RF AMPLIFIER MODEL QBH-1505PM Available as: Features Typical Intermodulation Performance at 25 ºC Ultra Low Phase Noise Performance Superior Gain Stability Replaces Avantek’s “1023” Design Environmental Screening Available Second Order Harmonic Intercept Point ....... +46 dBm (Typ.) Second Order Two Tone Intercept Point ........ +40 dBm (Typ.) Third Order Two Tone Intercept Point ............ +34 dBm (Typ.) Absolute (No Damage) Maximum Ratings Specifications Gain (dB) 13.0 12.0 Min. Gain Flatness (dB) Power @ 1 dB Comp. (dBm) (10-500 MHz) ±0.25 ± 0.75 Max. Ambient Operating Temperature ................ -55ºC to +100 ºC Storage Temperature .................................-62ºC to +125 ºC DC Voltage .......................................................... +15 Volts Continuous RF Input Power .................................. +13 dBm Short Term RF Input Power ...... 50 Milliwatts (1 Minute Max.) Maximum Peak Power .................... 0.1 Watt (3 μsec Max.) 28.0 26.5 25.5 Min. 25.0 Min. MTBF Calculation for Ground Benign Environment @ 25 ºC .................................................1,674,483.59 hrs 17 15 Max. CHARACTERISTIC Frequency TYPICAL Ta= 25 ºC 10 - 1000 MHz (500-1000 MHz) Reverse Isolation (dB) VSWR In Out Noise Figure (dB) Power Vdc mA MIN/MAX Ta = -55 ºC to +85 ºC 10 - 1000 MHz 1.5:1 1.5:1 6.0 +12 195 Guaranteed Phase Noise Performance (dBc/Hz) 2.0:1 Max. 2.0:1 Max. 9.0 Max. +12 210 Max. Note: Care should always be taken to effectively ground the case of each unit. (Measured in a 50 Ohm system @ +12 Volts DC nominal unless otherwise noted) Gain (dB) 15 Frequency 10 Hz 100 Hz 1 kHz 10 kHz 100 kHz 1 MHz Typical -150 -160 -170 -177 -180 -180 Guarantee -145 -155 -165 -172 -175 -175 Typical Performance Data Revision 10-19-2012 14 -10 -20 12 -30 11 -40 Start 10 MHz Stop 1000 MHz Phase Noise (dBc/Hz) Reverse Isolation (dB) 0 13 -130 -140 -150 -160 Stop 1000 MHz Start 10 MHz 1 dB Comp. (dBm) +28 QBH-1505PM, 4 Pin TO-8 (T4) QBH-9-1505PM, Connectorized Housing (H1) -170 Noise Figure (dB) 8 +26 7 +24 6 +22 5 +20 Input VSWR -190 Start 10 MHz 2.0 1.5 1.5 Start 10 MHz Stop 1000 MHz 100 1k 10k 100k __ __ __ Typical 2.0 1.0 10 4 Stop 1000 MHz Start 10 MHz -180 1.0 Stop 1000 MHz Residual Phase Noise Test Conditions: *Carrier Frequency: 600 MHz Power Output: +27.0 dBm Output VSWR Stop 1000 MHz Start 10 MHz Legend Temperature: 25 ºC ES5500 System Agilent +25 ºC +85 ºC - - - - - - -55 ºC Linear S-Parameters Data FREQ. MHz – – S11– – Mag Ang – – S21– – Mag Ang – – S12– – Mag Ang – – S22– – Mag Ang ================================================================== 0.11 10 0.23 151.8 0.11 4.70 -172.3 8.8 -61.9 0.11 -34.4 250 0.14 148.5 0.02 4.66 116.7 -83.6 0.12 500 0.14 124.8 0.01 -171.7 4.55 -70.5 54.5 0.13 -109.3 97.0 750 0.15 0.02 126.7 4.49 -7.5 0.14 -151.2 40.7 1000 0.13 0.05 4.51 15.7 -70.8 0.15 173.5 -25.7 1200 0.13 0.12 4.58 -123.8 -44.2 0.15 155.1 -68.5 1300 0.14 0.16 4.60 -151.8 -70.8 Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH (888) 553-7531 · Fax (888) 553-7532 www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, Pennsylvania 19154 · PH (215) 464-4000 · Fax (215) 464-4001 1M