Standard Lid 0,4 around 18,6 7,4 0,9 0 0 5,5 4,2 7,1 9,25 7,4 13,8 18,6 6,5 PCB 1,9 (1,5-2,5) 12,2 9,25 5,8 15,9 ±0,5 13,8 51,5 4 20,2 unmounted condition mounted condition 3,25 20,2 3,25 1,5 3,6 X 45° area for SMD on PCB (max. height: 3,5 mm) 1,5 Thin Lid PCB 1,9 (1,5-2,5) O 6,6 16,03 Thin Lid Bottom View 2,8 51,5 15,9 ±0,5 Standard Lid Bottom View O 12,6 16,03 24,23 0 0,12 2,3 8,23 10,96 13,26 16,43 12,38 11 8,66 24,22 O 3,7 l 0,2 pessure pin area (x28) unmounted condition mounted condition 3,2 3,2 35 30 29 28 27 26 25 24 23 22 21 15 14 13 12 11 34 33 32 +0,2 O 9,2 0 PCB hole 20 19 18 17 16 24,1 21,9 21,8 18,6 15,4 12,2 9 7,8 4,6 1,6 1,4 0 1,6 1,8 5 9 12,2 15,4 18,6 21,8 31 58,9 ±0,8 10 9 8 7 6 5 4 3 2 1 A Tolerance of coordinate dimensions: u0,1mm PCB specification according to the actual handling instruction Actual pinout, see on the module datasheet The press lid is not part of the module, it has to be ordered separately For assembly related dimensions refer to the attached 3D-CAD models 3 min. PCB pad size (pads can be combined, depending on layout) 2,4 Module Top View 18,6 22,5 0 1,7 4,6 4,7 36 O 4,4 51,9 ±0,8 All rights reserved. Proprietary data, company confidential. 7,6 6,8 +0,2 O3 0 PCB hole 22,5 18,6 27,6 58,5 A 5:1 01 28.08.2015 Rev. Date initial release Alteration General tolerances ISO 2768 - m , K mid. of PCB pads are dimensioned Gyimóthy Zs Géczy M. Designed Approved Package drawing Ps A3 Linear dimensions x < 0,5 ±0,05 0,5≤ x < 6 ±0,1 6≤ x <30 ±0,2 30≤ x <120 ±0,3 120 < x ±0,5 x <0,3 ±0,05 0,3≤ x <0,5 ±0,1 0,5≤ x < 3 ±0,2 3≤ x < 6 ±0,5 6< x ±1 Chamfers, radii Inspectional dim: Revision number (Rev.): * References View scale 1,5:1 Page Skiip2D-*-PD IP Development Drawing alteration in revision: {} 1/1