Rev. 7/10 0.1 TO 6.0 GHz ANALOG DETECTOR DAQ6101 DAQ6101 Typical Values @ +25 °C Wide Frequency Range. . . . . . . . . . . . . . . . . . . . . . . . . Wide Power Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . Temperature Stability . . . . . . . . . . . . . . . . . . . . . . . . . . Flatness . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Low VSWR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Single or Dual Power Supply Cougar Q Package 0.1 to 8.0 GHz –30.0 to +5.0 dBm ± 0.25 dB ± 0.5 dB 1.5:1 DAQ6101 SM-25 for Detectors SPECIFICATIONS* Parameter Typical Frequency (Min.) Guaranteed 0 to 50 °C -55 to +85 °C 0.1-8.0 GHz 0.1-6.0 GHz 0.1-6.0 GHz -30 to +5 dBm -25 to 0 dBm -25 to 0 dBm 1.5:1† 2.0:1† 2.0:1† 120 mV† 90 mV† 90 mV† Power Flatness (Max.) ±0.5 dB^ ±0.75 dB^ ±0.75 dB^ Temperature Stability (Max.) ±0.25 dB† ±0.5 dB† ±0.5 dB† Output Offset Voltage, no RF (Max.) ±0.5 mV ±2.0 mV ±2.0 mV 1 dB Square Law Departure -10 dBm — — Tangential Sensitivity -45 dBm^^ — — Pulse Response, Pin = -15 dBm 1.5 µsec‡ — — Input Power Range (Min.) VSWR (Max.) Sensitivity, Vout (Min.) 3.0 µsec‡ — — Supply Current, no RF Pulse Response, Pin = 0 dBm 2 +mA, 2 -mA — — Supply Current, Pin = +5 dBm 10 +mA, 2 -mA DAS6101 * Measured in a 50-Ohm system at ±5 Vdc, 2 KΩ||50 pF unless otherwise specified. † Pin = –15 dBm. ^ Vout = 100 mV. ^^ 3 dB NF, 1 MHz Bandwidth. ‡ 50% RF to 10 or 90% Video. SMTO-8 Package for Detectors MAXIMUM RATINGS DC Voltage (no RF) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±18 V Continuous RF Input Power . . . . . . . . . . . . . . . . . . . . . +14.0 dBm (±5 Vdc) Operating Case Temperature . . . . . . . . . . . . . . . . . . . . -55 °C to +100 °C Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . -65 °C to +125 °C Burn-In Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . +100 °C Detector Thermal Resistance1 (θjc) . . . . . . . . . . . . . . . +3500 °C/Watt Temperature Rise @ 0 dBm (Tjc) . . . . . . . . . . . . . . . . . +3.5 °C Temperature Rise @ +5 dBm (Tjc) . . . . . . . . . . . . . . . . +35 °C 1 Thermal resistance is based on RF input power. Ratings based on +25 °C. APPLICATION NOTES This unit is DC coupled and employs a RF choke at the input (DC short). If the application calls for the input to sink current there will approximately be an additional 1 mV of output offset voltage for each 3 mA of current. Sink current should be limited to 100 mA max to avoid choke burnout. For higher supply voltages, up to ±15 volts, the positive supply pin must include a series current limiting resistor, Rs = (Vs – 5)/0.01. (e.g.: Vs = 15v, Rs = 1K) Average power detection is obtained at power levels below approximately –13 dBm. For best pulse response both supply pins should be bypassed with an additional 1.0 µF capacitor. The unit contains 0.01 µF internal capacitors. DIMENSIONS ARE IN INCHES [MILLIMETERS] 650-691-9800 • Fax: 650-962-6845 • Updates: www.teledynemicrowave.com • [email protected] DAQ6101 TYPICAL PERFORMANCE Input Flatness @ Vo = 100 mV KEY: +25 C +85 C -55 C INPUT POWER -13.0 -14.0 -15.0 -16.0 -17.0 0.1 0.6 1.1 1.6 2.1 2.6 3.1 3.6 FREQUENCY - GHz 4.1 4.6 5.1 5.6 6.1 Input Flatness @ Vo = 1.0 V INPUT POWER -1.0 -2.0 Pulse Response @ Pin = 0 dBm -3.0 -4.0 -5.0 0.1 0.6 1.1 1.6 2.1 2.6 3.1 3.6 FREQUENCY - GHz 4.1 4.6 5.1 5.6 6.1 4.1 4.6 5.1 5.6 6.1 Input Flatness @ Vo = 3.0 V INPUT POWER 7.0 6.0 5.0 4.0 3.0 0.1 0.6 1.1 1.6 2.1 2.6 3.1 3.6 FREQUENCY - GHz Input VSWR @ Pin = -15 dBm 2.00 Pulse Response @ Pin = –15 dBm VSWR 1.75 1.50 1.25 1.00 0.1 0.6 1.1 1.6 2.1 2.6 3.1 3.6 FREQUENCY - GHz 4.1 4.6 5.1 5.6 6.1 Transfer Curve @ 1.0 GHz 10.0 OUTPUT VOLTAGE - VOLTS 1.0 0.1 0.01 0.001 0.0001 -50 -40 -30 -20 -10 INPUT POWER - dBm 0 10 20 650-691-9800 • Fax: 650-962-6845 • Updates: www.teledynemicrowave.com • [email protected]