Product data sheet PS-LEDP85-C LED-Netzteil | LED-Driver | LED-Control-Gear: 85 Watt (200 ~ 1.500mA / 24 ~ 55Vdc ) | CC • • Suitable for indoor applications Type of Protection: II and SELV output Product benefits • • • • High efficiency: > 91 % Very compact casing: 125 x 85 x 35 mm (L x W x H) Patented and labelled plugs for adjustments of precise output current 6 to 12 Vdc / 100mA adjustable Fan voltage Product features • • • • • • • Constant Current CC Output power max.: 85 Watt Output current range : 200 ~ 1.500 mA Output voltage range : 24 ~ 55 Vdc Simple and easily assembled poke-in connectors Analog current dimming, no PWM dimming Emergency voltage: 90 ~ 264 Vac or direct current voltage 150 ~ 300 Vdc Power Systems GmbH &Co KG Tel.: +49 7062 6759 6 www.power-systems.de Page (1) (Preliminary datasheet) All rights reserved. Version 3.2.2, 23th February 2016 Product data sheet PS-LEDP85-C LED-Netzteil | LED-Driver | LED-Control-Gear: 85 Watt (200 ~ 1.500mA / 24 ~ 55Vdc ) | CC Technical data Electrical Data Nominal voltage 100 ~ 240 Vac or 150 ~ 300 Vdc Input voltage range 90 ~ 264 Vac or 150 ~ 300 Vdc 1 Nominal current <2,0 Arms ² Power frequency 50 ~ 60 Hz or direct current voltage Output voltage range 24 ~ 55 Vdc 3 Output current range 200 ~ 1.500mA (selectable by current plugs) 4 Output power 85 W 5 Device power loss 7,6 W 6 Efficiency >91 % 7 Inrush current <100 A 8 Power factor λ >0,9 9 Device power loss in Stand-By <1 W Galvanic isolation primary / secondary 3750 Vac 10 Start delay <1 sec Switching off delay 10 msec Fan output 12 Vdc 11 Ripple voltage <1,0 Vss 1. 2. 3. 4. Permitted voltage range At 230 Vac or 250 Vdc Max. 57 Vdc <± 10% (200 ~ 1.500 mA) 5. 6. 7. 8. 9. 10. 11. Partial Load 4 ~ 85 W / non dimming Max. Full load at 230 Vac or 250 Vdc Twidth = 260 µs (measured at 50 % Ipeak), measured 80 A Full load at 230 Vac or 250 Vdc SELV-equivalent Max. 100 mArms. Adjustable 6-12 Vdc with resistor Dimensions and weight Lenght 125,0 mm Width 85,0 mm Height 35,0 mm Product weight 265 g Cable cross-section, input side 0,2 ~ 1,5 mm² / 24 ~ 16 AWG Cable cross-section, output side 0,2 ~ 1,5 mm² / 24 ~ 16 AWG Power Systems GmbH &Co KG Tel.: +49 7062 6759 6 www.power-systems.de Page (2) (Preliminary datasheet) All rights reserved. Version 3.2.2, 23th February 2016 Product data sheet PS-LEDP85-C LED-Netzteil | LED-Driver | LED-Control-Gear: 85 Watt (200 ~ 1.500mA / 24 ~ 55Vdc ) | CC Technical data Product drawing 3.0 35.0 125.0 3.1 D ia : 4. 0 85.0 3.1 9.95 3.0 Temperatures Operating ambient temperature range -20°C ~ +60°C Storage temperature range -20°C ~ +80°C Max. temperature at tc test point 85°C Operating humidity rage 5% to 80% Storage humidity rage 5% to 90% Capabilities Max. wiring lenght driver / lamp 10 m Overcurrent protection Automatic reversible Overvoltage protection Automatic reversible Short-circuit protection Automatic reversible Suitable for fixture with protection class I / II Power Systems GmbH &Co KG Tel.: +49 7062 6759 6 www.power-systems.de Page (3) (Preliminary datasheet) All rights reserved. Version 3.2.2, 23th February 2016 Product data sheet PS-LEDP85-C LED-Netzteil | LED-Driver | LED-Control-Gear: 85 Watt (200 ~ 1.500mA / 24 ~ 55Vdc ) | CC Technical data Certificates and standards CE EN61347-1; EN61347-2-13 EMI EN55015 Class B EMS EN61000-3-2; EN6100-3-3; EN61547 Type of protection IP50 Reliability: MTBF Drop test Vibration test Power Systems GmbH &Co KG Tel.: +49 7062 6759 6 www.power-systems.de 50.000 Stunden bei 25ºC. 100% Burn-In-Test 80~100% Last & 35~45ºC Betriebstemperatur. MIL HDBK-217F Testhöhe 76cm, nach Falltest keine Änderung der elektrischen Eigenschaften. Während der Seefracht sollte die Vibration nicht über 1.5G Spitze, 5~500Hz. Betriebsvibration sollte nicht höher als 0.75G Spitze, 5~500Hz, 3 planes. Nach dem Test keine Änderung der elektrischen Eigenschaften. Page (4) (Preliminary datasheet) All rights reserved. Version 3.2.2, 23th February 2016 Product data sheet PS-LEDP85-C LED-Netzteil | LED-Driver | LED-Control-Gear: 85 Watt (200 ~ 1.500mA / 24 ~ 55Vdc ) | CC Technical data Connector CN1 250-405 WAGO CN1-1 L (100 ~ 240 Vac) / +150 ~ 300 Vdc CN1-2 N.C. CN1-3 N (100 ~ 240 Vac) / - 150 ~ 300 Vdc CN1-4 N.C. CN1-5 N.C. Connector CN2 250-404 WAGO CN2-1 LED+ (55 Vdc) CN2-2 LED+ (55 Vdc) CN2-3 LED- CN2-4 LED- Connector CN3 53398-0371 Molex CN3-1 NTC SET3+4 CN3-2 NTC CN3-3 Fan Set 5 CN3-4 Signal GND CN3-5 Soft start 6 CN3-6 FAN + CN3-7 FAN - 1. 2. 3. 4. Slope adjustable Available August 2013 Fan voltage/speed CN3-3 /CN3-4 adjustable via ext. resistor value Output current rise time is adjustable in a range of 0 ~ 3 sec (optional) Power Systems GmbH &Co KG Tel.: +49 7062 6759 6 www.power-systems.de Page (5) (Preliminary datasheet) All rights reserved. Version 3.2.2, 23th February 2016 Product data sheet PS-LEDP85-C LED-Netzteil | LED-Driver | LED-Control-Gear: 85 Watt (200 ~ 1.500mA / 24 ~ 55Vdc ) | CC Technical data Diagram showing the correspondence between resistor value setting and fan voltage/speed: Diagram showing the different output current patterns of increase based on switch on time (with/without slow start). Switch on time with/without slow start is determined by resistor value settings Power Systems GmbH &Co KG Tel.: +49 7062 6759 6 www.power-systems.de Page (6) (Preliminary datasheet) All rights reserved. Version 3.2.2, 23th February 2016 Product data sheet PS-LEDP85-C LED-Netzteil | LED-Driver | LED-Control-Gear: 85 Watt (200 ~ 1.500mA / 24 ~ 55Vdc ) | CC Wiring diagram Connector CN3 - Settings NTC SET (R1) Ω NTC SET (Temp) °C 2.5K 6.7K 15K 40K TBD TBD TBD TBD FAN SET (R2) Ω Open 87.56K 27.59K 8.45K Fan SET (Volt) Vdc 12 10 8 6 Soft Start (R3) Ω Open 25K 68.1K 150K Soft Start (Time) sec 0 1 2 3 Power Systems GmbH &Co KG Tel.: +49 7062 6759 6 www.power-systems.de Page (7) (Preliminary datasheet) All rights reserved. Version 3.2.2, 23th February 2016 Product data sheet PS-LEDP85-C LED-Netzteil | LED-Driver | LED-Control-Gear: 85 Watt (200 ~ 1.500mA / 24 ~ 55Vdc ) | CC Delivered Accessories • • • • PS-LEDP-Plug 0950 PS-LEDP-Plug 1050 PS-LEDP-Plug 1200 PS-LEDP-Plug 1500 a 1 pcs a 1 pcs a 1 pcs a 1 pcs • • Model: PS-LED-Plug Other Plugs continuously variable between 200 and 1500 mA Accessories Power Systems GmbH &Co KG Tel.: +49 7062 6759 6 www.power-systems.de Page (8) (Preliminary datasheet) All rights reserved. Version 3.2.2, 23th February 2016 Product data sheet PS-LEDP85-C LED-Netzteil | LED-Driver | LED-Control-Gear: 85 Watt (200 ~ 1.500mA / 24 ~ 55Vdc ) | CC Disclaimer Subject to change without prior notice. Please ensure that you have the most recent release. Please find our terms and conditions here: AGB. Contact details Power Systems GmbH & Co.KG Hauptstr. 48 74360 Ilsfeld-Auenstein / Germany Tel.: +49 7062 6759 - 6 Fax: +49 7062 6759 - 800 Email: [email protected] Web: www.Power-Systems.de Commercial register Amtsgericht Stuttgart HRA 104529 Partner liable to unlimited extent Power Systems Verwaltungs GmbH, Ilsfeld General manager Mrs. Andrea Luithle General manager Mr. Holger Dziadek VAT Registration Number (VAT REG NO) DE 234167965 Tax number 65216 / 35600 DIN EN ISO 9001-2008 Regist. No. 454707 QM08, DQS Power Systems GmbH &Co KG Tel.: +49 7062 6759 6 www.power-systems.de Page (9) (Preliminary datasheet) All rights reserved. Version 3.2.2, 23th February 2016