15-pin High-Density D-Subminiature Field Terminating Insert Part Number: CHD15HDSC**Y INSTALLATION INSTRUCTIONS © Panduit Corp. 2014 PN389B INTRODUCTION The screw-down type 15-pin D-sub connector is designed for use with video cables having (3) coax lines (R,G,B) and (4) twisted pair lines with (2) conductor lines and a drain wire. Numerous configurations of video cables exist, signal names are given to accommodate the various video cable types with different conductor colors. RECOMMENDED TOOLS - 2mm slotted screwdriver - Wire cutters - Wire strippers - Cable stripper CHD15HDSC**Y STEP 1 Trim back video cable to expose conductors. 1 - Drain wire 4 - Twisted pair conductors (TP) Center conductor(CC) Outer conductor shield(SHLD) 3 - COAX: Red, Green, Blue 2 - Conductors(COND) 1" approximately 2" approximately ** Denotes color. For Technical Support: www.panduit.com/resources/install_maintain.asp Page 1 of 2 © Panduit Corp. 2014 INSTALLATION INSTRUCTIONS PN389B STEP 2 PINOUT TABLE Identify conductor to appropriate signal name per pinout table. Due to the wide variety of video cable: 1. There is no standard color code for the conductors other than the coaxial Red, Green, and Blue. 2. The only certain way to identify correct conductors is to perform a continuity test. 3. There may be unused conductors for your application. PIN 1 2 3 *4 5 6 7 8 9 *10 *11 12 13 14 15 16 SIGNAL WIRE COAX CC COAX CC COAX CC TP TP COAX SHLD COAX SHLD COAX SHLD N/C TP TP TP COND 1 COND 2 N/C DRAIN WIRE RED GREEN BLUE ID BIT 2 GROUND RED SHIELD GREEN SHIELD BLUE SHIELD NO CONNECTION SYNC RTN ID BIT 0 ID BIT 1 HORZ SYNC VERT SYNC ID BIT 3 SHELL * Wires connected together Greyed connections are optional STEP 3 Before inserting wires for termination, turn screws counter-clockwise to ensure all clamps are completely open. (See Fig. 1) Insert coaxial center conductors, coaxial shields, and conductors into appropriate slots of terminal board by signal name in accordance with the pinout table. OPEN HALF OPEN CLOSED Fig. 1 Turn screws clockwise to ensure all clamps are properly closed and wires are secure. E-mail: [email protected] For Instructions in Local Languages and Technical Support: www.panduit.com/resources/install_maintain.asp www.panduit.com Page 2 of 2 Phone: 866-405-6654