Model J100N50X4 Half Flange Termination 100 Watts, 50Ω Description The J100N50X4 is high performance Aluminum Nitride (AlN) half flange termination intended as a cost competitive alternative to Beryllium Oxide (BeO). The termination is well suited to all cellular frequency bands such as; AMPS, GSM, DCS, PCS, PHS and UMTS. The high power handling makes the part ideal for terminating circulators, and for use in power combiners. The termination is also RoHS compliant! General Specifications Features: • RoHS Compliant • 100 Watts • DC – 3.0 GHz • AlN Ceramic • Non-Nichrome Resistive Element • Low VSWR • 100% Tested Resistive Element Substrate Cover Mounting Flange Leads Cover Thick Film AlN Ceramic Alumina Ceramic Copper, nickel plated per QC-N-290 99% pure silver (.006” thick) Alumina Ceramic Tolerance is ±0.010”, unless otherwise specified. Designed to meet of exceed applicable portions of MIL-E-5400. All dimensions in inches. Electrical Specifications Resistance Value: Power: Frequency Range: V.S.W.R. 50 Ohms, ± 2% 100 Watts DC – 3.0GHz 1.25 : 1 Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Storage temperature is -20°C to 85 ºC . Operating temperature is -55ºC to 125ºC (see chart for derating temperatures). Specifications subject to change with out notice. Outline Drawing Note: All dimensions in inches – 1inch = 2.54cm. Lead Length: 0.150in min. J100N50X4 (097) Rev E. USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Model J100N50X4 Typical Performance: J100N50X4 Power De-rating: J100N50X4 Mounting Footprint and Procedure: J100N50X4 (097) Rev E USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392