RoHS Power Choke High Current PCHC104R7 Dimensions: .456 Max (11.6 Max) Inches (mm) .098+/-0.019 (2.5+/-0.5) .397+/-.011 (10.1+/-0.3) .118 Typ. (3.0 Typ.) .157 Max (4.0 Max) Allied Part Number Inductance (µh) Tolerance (%) DCR (mΩ) Max. Irms (A) Typ. Isat (A) Typ. PCHC104R7-R22M-RC 0.22 20 0.6 35 45 PCHC104R7-R36M-RC 0.36 20 1.2 34 42 PCHC104R7-R45M-RC 0.45 20 1.2 33 38 PCHC104R7-R47M-RC 0.47 20 1.2 33 38 PCHC104R7-R56M-RC 0.56 20 1.55 27 32 PCHC104R7-R68M-RC 0.68 20 1.55 27 30 PCHC104R7-1R0M-RC 1.0 20 3.1 20 26 PCHC104R7-1R5M-RC 1.5 20 4.2 16 22 PCHC104R7-1R8M-RC 1.8 20 5 15.3 16 PCHC104R7-3R3M-RC 3.3 20 13.2 11 12 PCHC104R7-6R8M-RC 6.8 20 25 6 10 PCHC104R7-8R2M-RC 8.2 20 30 6 9 PCHC104R7-100M-RC 10 20 30 6.5 7 PCHC104R7-150M-RC 15 20 53 5 6 PCHC104R7-220M-RC 22 20 64 4.5 4.5 Features • • • • • Magnetically shielded construction High saturation current up to 45A Low DC Resistance Expanded operating temp range Suitable for pick and place Electrical Inductance Range: .22µH to 22µH, additional values available. Tolerance: 20% over entire range Available in tighter tolerances. Test Frequency: 100KHz, 0.5V Operating Temp: -55ºC ~ +125ºC StorageTemp: -55ºC ~ +125ºC Irms: Current at which the temp will rise approx 40ºC. Isat: Current at which the Inductance will drop approximately 30%. Part temperature should not exceed 125ºC including temperature rise. Resistance to Soldering Heat Pre-Heat 150ºC, 1 minute. Solder Composition: Sn/Ag3.0/Cu0.5 Solder Temp: 260ºC ± 5ºC Immersion Time: 10 sec. ± 1 sec. All specifications subject to change without notice. Test Equipment (L): HP 4284A LCR meter or equivalent DCR: CH502, Agilent 33420A Micro-Ohm meter IDC: 3260B WK & DC Bias 3265B WK Physical Packaging: 500 pieces per 13 inch reel. Marking: EIA Inductance Code 714-665-1140 ALLIED COMPONENTS INTERNATIONAL 05/30/12 15 www.alliedcomponents.com