5 Port Industrial Ethernet Managed Switch

ET-5MS Legacy Product Datasheet
sales@sixnet.com www.sixnet.com
5 Port Industrial Ethernet Managed Switch
Ultra-Reliability Enhanced with Open-source Capabilities
Real-time Secure Performance
„
„
„
„
„
„
„
„
„
„
„
5 Ports with up to 2 Fiber
Rapid Spanning Tree (RSTP) for fast redundant rings
SNMPv1 and v2 network management
SNMPv3 authentication & encryption for security
SNMP notifications (traps) for report on event
Priority Queuing (QoS/CoS) for real-time operation
IGMP for Multicast filtering (snooping & querying)
VLAN for convenient traffic segregation
Open-source programming for ultimate flexibility
Broadcast & multicast storm protection
RMON & port mirroring for advanced diagnostics
Security with HTTPS, SSL, SSH, SNMPv3 & more
Trouble Free Operation
„
„
„
„
„
„
„
„
Over 1,000,000 hours Mean Time Between Failures
Free field-installable upgrades forever
-40 to +75 °C operation – no fans or moving parts!
UL, CSA (CUL), and CE certified
Marine, offshore and hazardous locations rated
Enhanced surge and spike protection
Dual (redundant) power inputs
Self-test/alarm output contact
The Power of
Linux IPm
Inside
Ensure the reliability of your network with fast
automatic switchover on a segment failure.
Performance Specifications
General
Ethernet switch type
Ethernet protocols supported
RJ45 ports (shielded)
RJ45 speed (10 or 100 Mbps)
RJ45 MDI/MDIX
RJ45 TD and RD polarity
Fiber optic port speed
Fiber optic port wavelength
Fiber multimode (mm) optimal
Fiber singlemode (sm) optimal
Fiber max. distance (full duplex)
(see web for details)
Typical latency for 10 Mbps ports
Typ. latency for 100 Mbps ports
Full or half duplex operation
MAC addresses supported
Memory bandwidth
“OK” Output
Voltage
Maximum current output
Environmental
Power input
Input power (all ports active)
5 Ethernet ports
Managed
All IEEE 802.3
10/100BaseTX
Auto-negotiation
Auto-crossover
Auto-polarity
100BaseFX (100 Mbps)
1300 nm center
62.5/125 um (SC or ST connector)
9/125 um (SC or ST connector)
4 km (mm), 20 or 40 km (sm) or
more (contact SIXNET)
16 us + frame time
Varies on load
& settings
5 us + frame time
Configurable
2048
3.2 Gbps
Power & operational status
Same as switch input voltage
0.5 Amp
DIN rail or direct panel mounting
Redundant input terminals
3.0 W (model -1 without fiber)
4.0 W (model -2/3 with 1 fiber)
5.0 W (model -4/5 with 2 fiber)
Input voltage (all models)
10-30 VDC (continuous)
Transient protection
15,000 watts peak
Spike protection
5,000 watts (10 times for 10 uS)
Ethernet isolation
1500 VRMS 1 minute
Operating temperature range
-40 to +75 °C
Storage temperature range
-40 to +85 °C
Humidity (non-condensing)
5 to 95% RH
Vibration
IEC68-2-6
Electrical safety
UL508/CSA C22, EN61010-1
EMI emissions
FCC part 15, ICES-003, EN55022
IEC61326-1
EMC immunity
Hazardous locations
UL1604, CSA C22.2/213 (Class 1,
Div. 2), Cenelec EN50021 (Zone 2)
Marine and off-shore
Rated per ABS
Eye safety (fiber models)
IEC60825-1, Class 1; FDA 21 CFR
1040.10 and 1040.11
Packaging (Lexan & alum. case)
IP30 protection
Dimensions (L x W x H)
See following page
Specifications are subject to change. Consult factory for latest information.
Hardware Highlights:
„ 5 port industrial Ethernet managed switch with up to two
fiber optic ports (multimode or singlemode)
„ Output for reporting power and operational status
„ Redundant power inputs and enhanced surge/spike
protection
„ Industrial rated for -40 to +75 °C operation (no fans!)
„ UL/CSA, CE and Zone 2 rated for hazardous locations
„ Rated for marine and off-shore use
„ DIN rail or direct panel mounting (no extra kits required)
Networking Features:
„
„
„
„
„
„
„
„
„
„
„
„
„
„
Auto-detecting, auto-crossover and auto-polarity
Store and forward wire speed switching
Support for up to 2048 MAC addresses
Full-Duplex operation with flow control (no collisions!)
Rapid Spanning Tree (RSTP) for fault-tolerant loops
Priority queuing for real-time performance
SNMP v1 and V2 for network management
SNMP v3 for authentication and encryption
SNMP notifications (traps) for report on event
IGMP v1 & v2 for IP multicast filtering
VLAN (port & tag based) for traffic segregation
Message filtering to stop broadcast/multicast storms
RMON and port mirroring for diagnostics
Configuration via secure (https) Web interface, Telnet /
SSH (network), terminal (RS232) or SNMP (v1, v2, v3)
Ethernet Compliance:
„
„
„
„
IEEE 802.3 (10Mbps Ethernet supports legacy devices)
IEEE 802.3u (Fast Ethernet 100Mbps for newer devices)
IEEE 802.3x (Full-Duplex with Flow Control)
IEEE 802.1D/w (Rapid Spanning Tree for redundant
rings and Spanning Tree for interoperability)
„ IEEE 802.1p (Priority Queuing – QoS, CoS, ToS/DS)
„ IEEE 802.1Q (VLAN for traffic segregation)
Additional features are in the works and are
provided through FREE Firmware Upgrades.
Contact SIXNET for the latest information.
Ordering Guide
ET-5MS-2SC
SC style fiber connector(s)
ST style fiber connector(s)
SxL for long haul fiber (40 km)
1 (5 RJ45 ports & no fiber)
2 (4 RJ45 & 1 multimode fiber)
3 (4 RJ45 & 1 singlemode fiber)
4 (3 RJ45 & 2 multimode fiber)
5 (3 RJ45 & 2 singlemode fiber)
Accessories:
ET-PS-024-02
SP-ETH-2
RJ45-DB9F-CBL
331 Ushers Road y Ballston Lake, NY 12019 USA y sales@sixnet.com
Phone: +1 (518) 877-5173 y Fax: +1 (518) 877-8346 y www.sixnet.com
Power supply - AC to 24VDC, 2A
2 port Ethernet surge protector
PC to Managed Switch serial cable
ET-5MS Mechanical Dimensions
ST Fiber
0.40"
[1.02 cm]
(max. for
ST Fiber)
5, 4 or 3
Copper Ports
(RJ45)
SC Fiber
0.275"
[0.70 cm]
0, 1 or 2
Fiber Ports
(SC or ST)
3.17"
[8.05 cm]
2.935"
[7.45 cm]
DIN EN
50022
(not
included)
Front View
0.235"
[0.60 cm]
1.60"
[4.07 cm]
Power & Alarm
ET-5MS
0.17"
[0.43]
(clear for
#8 screw)
4.475" [11.37 cm]
4.75" [12.07 cm]
0.35" [0.90 cm]
1.95"
[4.95 cm]
1.38" [3.5 cm]
DIN EN50022
(not included with units;
not shown to scale;
for reference only)
Side View
0.30"
[0.76 cm]
1.06" [2.7 cm]
0.10" [0.25 cm]
ET-5MS Power and Alarm Connections
Redundant DC Power
Single DC Power
P1 P2
P1 P2
OK
+
-
To
Panel
+ VDC Supply
Alarm
Output
Load
To
Panel
OK
+ + VDC Supplies
331 Ushers Road y Ballston Lake, NY 12019 USA y sales@sixnet.com
Phone: +1 (518) 877-5173 y Fax: +1 (518) 877-8346 y www.sixnet.com
+
-
Alarm
Output
Load