The following document contains information on Cypress products. S6E2DF Series 32-bit Microcontroller FM4 Family Fact Sheet ® As part of Spansion’s FM4 Family this new Cortex -M4 based microcontroller series incorporates a dedicated hardware graphics engine that allows rich display images with a cost-effective single-chip solution. Ideal for embedded applications with TFT HMIs such as home appliances, multi-function printers, industrial equipment, electronic musical instruments, security systems, and similar. The graphics engine and 512 KB of video RAM allow complex image overlap, mirroring, scaling, and image movement with very little CPU overhead. Previously this type of sophisticated graphics was possible only with multi-chip solutions costing much more. The Spansion solution comes complete with graphics authoring tools and low level libraries for the graphics engine. 1. − − − − − − − − − − − − − − − − − − − − FEATURES ARM Cortex-M4F CPU Core Processor version： r0p1 FPU built-in, Support DSP instruction Clock Maximum clock frequency： 160 MHz Graphics Display Controller (GDC) 2 Dimensional accelerator blit engine Parallel RGB interface TM HyperBus interface Quad-SPI interface SDRAM interface 512 Kbyte on-chip VRAM Optional 2 Mbyte VFlash for storing images Multi-function Timer：1 unit (Max.) 16-bit free-run timer ×3 channels/unit Input capture ×4 channels/unit Output compare ×6 channels/unit A/D activation compare ×6 channels/unit Waveform generator ×3 channels/unit 16-bit PPG timer ×3 channels/unit Quadrature Position Counter (QPRC)：1 channel Dual Timer：1 unit Watchdog Timer： 1 channel (SW) + 1 channel (HW) Multi-function Serial Interface：8 channels (Max.) 2 Selectable from UART/SPI/LIN/I C Real Time Clock： 1 unit DMA Controller： 8 channels Descriptor System Transfer Controller (DSTC)： 128 channels USB 2.0 FS (Device/Host)： 1 unit SD card Interface： 1 unit 2 I S： 2 units External Interrupt Controller Unit External interrupt input pin： Max. 16 pins Include one non-maskable interrupt (NMI) 12-bit A/D Converter： Max. 24 channels (2 units) Low Power Consumption Mode Sleep mode/Timer mode/RTC mode/Stop mode/Deep standby RTC mode/Deep standby stop mode supported Publication Number S6E2DF_NP709-00017 ® − − − − General Purpose I/O Port S6E2DF5G： 98 (Max.) 154 (Max.) S6E2DF5J： Built-in 100 kHz and 4 MHz CR oscillators Unique ID Low Voltage Detector Clock Supervisor Debug Serial Wire JTAG Debug Port (SWJ-DP) Embedded Trace Macrocells (ETM) Power Supply： 2.7 to 3.6 V Base Timer： 16 channels (Max.) Watch counter Programmable CRC accelerator 2. PRODUCT LINEUP Part number S6E2DF5 G0A/J0A S6E2DF5 GAA/JAA S6E2DF5 GJA VRAM (for GDC) 512 Kbytes 384 Kbytes 512 Kbytes VFlash (for GDC) ― ― 2 Mbytes Parameter 3. SRAM 36 Kbytes Flash 384 Kbytes ORDERING INFORMATION Package Part number S6E2DF5G0AMV20000 Plastic・LQFP (0.5 mm pitch), S6E2DF5GAAMV20000 120 pin (FPT-120P-M21) S6E2DF5J0AGV20000 Plastic・LQFP (0.5 mm S6E2DF5JAAGV20000 pitch), S6E2DF5G0AGB10000 Plastic・BGA (0.5 mm pitch), 176 pin (FPT-176P-M07) 161 pin (FDJ161) Revision 1.1 ® Issue Date February 19, 2015 Copyright © 2015 Spansion All rights reserved. Spansion , the Spansion logo, MirrorBit , Easy DesignSim™, Traveo™and combinations thereof, are trademarks and registered trademarks of Spansion LLC in the United States and other countries. Other names used are for informational purposes only and may be trademarks of their respective owners. F a c t 4. S h e e BLOCK DIAGRAM ARM and Cortex are the registered trademarks of ARM Limited in the EU and other countries. 2 S6E2DF_NP709-00017-1v1-E, February 19, 2015