Sl~
Siovenski institut za
kakovost in meroslovje
Siovenian Institute of
Quality and Metrology
NlIlI/ber
SI-SIQ BG 007/014
----------------~----~----~-------------- - - - -
Prot/llct (IlUl type(s) / lI/ot/el(s)
Switch Mode Power Supply for building-in
Model: TSPxxx-124-3PACxxx or LOCO 024.xxx.3xx
Tmde 11/ flrk
TRACOPOWER or Convertec Power Electronics
,-/ppliCflllt/ Licellsee
Convertec Ltd., Whitemill Industrial Estate, Whitemill Road, Wexford 1 Irleand
ilfill/Ilfild II rer
Convertec Ltd., Whitemill Industrial Estate, Whitemill Road, Wexford 1 Irleand
Re/erellce to tIll' Ellropeflll stfllldflf'{ls
EN 60950-1:2006 + Am 1:2010 + Am 11:2009 + Am 12:2011
EN 61558-2-16:2009, EN50178:1997, EN 60204-1:2006 + Al:2009
Test Report - No. mul date ofisslle
T221-0022/11,2011-09-26
This licence is based on the licence agreement No. SIQ BG 007 and general service contract with SIQ valid at the date ofthis
certificate. The SIQ Type Approved certification mark of conformity may be applied to the product(s) as specified in this document
for the duration ofthe SIQ licence agreement based on regular surveillance of product and production processes.
Only the integral publication of this licence (together with the Annex) is allowed.
Certificatiollll/(Irk ofcOllforll/ity
SIQ hereby grants the right to use the SIQ Type Approved certification mark on the products specified in the Annex to this
document. Compliance with requirements of standard(s) cited give a presumption of conformity with the essential
requirements of the Low Voltage Directive 2006/951EC.
Sli:~
Type Approved
Bauart Gepruft
L;lIbf;mUl,2011-09-26
AlItlt orized sigll(l{lIl'e
Alja Pregl
Slovenian Institute of Quality and Metrology, TrZaSka cesta 2, SI-1000 Ljubljana, Slovenia
tel.: +386 1 4778 lOO, fax: +3861 4778444, e-mail: [email protected]
Sl~
SI-SIQ BG 007/014
I (2)
St. INa.
Stranl Page
ANNEX to the Licence for the use of SIQ Type Approved certification mark
No. SI-SIQ BG 007/014
1. Specification of the certified product
product:
Switch Mode Power Supply for building-in
trade mark:
TRACOPOWER or Convertec Power Electronics.
Model:
TRACOPOWER
Model reference
Convertec Power
Electronics
Manufacturers
Model reference
Model reference
TSP 240-124-3PAC400
LOCO 024.1 00.3P
240PRL194A
TSP 240-124-3PAC500
LOCO 024.1 00.3PU
240PRL194B
TSP 480-124-3PAC400
LOCO 024.200.3P
480PRL194A
TSP 480-124-3PAC500
LOCO 024.200.3PU
480PRL194B
TSP 960-124-3PAC400
LOCO 024.400.3P
960PRL194A
TSP 960-124-3PAC500
LOCO 024.400.3PU
960PRL194B
2. Technical data
Model
Output
Input
Voltage
[AC]
Current
[A]
Frequency
[Hz]
Voltage
[DC]
Current
[A]
TSP 240-124-3PAC400
3 x 400 V
0,50
50160
24
10,0
TSP 240-124-3PAC500
3 x 500 V
0,40
50160
24
10,0
TSP 480-124-3PAC400
3 x 400 V
0,96
50160
24
20,0
TSP 480-124-3PAC500
3 x 500 V
0,75
50160
24
20,0
TSP 960-124-3PAC400
3 x 400 V
1,90
50160
24
40,0
TSP 960-124-3PAC500
3 x 500 V
1,50
50160
24
40,0
IN-100-llzdCljo IsslIe: 01 01 06 ]009
Sl~
SI-SIQ SG 007/014
St. / No.
2 (2)
Stran/ Page
3. Information regarding test results and product documentation
test report:
T221-0022/11, dated 2011-09-26
product documentation:
C20110986
4. Factory locations
The products are manufactured by Convertec Limited, Wexford, Ireland or it's subcontractors as
disclosed in document »Factory locations SI-SIQ BG 007/014«.
5. Limitation/Comments:
/
6. List of components
The list of critical components fonns part of the test report listed above.
7. Conclusion
A representative test sample(s) of the above listed modeles) has passed the tests in full compliance
in accordance to the standards EN 60950-1:2006 + Am 1:2010 + Am 11:2009 + Am 12:2011 and
lEe 60950-1 :2005 (2nd edition) as verified in the test report. The examination proved that all
safety requirements were met. In addition unit was verified for compliance of basic requirements,
applicable for built in power supplies, according to the following standards:
EN 61558-2-16:2009, EN50178:1997 and EN 60204-1:2006 + Al :2009.
l/:').
J-A
\6\..\tJV~
Tested by:
Klaus YOlk
Checked by:
Bostjan Glavic
TN4004 /zdaja//sslle: 01_01_06j009
j