M ICROWAVE A Division of Crystek Corporation NOTES: 1.0 Materials 1.1 Body, Coupling, and Clamp Nuts: Steel. Corrosion Resistant per ASTM-A582. UNS No. S30300. 1.2 Center Conductor: Beryllium Copper per ASTM-B196. UNS C17300. 1.3 Solder Ferrule: Brass per ASTM-B16. UNS C36000. 1.4 1.5 1.6 1.7 Lock Ring: Beryllium Copper per ASTM-B197. UNS C17200. Gasket: Silicone Rubber per A-A-59588. Insulator: PTFE Fluorocarbon per ASTM-D1710. Cable Stop: Teflon. 2.0 Finishes 2.1 Center Contact and Solder Ferrule: Gold Plate per ASTM-B488 50 Microinches Min. thickness over Electrolytic Nickel Plate per ASTM-B689 50 Microinches Min. thickness. 2.2 Body, Coupling, and Clamp Nuts: Passivated per SAE-AMS-2700. 2.3 Gasket, Lock Ring, and Dielectrics: None. 3.0 Interface: Type N plug per Crystek interface specification CC-PNP-TL. Page 1 of 2 CRYSTEK CORPORATION 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com M ICROWAVE A Division of Crystek Corporation Step 1 1.1 Trim Cable as shown. 2.1 2.2 2.3 2.4 Step 2 Step 3 Slide clamp nut over cable as shown. Insert cable into solder ferrule as shown then solder braids to ferrule where indicated. Trim exposed cable dielectric flush with solder ferrule face. Slide dielectric stop over cable center conductor against ferrule face and solder contact flush against stop to dimension shown. 3.1 Insert cable/contact sub-assembly into connector until seated. 3.2 Tighten connector coupling nut to mating type N jack. 3.3 Tighten rear clamp nut to 30-40 in-lbs and disengage main interface from jack. Product Control: Crystek Part Number: CS-NM-MSC Release Date: 04-Jan-11 Revision Level: A Responsible: K. Piotrowicz CRYSTEK CORPORATION Page 2 of 2 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com