DC-DC Converter UNIT OSN10W SERIES FEATURES •0.75~5.0 V out / 10 Amp SIP/SMD Package •8.3~14V Input Voltage •High efficiency •Cost efficient open frame design •2 YEARS WARRANTY •RoHS compliant OUTPUT SPECIFICATIONS INPUT SPECIFICATIONS Voltage Set point Accuracy Ripple & Noise (20MHz BW)1 +/-2% max 100mVp-p max Regulation2 Line Load Regulation3 +/-0.3% max +/-0.4% max Temperature Coefficient +/-0.4% max Short Circuit Protection Over Load Protection Continuous 180% Typ Input Voltage Range Input Filter Remote On/Off Control GENERAL SPECIFICATIONS Efficiency Switching Frequency Isolation voltage ENVIRONMENTAL SPECIFICATIONS Operating Temperature -40 °C to +85 °C Storage Temperature -55 °C to +125 °C 8.3 – 14V Capacitive Table 1 90% min 300KHz Typ Non-isolation Weight OSN10WH 6,5 g Typ Weight OSN10WS 6,0 g Typ SIP Package OSN10WH 50.8mm*13.0mm*10.7mm OSN10WS 33.0mm*13.5mm*7.6mm ALL SPECIFICATIONS TYPICAL AT NOMINAL LINE, FULL LOAD , AND 25 °C UNLESS OTHERWISE NOTED. [1] The value includes the deviation from output voltage setting point, line and load. [2] High Line to Low Line. [3] Load Regulation is for output load current change from 10% to 100% Load [4] Refer to the Derating Chart. Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specifications are subject to change without notice. Address: Hauptstr. 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Page (1) Version 1.0, 7th July 2009 DC-DC Converter UNIT OSN10W SERIES ●SELECTION GUIDE (1) MODEL NUMBER INPUT VOLTAGE (VDC) OSN10WHN[7] Vo(set) ≤3.63 Vin = 8.3-14 OSN10WHN[8] Vo(set) >3.63 Vin = 8.3-14 OUTPUT VOLTAG E (VDC) OUTPUT CURREN T (A) 0.75 ~ 5.0 10A EFFICIENCY (%)[6] 12Vin, 3.3Vdc@10A 92 Note: Other input to output voltages may be available. Please contact factory. ●MECHANICAL DIMENSIONS PIN ●RECOMMENDED FOOTPRINT DETAILS Single 1 +Vout 2 +Vout 3 SENSE 4 +Vout 5 Common 6 Common 7 +Vin 8 +Vin 9 NC 10 TRIM 11 On/Off Control [6] Nominal Input voltage, full load. [7] OSN10WHN ON/OFF – Negative Logic. [8] OSN10WHP ON/OFF – Positive Logic.. Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specifications are subject to change without notice. Address: Hauptstr. 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Page (2) Version 1.0, 7th July 2009 DC-DC Converter UNIT OSN10W SERIES ●SELECTION GUIDE (2) MODEL NUMBER INPUT VOLTAGE (VDC) OSN10WSN[10] Vo(set) ≤3.63 Vin = 8.3-14 OSN10WSP[11] Vo(set) >3.63 Vin = 8.3-14 OUTPUT VOLTAG E (VDC) OUTPUT CURREN T (A) 0.75 ~ 5.0 10A EFFICIENCY (%)[9] 12Vin, 3.3Vdc@10A 92 Note: Other input to output voltages may be available. Please contact factory. ●MECHANICAL DIMENSIONS [6] Nominal Input voltage, full load. [7] OSN10WSN ON/OFF – Negative Logic. [8] OSN10WSP ON/OFF – Positive Logic.. Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specifications are subject to change without notice. Address: Hauptstr. 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Page (3) Version 1.0, 7th July 2009 DC-DC Converter UNIT OSN10W SERIES ●EXTERNAL RESISTOR VALUES FOR PROGRAMMING OUTPUT VOLTAGE zTABLE 1 (Remote On/Off Control) Remote On/Off Control Voltage Negative logic (standard) ON = 0V < Vr < 0.3V OFF = 2.5V < Vr < Vin (max) Iin = 10uA, max Iin = 1mA, max Positive logic (option) ON = (Vin-4) < Vr < Vin(max) OFF = 0V < Vr < 0.3V Iin = 10uA, max Iin = 1mA, max Remote off state input current Nominal Vin 2.0mA, typ 10uA~1.0mA Input current of Remote control pin zDERATING CURVE Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specifications are subject to change without notice. Address: Hauptstr. 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Page (4) Version 1.0, 7th July 2009 DC-DC Converter UNIT OSN10W SERIES zINPUT FUSE SELECTION GUIDE Note: Certain applications may require the installation of external fuse in front of the input. Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specifications are subject to change without notice. Address: Hauptstr. 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Page (5) Version 1.0, 7th July 2009