. MACOM may make changes to
specifications and product descriptions at any time, without notice. MACOM makes no commitment to update
the information and shall have no responsibility whatsoever for conflicts or incompatibilities arising from future
changes to its specifications and product descriptions. No license, express or implied, by estoppels or otherwise,
to any intellectual property rights is granted by this document.
THESE MATERIALS ARE PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR
IMPLIED, RELATING TO SALE AND/OR USE OF MACOM PRODUCTS INCLUDING LIABILITY OR
WARRANTIES RELATING TO FITNESS FOR A PARTICULAR PURPOSE, CONSEQUENTIAL OR
INCIDENTAL DAMAGES, MERCHANTABILITY, OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR
OTHER INTELLECTUAL PROPERTY RIGHT. MACOM FURTHER DOES NOT WARRANT THE ACCURACY
OR COMPLETENESS OF THE INFORMATION, TEXT, GRAPHICS OR OTHER ITEMS CONTAINED WITHIN
THESE MATERIALS. MACOM SHALL NOT BE LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES, INCLUDING WITHOUT LIMITATION, LOST REVENUES OR LOST PROFITS,
WHICH MAY RESULT FROM THE USE OF THESE MATERIALS.
MACOM products are not intended for use in medical, lifesaving or life sustaining applications. MACOM
customers using or selling MACOM products for use in such applications do so at their own risk and agree to
fully indemnify MACOM for any damages resulting from such improper use or sale.
6
M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice.
Visit www.macom.com for additional data sheets and product information.
For further information and support please visit:
https://www.macom.com/support