Model MM4xMS Model MM4xMS-15 Triple Balanced Mixer RF 1.5 to 9.0 GHz Multi-Octave Band Electrical Specifications: (1) Specifications Conditions RF (GHz) 2.0-9.0 1.5-9.0 Parameter SSB Conversion loss: (2) (3) Isolation LO to RF: LO to IF: RF to IF: IF to RF: 1.5-9.0 LO (GHz) 2.0-9.0 1.5-9.0 IF (MHz) 10-2000 10-4000 1.5-3.0 3.0-9.0 1.5-9.0 Min 15 dB 20 dB 22 dB 10-4000 Input 1 dB Compression Point: 1.5-9.0 1.5-9.0 10-4000 Input Third Order Intercept Point: 1.5-9.0 1.5-9.0 10-4000 LO Power: (4) 1.5-9.0 1.5-9.0 10-4000 Typical 6.0 dB 6.5 dB 22 27 35 31 42 Max 7.5 dB 9.0 dB Model MM4xMS Model MM4xMS-15 LO Power 4 = +10 dBm 6 = +13 dBm 7 = +17 dBm 8 = +21 dBm dB dB dB dB dB +5 dBm +8 dBm +12 dBm +15 dBm +14 dBm +17 dBm +21 dBm +24 dBm +10 dBm +13 dBm +17 dBm +21 dBm MM44 MM46 MM47 MM48 MM44 MM46 MM47 MM48 MM44 MM46 MM47 MM48 Notes: 1. Specifications are guaranteed when tested as a downconverter in a 50 Ohm system at +25˚C with the nominal LO power. Specifications indicated as typical are not guaranteed. 2. Noise figure is typically within ±0.5 dB of conversion loss. 3. Conversion loss typically degrades less than 0.5 dB at +100˚C and improves less than 0.5 dB at -55˚C. 4. Usable LO drives are up to 2 dB below and 3 dB above nominal. 5. See Application Note M112, for aid in selecting the outline and for mounting and installation information. MM4xMS Outline: MS3AL Typical Performance at 25˚C z MM4xMS-15 Outline: MS3BL NOTES (UNLESS OTHERWISE SPECIFIED): 1. LO, RF, AND IF TRACES ARE 0.02[0.5] WIDE AND SUITABLE FOR SOLDER ATTACH. 2 RELIEF IN MOUNTING SURFACE REQUIRED FOR COMPONENT CLEARANCE. All dimensions are in inches and [mm]. CT Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, FL 32905 · PH (888) 553-7531 · Fax (888) 553-7532 www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, PA 19154 · PH (215) 464-4000 · Fax (215) 464-4001 REV A 9/13/10