Model Number: QBS-617 Signal Jamming Power Amplifier Communications Band Microwave Power Module Features • 150W Peak Output Power • Typical frequency range of 1930-2000 MHz • Communications Signal Jamming Applications • Class “A” Amplifier • Typical Gain of 50dB The LDMOS-based, QBS-617 is a Class “A” Amplifier operating in a frequency band of 1930MHz to 1990MHz to specifically jam communication band frequencies. This addition to API’s power amplifier product line offers a minimum output power of 100 watts with a gain of 50dB, with multiple carrier inputs. Typical current draw from a nominal +28 VDC supply at rated output power is 8 A. This design offers a isolator protected output to guard against transistor failure due to infinite VSWR mismatch. In addition API has incorporated an array of control and monitoring features including amplifier enable, high temperature alarm, thermal shutdown, forward / reverse power monitoring and temperature monitoring. The entire assembly is packaged in an aluminum chassis for heat dissipation and protection from harsh environmental conditions. Electrical Ratings Parameter Specification (1) Unit Typical 25°C Comment Guaranteed 25°C Frequency Range MHz Saturated Output Power Watts 150 POUT @ 1dB Compression Watts 120 100 min. Gain @ 1dB Compression dB 50 dB 48 min. Input VSWR — 1.3 :1 1.5 :1 max. Output VSWR — 1.3 :1 1.5 :1 max. dBm +55 Noise Figure dB 8 DC Voltage Vdc 3rd Order Output Intercept Point 1930 - 2000 Minimum Bandwidth Note 2 10 max. +28.0 Nominal Current (Quiescent) A 1.5 2.0 max. Current (POUT = 100W) A 8 10 max. No RF Input Rev Date: 10/7/2015 © API Technologies Corp. Proprietary Information Page # 1 | www.apitech.com | micro.apitech.com | +1.888.553.7531 | [email protected] Model Number: QBS-617 Absolute Maximum Ratings Parameter Limit Unit Specification DC Voltage Max. Vdc +32 RF Input Power Max. dBm +13 CW °C - 20 Baseplate °C +70 Min. °C - 40 Max. °C +100 Operating Temperature* Min. Max. Storage Temperature Comment Baseplate *Maximum Operating Temperature is defined as the baseplate temperature which, if exceeded for extended periods, could result in premature unit failure. This data is provided for user reliability information. This may or may not represent the maximum temperature for electrical parameter specifications. Features Parameter Specification DC Input RF Output Protection Comment Reverse Polarity Integrated Isolator Amplifier Enable High Temperature Alarm Infinite VSWR (POUT = 100W) High → Disable Low or Open → Enable TTL Logic High → Alarm Low → Normal TTL Logic 90 ± 5⁰C 70 ± 5⁰C; Auto Enable Thermal Shutdown Forward Power Monitor 4.0V @POUT = +50 dBm, 0.1 V/dB Analog Reverse Power Monitor 4.0V @POUT = +50 dBm, 0.1 V/dB Analog VO = (T/100) + 0.5V Analog Temperature Monitor Notes: 1) Specification ratings are based on measurements in a 50 ohm system with a DC supply voltage tolerance of ± 2%. 2) Two tone measurement with a 1 MHz spacing and an output single carrier level of +38 dBm. Rev Date: 3/16/2015 © API Technologies Corp. Proprietary Information Page # 2 | www.apitech.com | micro.apitech.com | +1.888.553.7531 | [email protected] Model Number: QBS-617 Mechanical Specifications Parameter Specification Maximum Case Dimensions Comment 150 (L) x 120 (W) x 25 (H) mm Material Aluminum Alloy 6061-T6 Finish Clear Iridite MIL-STD-5541F, Class 3 SMA Female (4-Hole Flange) Captivated; Extended Teflon Type N Female (4-Hole Flange) Extended Teflon I/O Interface 9 Pin D-Sub; Male Figure 1 +VDC Filtered Feed Thru Solderable Threaded Turret Solderable Connectors RF Input RF Output +VDC Return Grounding Chassis Cooling Adequate Heat Sink Required Relative Humidity Weight 0 to 90% Non-condensing 2.2 lbs Max. 1.9 lbs Typical Outline Drawing Pin Number NOTES: • Interpret drawing IAW ASME Y14.100-2004 • Dimensions and tolerancing IAW ASME Y14.5-1994 • Dimensions are in millimeters • TOLERANCES • Angles: ± 1.0° Signal 7W2 Connector Signal +28 VDC Ground N/C PA Enable N/C N/C Temp Alarm A1 A2 1 2 3 4 5 Rev Date: 10/7/2015 © API Technologies Corp. Proprietary Information Page # 3 | www.apitech.com | micro.apitech.com | +1.888.553.7531 | [email protected]