DR100 1 0 0 W S i n g l e O u t put LED Driver with PFC series Constant Voltage and Current Output Universal AC Input of 100~305VAC Built-in Active PFC function Protections: Short Circuit/Over Voltage/Over Load/Over Temperature Cooling by Free Air Convection 3 in 1 Dimming Function (optional) Adjustable Output Voltage and Current (optional) Suitable for LED Lighting and LED Electronic Display Applications IP66 ~ IP67 Design for Indoor or Outdoor Installations Suitable for Dry / Damp / Wet Locations 5 Year Warranty IP67 Model Number Output Voltage Rated Output Amps Efficiency Constant Current Range (Note 3) DR100-286S035 DR100-143S070 DR100-096S105 DR100-072S140 DR100-054S180 DR100-048S200 DR100-042S230 DR100-036S265 DR100-030S300 DR100-027S357 DR100-024S400 DR100-012S833 286Volts(DC) 143Volts(DC) 96Volts(DC) 72Volts(DC) 54Volts(DC) 48Volts(DC) 42Volts(DC) 36Volts(DC) 30Volts(DC) 27Volts(DC) 24Volts(DC) 12Volts(DC) WWW.ASTRODYNE.COM 0.350 Amps 0.700 Amps 1.05 Amps 1.4 Amps 1.8 Amps 2.0 Amps 2.3 Amps 2.65 Amps 3.0 Amps 3.57 Amps 4.0 Amps 8.33 Amps 92% 91% 91% 91% 91% 91% 91% 90% 90% 90% 90% 88% 172~286 Volts(DC) 86~143 Volts(DC) 58~96 Volts(DC) 44~72 Volts(DC) 33~54 Volts(DC) 29~48 Volts(DC) 26~42 Volts(DC) 22~36 Volts(DC) 18~30 Volts(DC) 17~27 Volts(DC) 15~24 Volts(DC) 8~12 Volts(DC) ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 DR100 1 0 0 W S i n g l e O u t put LED Driver with PFC INPUT SPECIFICATIONS ENVIRONMENTAL SPECIFICATIONS Input Voltage Range (Note 4) Frequency Range Input Current Leakage Current Inrush Current Power Factor Oper. Temperature Operating Humidity Storage Temp. / Humidity Max. Case Temperature Vibration MTBF IP Rating 100-305VAC 47-63 Hz (50/60 Hz nominal) 1.3 Amps max @ 100VAC 0.6 Amps max @ 220VAC <0.75mA/230VAC <0.5mA/120VAC 65A 0.96 (220Vac) OUTPUT SPECIFICATIONS Voltage and Current Constant Current Range Dimming Current Range Voltage Tolerance (Note 2) Line Regulation Load Regulation Efficiency Ripple/Noise (Note 1) Turn-on Delay Time (Note 6) Temperature Coefficient Output Overshoot / Undershoot Over Voltage Protection Over Current Protection (Note 3) Short Circuit Protection Over Temperature Protection See Selection Chart See Selection Chart 10~100% rated output current, ≥50% rated output voltage ±5% ±1% ±5% See Selection Chart ≤10% Output Voltage 3S, max. ±0.03%/°C (0~50°C) 10% When powered on or off Shut down at 140%Vo and latch off o/p voltage, re-power on to recover Constant current limiting ≤10W with 3 in 1 Dimmer Function Hiccup Auto Recover w/o Dimmer Shut down and latch off o/p voltage PHYSICAL SPECIFICATIONS Size Weight 196 x 68 x 40 mm 28.22 oz (800g) WWW.ASTRODYNE.COM series -40°C to +60 (See Derate Curve) 20~95%RH, non-condensing -45°C to +85°C / 10~95%RH 80 °C 10~300Hz,1G ,Period for 60min, each along X,Y,Z axes 500KHrs IP67 without Adjustment Option IP66 with Adjustment Option GENERAL SPECIFICATIONS Safety (Note 5) Isolation I/P-OP: I/P-GND, O/P-GND: Isolation Resistance EMC Interference (Note 5) EMC Emission (Note 5) EMC Immunity (Note 5) UL8750, IEC61347, EN55015 3.75K VAC 1.56K VAC 100MΩ/500VDC/25°C/70%RH Compliance to EN55015, EN55022 (CISPR22) Class B Compliance to EN61000-3-2 Class C (≥50%load); EN61000-3-3 Compliance to EN61000-4-2,3,4,5,6,8,11 ENV50204, EN61547, EN55024 NOTES 1. O/P Noise measured directly at the terminals at nominal load, 20MHz bandwidth by using a 12” twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 2. Includes set up tolerance, line regulation and load regulation 3. Constant current operation region is within 60% ~100% rated output voltage. This is the suitable operation region for LED related applications, but please reconfirm special electrical requirements for some specific system designs. 4. Derating may be needed under low input voltages. Please check the Static Characteristics for more details. 5. Safety and EMC design refer to EN60598-1, subject 8750(UL), CNS15233, GB7000.1, FCC part18. The power supply is considered a component that will be installed in the end application. EMC performance be must re-qualified in the completed installation. 6. Cold start. Turning ON/OFF the power supply may lead to increase of set up time ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 DR100 1 0 0 W S i n g l e O u t put LED Driver with PFC series Mechanical Outline 198 ACL（BLACK） ACN（WHITE） （GREEN） 10 176 8 172 TC UNIT：mm 220±20 Tcase 86 26 AC Input(3*AWG#18) 5 12±0.5 52 Dimming wires(2*AWG#22) 12±0.5 DC Output(2*AWG#18) 220±20 520±20 12±0.5 AGND(BLACK) PVR (ORANGE) V+(RED) V-(BLACK) 185 44 Tcase: Max. Case Temperature Power's internal temperature is 15°C warmer than case temperature. All specifications are typical at nominal input, full load, and 25°C unless otherwise noted WWW.ASTRODYNE.COM Astrodyne products are not authorized or warranteed for use as critical components in life support systems, equipment used in hazardous environments, nuclear controls systems, or other mission-critical applications. ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 DR100 1 0 0 W S i n g l e O u t put LED Driver with PFC series Part number code D R 100 - 024 S 400 TC A Optional mode: output voltage and current are adjustable (IP66 rated) Lighting products Optional mode：two letters Default：no additional features，output voltage and current can regulation TC: 3 in 1 dimming function (PWM, resistance, voltage) R：High performance LED driver E：Economical LED driver Output current(*10mA) ：three numbers Filled 0 in front of it when less than 3; four numbers are available if needed. For example:400 means 4000mA，035 means 350mA Output power(W): three numbers Filled 0 in front of it when less than 3. Output channel：one letter or number S: Single channel output D: Double channel output T: Triple channel output Q: Quadruple channel output F: Quintuple channel output H: sextuple channel output Output voltage(V)：three numbers Filled 0 in front of it when less than 3. For example:105 means 105V ，024means24V For example: DR100-024S400TC means it is a high performance LED driver, output power 100W, output voltage 24Vdc, output current 4000mA ，single output，with 3 in 1 dimming function. . wiring diagram ACL BROWN ACN BLUE CE CE V- BLUE GND YELLOW GREEN OR OR ACL BLACK ACN WHITE V+ BROWN UL GND GREEN WWW.ASTRODYNE.COM OUTPUT WIRES INPUT WIRES LED DRIVER DIMMING WIRES UL V+ RED V- BLACK TC AGND BLACK PVR ORANGE ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 DR100 1 0 0 W S i n g l e O u t put LED Driver with PFC series Derating Curve Derating Curve 110VAC ~277VAC 100 load（%） 80 100VAC 60 40 20 0 -40 -25 -5 0 15 30 50 60 70 Ambient Temperature （˚C ） Static Characteristics Derating Curve 100 load（%） 80 60 40 20 0 90 100 110 180 210 240 260 277 Input Voltage（V） WWW.ASTRODYNE.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 DR100 1 0 0 W S i n g l e O u t put LED Driver with PFC series Power Factor Characteristic(DR100-024S400) 1.03 PF 0.98 0.93 110VAC 230VAC 0.88 277VAC 0.83 50% 60% 70% 80% 90% 100% LOAD EFFICIENCY vs LOAD(DR100-024S400) 95 EFFICIENCE 90 85 80 110VAC 75 230VAC 70 277VAC 65 10% 20% 30% 40% 50% 60% 70% 80% 90% 100% LOAD VO Typical LED power supply I-V curve 100% (A) Constant voltage area 60% (C) Non-Dimming hiccup protection area 50% WWW.ASTRODYNE.COM (B) Constant current area (D) Dimming constant current area 100% IO ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 DR100 1 0 0 W S i n g l e O u t put LED Driver with PFC series Non-isolated 3 in 1 dimming function Reference resistance value for output current adjustment (Typical) Resistance value Single driver Multiple drivers Percentage of rated current 10KΩ 20KΩ 30KΩ 40KΩ 50KΩ 60KΩ 70KΩ 80KΩ 90KΩ 100KΩ OPEN 10KΩ /N 20KΩ /N 30KΩ /N 40KΩ /N 50KΩ /N 60KΩ /N 70KΩ /N 80KΩ /N 90KΩ /N 100KΩ /N OPEN 10% 20% 30% 40% 50% 60% 70% 80% 90% 100% 98%∼108% 1 ~ 10V dimming function for output current adjustment (Typical) Dimming value Percentage of rated current 1V 10% 2V 20% 3V 30% 4V 40% 5V 50% 6V 60% 7V 70% 8V 80% 9V 10V OPEN 90% 100% 98%∼108% 10V PWM signal for output current adjustment (Typical): Frequency range: 100HZ ~ 3KHz Duty value Percentage of rated current 10% 10% 20% 20% 30% 30% 40% 40% 50% 50% 60% 60% 70% 70% 80% 80% 90% 90% 100% OPEN 100% 98%∼108% Input and output Dielectric strength Isolation Input Wires Output Wires Isolated Dimming Control Wires Chassis Input Wires NA 3750 2000 2000 Output Wires 3750 NA 2000 2000 Isolated Dimming Control Wires 2000 2000 NA 2000 Chassis 2000 2000 2000 NA Fixed derating-cutoff type temperature protection Output Power 100% ≤20% 80∼85˚C WWW.ASTRODYNE.COM 90∼105˚C Case temperature (TC) 4812 ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458