Download Data Sheet

Part No.
Quick-test Valved Fitting, 1/4" FNPT x 1/4" FNPT, S.S.
Install between a pressure gauge and the
process and isolate the process from the
gauge to perform a calibration of the gauge.
After completing the calibration open the valve
and place the gauge on-line, all without blowing
down the system.
• * Use whenever there is a gauge that needs frequent
calibration or verification
Pressure Range
0 to 3000 psi (0 to 207 bar)
End C1
1/4" Female NPT
End C2
1/4" Female NPT
End C3
Male Quick-test with Cap and Chain
Has Block Valve
Has Vent Valve
Temperature range
0 to 225 °F (-18 to 107 °C)
Stainless Steel
Seal materials
Buna-N, Delrin, Teflon
Dimensions A
3.57 in (9.07 cm)
Dimensions B
2.31 in (5.87 cm)
Ralston Instruments Inc. | | Toll Free 800-347-6575 | Phone 440-564-1430 | Fax 440-564-1480