5302

5302
Note: For more information about using programmable keys and other features on your 5302 IP
Phone, refer to 5302 IP Phone User Guide located at http://edocs.mitel.com or contact
your administrator.
Configuring your Directory Number
(DN) and PIN
If all 3 LEDs are flashing after power-up or
reset, the DN must be entered using the dial
pad, followed by the ‘#’ key. Then,
optionally enter a PIN followed by the ‘#’
key. If you do not need to enter a PIN. just
press the ‘#’ key.
Phone Key Features
Make a Call
12
Lift handset.
1
Dial number.
1
Press the # key to indicate the end of
dialing or wait for the call to connect.
Retrieve a Message
12
Lift handset
1
Dial the voicemail number, OR
4
Press the programmed message key.
Follow the prompts to retrieve your
message.
Transfer a Call
6
Press
, then dial the transfer
destination number.
12
Hang up when you hear ringing or
wait for an answer, announce the
call, then hang up.
Conference Call
First call is established.
6
Press
, dial the number of the
third party when you hear dial tone,
then wait for an answer.
6
Press
1
Dial the conference feature access
code when you hear dial tone.
Receive a Call
12
Lift the handset.
If the handset is already off hook,
8
or
9
Press the flashing line key.
End a Call
12
Replace the handset.
Place a Call on Hold
7
8
M (Mitel design) is a registered trademark of Mitel Corporation. ©2007, Mitel Corporation.
All other products and services are the trademarks of their respective holders. All rights reserved.
Adjust Handset or Speaker Volume
12
Lift handset.
10
or
Press
. The LED next to the
held line number will flash.
Retrieve a Call on Hold
or
9
Press the flashing line key.
.
11
Press volume up
volume down
or
repeatedly.
Speaker volume is changed if a paging
call is playing.
Adjust Ringer Volume
10
or
11
Press volume up
volume down
while ringing.
or
repeatedly.
Similar pages