Introduction bus ic dc/dc converter motor driver ic ripple counter driver ic I/O ic Sensor interface ic sensor ic ip’s E 909.01 HALIOS® optical switch E 910.41 Hall sensor- and contact monitor E 910.84 PIR light controller E 910.92 PIR motion detector E 910.98 Hall sensor interface 4 *, par. out ÿ E910.99 PIR light controller for DC/AC E 909.05 HALIOS® multi-purpose sensor ÿ PIR light controller for DC/AC applications features description ÿ Fully integrated PIR motion detector The integrated circuit E910.99 combines all required functions for ÿ Dimmer function a single chip Passive Infra Red (PIR) light controller. It is designed ÿ Open drain high voltage relay output for load switching with a transistor or a relay in 3 wire AC and DC ÿ PWM output systems. ÿ Suitable for DC and AC applications ÿ Adjustable soft on/off switching (fading) A conventional PIR sensor connects directly to the PIR input. The ÿ Digital signal processing pull-down resistor and DC decoupling circuitry are integrated on ÿ Temperature compensation input chip. The PIR signal is converted to a 15 bit digital value. All signal ÿ On chip supply regulator with wide operating processing is performed digitally. voltage range ÿ Low power consumption External potentiometers or resistors are used to set the operat- ÿ SO20w package ing parameters for sensitivity, on-time, brightness, fade, daylight sensor and environment temperature correction. The cor- E910.99 pinning package Pin Name Description 1 BRIGHT Brightness adjustment 2 FADE Fade time adjustment 3 SENS Sensitivity threshold adjustment 4 ON-TIME Light on-time adjustment 5 TCOMP Temperature compensation input 6 DARK Dark mode input, connected to LDR/Photodiode 7 SWIN ON-AUTO-OFF selct input 8 LMODE LED mode select 9 VB Supply voltage input 10 VDDA Analog supply 11 TEST Reserved test mode, has to be connected to VSS 12 TOG SO20 Reserved test mode (TOG), has to be connected to VSS application responding voltage levels are converted to digital values with a ÿ Automatic bedroom night lights 4 bit resolution. 13 RETRIG ÿ High end lighting switches 14 PIRIN PIR sensor input ÿ Outdoor and indoor motion sensor lights The features and the minimum amount of external components 15 VSSA Analog ground ÿ Battery operated lights makes the E910.99 most suitable for all PIR sensor light applica- 16 VSS Digital ground ÿ Solar powered garden lights tions. 17 RELAY Relay output ÿ Energy saving 18 PWM Light output (PWM) 19 VDD Digital VDD 20 VSW Voltage sense input Retrigger mode select input Block diagram Note ELMOS Semiconductor AG (below ELMOS) reserves the right to make changes to the product contained in this publication without notice. ELMOS assumes no responsibility for the use of any circuits described herein, conveys no licence under any patent or other right, and makes no representation that the circuits are free of patent infringement. While the information in this publication has been checked, no responsibility, however, is assumed for inaccuracies. ELMOS does not recommend the use of any of its products in life support applications where the failure or malfunction of the product can reasonably be expected to cause failure of a life-support system or to significantly affect its safety or effectiveness. Products are not authorized for use in such applications. 108 Copyright © 2007 ELMOS Reproduction, in part or whole, without the prior written consent of ELMOS, is prohibited. www.elmos.de | [email protected] elmos product catalog 2007/2008 109