Tool & Product Update PROPER ATTACHMENT ADAPTER 125770 ADAPTER 125770 The 209 tool has been obsoleted and superceded by adapter 125770. This adapter is designed for use with the 208-625 tool and 1500 series noses. Greater availability of the 208-625 tool makes the adapter/tool combination a more practical solution to those applications having clearance requirements that would necessitate use of the 209 tool. 90° 45° 1.280 7.530 .923 .455 1.500 2.250 2.250 1.495 125770 ADAPTER 208-625 TOOL Figure 1 HOW TO ATTACH ADAPTER ON REVERSE SIDE... 1/20/00 464 ATTACHING ADAPTER 125770 TO THE 208-625 TOOL (Refer to Figure 2) Thread drawbar stop 122879 into the rear of the tool piston and tighten using a 5/16" Allan wrench. Remove screw 501205 and 119423 stop from face of tool (if they are attached). Thread anvil holder 125767 onto tool until it bottoms on face of tool. Back off ½ to 1 full pitch (revolution) max. It should be oriented in the vertical position and free to rotate 45 degrees either side of the vertical axis (see fig. 1) Drop collet holder 125768 into anvil holder and insert draw-bar 125769 through front of anvil holder. Using a 5/16" Allan wrench thread drawbar 125769 down and tighten (it will bottom out against stop 122897). Replace stop 119423 and screw 501205 on face of tool. The adapter should be free to rotate through an included angle of 90 degrees (see fig. 1). Attach nose assemblies per nose assembly data sheet. 125768 COLLET HOLDER 208-625 TOOL 125767 ANVIL HOLDER 125769 DRAWBAR 501205 SCREW 119423 STOP Figure 2 TOOL AND ADAPTER ASSEMBLED 122897 STOP