Element Technical datasheet 30W

Element LED Power Supply
Product Data Sheet
Element LD 30W
Constant Current LED Power Supply
700mA
Element LED Power Supply with high efficiency
and reliability in small compact housing fits in light
fixtures for office and shop lighting.
Benefits
High compatibility with COBs and discrete LEDs;
High efficiency and reliability
Simple to use with easy installation and LED
connection
Applications
Spotlight;
Downlight;
Other Indoor LED luminaries
Approval marks
(Under preparation if not shown on label)
Product Features
•
Output currents :700mA
•
Ambient temp range,ta: -10°C to +50°C
•
Output voltage : 21VDC – 42VDC
•
Max. case temperature at tc point : 75°C
•
Output power : 15W - 30W
•
SELV (< 60V)
•
Input voltage : 220 – 240 VAC
•
Suitable for class I and II luminaires
•
Typ. Efficiency : ≥ 90%
•
Fixed Output (i.e. no dimming)
•
30’000 h lifetime at tc = 75°C
1
Edition: June. 2015
Ver.: 2.0
Status: Released
Misprints and technical changes excepted
Element LED Power Supply
Element LD 30W
Product Data Sheet
Electrical Specifications
ENVIRONMENT
Cable
clamp
DIMMING
OUTPUT
INPUT
Item
Value
Unit
Nominal voltage
220 – 240
VAC
Nominal frequency
50 - 60
Hz
AC voltage range
198 – 264
VAC
DC voltage range
NA
V
Maximum voltage
275
V
Nominal current
160
mA
Total Harmonic Distortion (THD)
< 20
%
Power factor
0.98
Efficiency
> 90
%
No-load power
< 1.5
W
Stand-by power
NA
W
Power loss
4.4
W
Protection class
I/II
Inrush current
<16
A
Max. units per circuit breaker
B16: 40; B10: 25
Leakage current
< 0.7
mA
Nominal voltage range
21 – 42
VDC
Maximum voltage
60
VDC
Nominal current range
700
mA
Current accuracy
±10 %
Current ripple (typical)
± 40%
Nominal power range
15 – 30
W
Maximum power
30
W
Galvanic isolation
SELV
Dimming control
No
Dimming range
NA
%
Dimming technique
NA
Frequency
NA
Hz
Galvanic isolation
NA
Tested cable types: according to IEC60598
Input side
H03VV-F 2x0.75
H03VV-H2F 2x0.75
Output side
H03VV-F 2x0.75
H03VV-H2F 2x0.75
Ambient temperature range ta
-10 …+50
°C
Maximum case temperature tc
75
°C
Max. case temp. in fault condition
Storage temperature range
Relative humidity
Surge transient protection
Environmental rating
IP rating
Mains switching cycles
Expected lifetime
110
-10 …+75
5 ... 85
1|2
Indoor
IP 20
> 100’000
30’000
Remarks
Permitted voltage range
2hrs
230V, Refer to Table 1 for details
Full load, 230 V, 50 Hz / see graphs
Full load, 230 V, 50 Hz / see graphs
Full load, 230 V, 50 Hz, typical / see graphs
230V, typical
at 230V, Input power 34.5 W max. Refer to Table 1 for details
Suitable for class I and class II luminaires
twidth = 50 µs typical (measured at 50% Ipeak)
Output floating
Refer to Table 1 for details
Open circuit
Ripple / average @ 100 Hz
Partial Load. Refer to Table 1 for details
Ta ≤ 50°C, Refer to Table 1 for details
3,75 kVrms . Output to mains - Touch current < 0.7 mA
Not dimmable
Cable type
Cable type
Refer to Table 1 for details
Measured on t c point indicated of the product label. Refer to Table 1
for details
°C
°C
%
kV
Cool down bef ore operating
Not condensing
L/N | LN/PE acc. IEC 61000-3-2 (ANSI C62.41 Cat.A …)
hrs
tcmax = 75°C, 10% failure rate
Protections
Over temperature
Automatic, auto reversible
Overload
Automatic, auto reversible
No load
Yes
Short-circuit
Automatic, auto reversible
Input overvoltage
Maximum allowed input voltage 275V AC
Output overvoltage
Yes, Limitation of Output voltage < 60V
Output under voltage
NA
LED load protection
NA
Wiring Diagram
Terminal:
Max. cable length - system:
Geometry (l x b x h):
Weight:
Push in terminals
2m
103 x 67 x 29.5 mm
150 g
Hot plug-in or secondary switching of LEDs is not permitted and may cause a very high current to the LEDs.
Edition: June. 2015
Ver.: 2.0
Status: Released
Misprints and technical changes excepted
2
Element LED Power Supply
Element LD 30W
Product Data Sheet
Typical Operating window
Typical Efficiency over load
Typical Power factor over load
Typical THD over load
L x W x H: 103 x 67 x 29.5 mm
3
Edition: June. 2015
Ver.: 2.0
Status: Released
Misprints and technical changes excepted
Element LED Power Supply
Element LD 30W
Product Data Sheet
Table 1 - Rated output power and current sets
Iout (mA)
700
U min [V]
21
U max [V]
42
P min [W]
15
P max [W]
30
Ta [°C ]
50
Tc [°C ]
75
Line Current, nominal@230V mA
160
4.5
Max Power Loss@230V [W]
34.5
Input Power @230V [W]
Table 2 - Expected lifetime
Ta= 50°C , Tc [°C ] , All Iout
75°C
Lifetime
30’000h
Standards
Safety: IEC 61347-1, IEC 61347-2-13
Performance: IEC 62384
Harmonic content: IEC 61000-3-2
Radio interference: CISPR 15
Immunity: IEC 61000-3-3
IEC 61547
Product name
EAN10
EAN40
Element LD 30W
4052899947108
4052899947177
Manufacturer’s address:
Technical support:
OSRAM GmbH
Kunden Service Center Germany
+49 (0)89-6213-60 00
Pieces / box
20
Steinerne Furt 62 D-86167 Augsburg
Germany
www.osram.com
4
Edition: June. 2015
Ver.: 2.0
Status: Released
Misprints and technical changes excepted