AC-DC Power Supplies VEG120X (120 WATT) (PRELIMINARY INFORMATION) Description: This product is a AC to DC power device for 120W with 19Vdc constant voltage and 6,32A (max.) current. Features: CEC-compliant performance Wide Range AC Input Power factor Correction Output Status LED Indicator Level B EMI Filter Fully enclosed plastic case High efficiency High Quality Temperature & Humidity: Operating Temperature Range: Storage Temperature Range: Humidity Dimensions: 0ºC ~ +40ºC -20ºC ~ +80ºC 95% RH max LxBxH 169.3 x 65.0 x 37.9mm C6 VEG120A-xxx C14 VEG120C-xxx Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specifications are subject to change without notice. Address: Hauptstr. 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Page (1) Version 1.1, 11th December 2012 AC-DC Power Supplies VEG120X (120 WATT) (PRELIMINARY INFORMATION) Electrical Characteristics: Voltage Range Frequency Range AC Current DC Voltage Rated Power Hold Up Time Toleranz Efficiency Over voltage protection Over current protection Short Circzuit protection Rippel & Noise Input Output 90 ~ 264Vac 47 ~ 63Hz 1.5Arms Max. (see table) 120W Max. 20ms @ Full Load/ Vin 115Vac. 5% 85% typ. Full load, Vin 115Vac. Buit-in Buit-in Pulsing mode, auto recovery 1% (20MHz bandwidth) Safety / EMC Specification: Safety Referring Standards EMI UL E199447 cUL CE FCC Clas s B CISPR 22 Clas s B VCCI Clas s B Order Key: Model No. Vout in Vdc Iout in A Pout in W VEG120X-190-AA VEG120X-240-AA 19 24 6.32 5.00 120 120 Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specifications are subject to change without notice. Address: Hauptstr. 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Page (2) Version 1.1, 11th December 2012 AC-DC Power Supplies VEG120X (120 WATT) (PRELIMINARY INFORMATION) Reliability: MTBF: When the power supply is operating within the limits of this specification the MTBF shall be at least 100,000 hours at 25ºC. Burn In: The power supply shall undergo a minimum 4 hours burn- in test at 40ºC ±5ºC under rated current. Output Terminal: Note1: Ripple/Noise tested by dc-loading side parallel with a 10uF/E-Cap & 0.1uF/C-Cap and measured band-width DC-20MHz. Power Systems – The Power Solution Web: Email: www.Power-Systems.de [email protected] All specifications are subject to change without notice. Address: Hauptstr. 48 ; 74360 Ilsfeld-Auenstein / Germany Tel. : + 49 / 70 62 / 67 59 - 6 Fax: + 49 / 70 62 / 67 59 - 800 Page (3) Version 1.1, 11th December 2012