DC-AC INVERTER UNIT PS-DA0401-152 (S) (20 W QUAD OUTPUTS) (PRELIMINARY INFORMATION) DESCRIPTION : This low profile DC/AC inverter is developed for quad lamps. Optimized for NEC: NL8060BC31-36 APPLICABLE LCD: 15 to 17 inches quad lamps Lamp voltage 540 Vrms Lamp current 4 x 6.0 mArms Lamp Start Up Voltage 1.500 Vrms (Vin : 12 Vdc) FEATURES : Remote ON/OFF Independent open lamp detection for each side Current balance circuit RoHS comliant (S) TEMPERATURE & HUMDITY : Operating Temperature Range Storage Temperature Range Humidity DIMENSIONS : LxWxH -10°C ~ +60°C -20°C ~ +85°C 95 %RH max 180 x 30 x 16 mm Pin 1 Pin 1 Pin 1 Unit : mm Weight :40 (g) typ. Pin 1 Note: Please use plastic screw in case of a non-insulating mounting base! Components No. 1 2 3 Part Description PCB Connector CN1 Connector CN2 ~ CN3 Qty. 1 1 2 Material UL94V-0 (FR-4 or CEM-3) S7B-PH-K SM04(4.0)B-BHS-1-TB Input side CN1: Pin No. Symbols Ratings Vin 10.8 ~ 13.2 Vdc CN 1-1+2 GND CN 1-3+4+6 Vrm t 0 ~ 0.4 = OFF / 4.5 ~ Vin = ON CN 1-5 Vbr 0 ~ 5.0 Vdc CN 1-7 Output side Pin No. CN 2-1 CN 2-2 CN2-3 CN 2-4 Note t=1m m JST or equal JST or equal CN2 ~ CN3 Symbols Ratings Vhigh1 540 Vrm s (6.0 m Arm s ) Vhigh2 540 Vrm s (6.0 m Arm s ) N.C. Vlow (GND) Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specifications are subject to change without notice. Address: Hauptstr. 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Page (1) Version 1.1.1, 21st May 2014 DC-AC INVERTER UNIT PS-DA0401-152 (S) (20 W QUAD OUTPUTS) (PRELIMINARY INFORMATION) ELECTRICAL CHARACTERISTICS : Conditions Parameters Symbols Output Current Output Current Input Current Frequency Open Circuit Voltage No load Shutdow n Iout Iout Iin F Vopen Ts d Note 1 : Vin (V) Vbr (V) 12±1.2 12±0.6 12±1.2 12±1.2 11.4 12±1.2 0.0 5.0 0.0 0.0 0.0 0.0 Specification Tu (°C) -10 -10 -10 -10 -10 -10 ~ +60 ~ +60 ~ +60 ~ +60 ~ +60 ~ +60 Min. Typ. Max. 5.5 1.7 45 1.300 1.0 6.0 2.0 1.77 52 1.500 - 6.5 2.3 2.2 60 - Unit Note m Arm s m Arm s Adc kHz Vrm s s ec Dut y 10 0 % wit ho ut lo ad Please keep a minimum of 2mm clearance in all directions between inverter high voltage areas and any conductors. TEST CIRCUIT : F Vin 12 V V SW4 SW 1 Operation of unit a Operation b Non operation CN2-2 CN1-4 a V V ~ CN2-1 CN1-1 CN1-2 CN1-3 Vrmt 0 / 5 Vdc Vopen SW3 Iin A 1000:1 PROBE F b RL2 T1 CN2-4 SW1 CN1-5 RL1 A ~ CL2 Iout 2 A ~ CL2 Iout 2 CL1 A ~ Iout 1 SW5 SW3 CN3-1 SW4 CN1-6 CN3-2 RL2 CN1-7 Vbr 0 ~ 5.0 Vdc CN3-4 RL1 CL1 A ~ Iout 1 SW5 Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specifications are subject to change without notice. Address: Hauptstr. 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Page (2) Version 1.1.1, 21st May 2014