RF AMPLIFIER MODEL TM5122PM Available as: TM5122PM, 4 Pin TO-8 (T4) TN5122PM, 4 Pin Surface Mount (SM3) FP5122PM, 4 Pin Flatpack (FP4) BX5122PM, Connectorized Housing (H1) Features Typical Intermodulation Performance at 25 ºC ! Superior Phase Noise Performance ! Output Power: +20 dBm Typical ! Operating Temp. -55 ºC to +85 ºC ! Environmental Screening Available Second Order Harmonic Intercept Point ...... +43 dBm (Typ.) Second Order Two Tone Intercept Point ....... +38 dBm (Typ.) Third Order Two Tone Intercept Point ........... +30 dBm (Typ.) Maximum Ratings Specifications CHARACTERISTIC Frequency TYPICAL Ta= 25 ºC 10-500 MHz MIN/MAX Ta = -55 ºC to +85 ºC 10-500 MHz 17 15.5 Min. +20 + 19 Min. -22 <1.8:1 <1.8:1 4.2 +15 60 -20 Max. 2.0:1 Max. 2.0:1 Max. 4.6 Max. +15 65 Max. Gain (dB) Power @ 1 dB Comp. (dBm) Reverse Isolation (dB) VSWR In Out Noise Figure (dB) Power Vdc mA Ambient Operating Temperature ................ -55ºC to +100 ºC Storage Temperature ................................. -62ºC to +125 ºC Case Temperature .................................................. +125 ºC DC Voltage .......................................................... +18 Volts Continuous RF Input Power .................................. +13 dBm Short Term RF Input Power ........... 100 mW (1 Minute Max.) Maximum Peak Power .................... 0.5 Watt (3 µsec Max.) Guaranteed Phase Noise Performance (dBc/Hz) Frequency 100 Hz 1 kHz 10 kHz 100 kHz 1 MHz Typical -157 -170 -173 -173 -173 Guarantee (min.) -153 -166 -170 -170 -170 * Note: Care should always be taken to effectively ground the case of each unit. Typical Performance Data Gain (dB) 19 Reverse Isolation (dB) -10 18 -20 17 -30 16 -40 15 Start 10 MHz Stop 500 MHz +20 5 +19 4 +18 3 Input VSWR Stop 500 MHz -170 -180 -190 100 Start 10 MHz 2.0 Output VSWR Stop 500 MHz 1.5 1.5 1.0 Start 10 -160 Stop 500 MHz Noise Figure (dB) 7 6 Start 10 MHz -150 Start 10 MHz +21 2.0 -140 -50 1 dB Comp. (dBm) +22 Stop 500 MHz MHz Legend +25 ºC Phase Noise (dBc/Hz) -130 1.0 Start 10 Stop 500 MHz MHz 1k 10k 100k 1M _________Guarantee __ __ __ __Typical Residual Phase Noise Test Conditions: ! Carrier Frequency: 500 MHz ! Power Output +18.5 dBm ! Temperature: 25 oC ! Agilent ES5500 System +85 ºC - - - - - - -55 ºC Linear S-Parameters FREQ. – – – – S11– – – – – – – – S21– – – – – – – – S12– – – – – – – – S22– – – – Mag Deg Mag Deg Mag Deg Mag Deg MHz ========================================================================================================= 5 50 100 200 300 400 500 .16 .04 .07 .15 .24 .29 .29 - 76 - 87 - 94 -123 -159 155 89 6.84 7.19 7.15 7.16 7.21 7.38 7.30 -156 166 148 114 80 43 1 .09 .09 .09 .10 .11 .11 .11 -155 163 145 108 75 41 5 .15 .08 .12 .18 .18 .16 .19 -33 20 23 3 -30 -82 -161 Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH (888) 553-7531 · Fax (888) 553-7532 0222205/04/05 www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, Pennsylvania 19154 · PH (215) 464-4000 · Fax (215) 464-4001