RF AMPLIFIER MODEL TM9105PM Available as: Features Typical Intermodulation Performance at 25 ºC ! ! ! ! Superior Phase Noise Performance Higher Power: +21 dBm Typical Operating Temp. -55 ºC to + 85 ºC Environmental Screening Available Second Order Harmonic Intercept Point ....... +50 dBm (Typ.) Second Order Two Tone Intercept Point ........ +45 dBm (Typ.) Third Order Two Tone Intercept Point ............ +35 dBm (Typ.) (Absolute) Maximum Ratings Specifications CHARACTERISTIC Frequency TYPICAL Ta= 25 ºC 10 - 1000 MHz MIN/MAX Ta = -55 ºC to +85 ºC 10 - 1000 MHz Gain (dB) 12.5 10.5 Min. +21 +19 Min. -15 1.5:1 1.5:1 4.5 +15 90 -13 Max. 2.0:1 Max. 2.0:1 Max. 6.5 Max. +15 Min. 100 Max. Power @ 1 dB Comp. (dBm) Reverse Isolation (dB) VSWR In Out Noise Figure (dB) Power Vdc mA TM9105PM, 4 Pin TO-8 (T4) TN9105PM, 4 Pin Surface Mount (SM3) BX9105PM, SMA Connectorized Housing (H1) Ambient Operating Temperature ................ -55ºC to +100 ºC Storage Temperature .................................-62ºC to +125 ºC Case Temperature .................................................. +125 ºC DC Voltage .......................................................... +18 Volts Continuous RF Input Power .................................. +13 dBm Short Term RF Input Power ...... 50 Milliwatts (1 Minute Max.) Maximum Peak Power .................... 0.5 Watt (3 µsec Max.) Guaranteed Phase Noise Performance (dBc/Hz) Note: Care should always be taken to effectively ground the case of each unit. Frequency 100 Hz 1 kHz 10 kHz 100 kHz 1 MHz Typical -164 -174 -178 -180 -180 Typical Performance Data Gain (dB) 14 0 13 - 10 12 - 20 11 - 30 10 Stop 1000 MHz Start 10 MHz - 40 1 dB Comp. (dBm) 23 Reverse Isolation (dB) -150 -160 Stop 1000 MHz Start 10 MHz Noise Figure (dB) 8.0 -170 -180 6.0 21 -190 100 20 Stop 1000 MHz Start 10 MHz Input VSWR 2.0 4.0 Stop 1000 MHz Start 10 MHz Output VSWR 2.0 1.0 0.0 Phase Noise (dBc/Hz) -130 -140 22 19 Guarantee (Max.) -158 -168 -173 -175 -175 1.0 Start 10 MHz Legend Stop 1000 MHz +25 ºC 0.0 Start 10 MHz 1k 10k 100k 1M Phase Noise Test Conditions: Carrier Frequency: 600 MHz Power Output: +19 dBm Temperature: 25 ºC Agilent ES5500 System Stop 1000 MHz +85 ºC - - - - - - -55 ºC Linear S-Parameters FREQ. – – – – S11– – – – – – – – S21– – – – – – – – S12– – – – – – – – S22– – – – MHz Mag Deg Mag Deg Mag Deg Mag Deg ========================================================================================================= .11 10 .09 -56 4.45 10 116 .09 -173 .11 100 .04 14 4.53 0 120 .04 166 .12 200 .05 33 4.49 1 103 .04 152 .12 300 .06 50 4.50 -1 88 .06 139 .12 400 .07 54 4.51 -3 78 .07 125 .13 500 .10 59 4.50 -7 75 .08 111 .13 600 .12 63 4.51 -7 68 .09 98 .14 700 .15 61 4.47 -10 62 .11 84 .15 800 .18 58 4.43 -14 57 .11 70 .15 900 .22 54 4.32 -19 52 .12 56 .16 1000 .25 48 4.24 -23 47 .13 41 Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH (888) 553-7531 · Fax (888) 553-7532 10/19/06 www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, Pennsylvania 19154 · PH (215) 464-4000 · Fax (215) 464-4001