Rev. 6/12 2.0 TO 20.0 GHz COUGAR MIXERPAK TRIPLE-BALANCED MIXER MMP20294 MMP20294 Typical Values LO & RF . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . IF . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Third Order I.P.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Conversion Loss . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LO Drive (nominal) . . . . . . . . . . . . . . . . . . . . . . . . . . . . Cougar MixerPak - Seam Sealed Hermetic Package MMP20294 2.0 - 20.0 GHz 0.001 - 12.0 GHz +18.0 dBm 8.0 dB +19.0 dBm Cougar MixerPak SPECIFICATIONS* Parameter Port Frequency (GHz) Typ. (dB) Guaranteed -55 to +85 °C Max. (dB) SSB Conversion Loss and SSB Noise Figure fR fL fI fR fL fI fI 2.0 to 10.0 2.0 to 10.0 0.001 to 7.0 10.0 to 20.0 10.0 to 20.0 0.001 to 7.0 7.0 to 12.0 8.0 8.0 8.0 9.5 9.5 9.5 10.5 10.0 10.0 10.0 11.0 11.0 11.0 12.0 Conversion Comp. Desensitization fR fR2 Level = +2 dBm Level = 0 dBm – – 1.0 1.0 Typ. (dB) Min. (dB) DIMENSIONS ARE IN INCHES [MILLIMETERS] Harmonic Intermodulation Products (single tone) fL fL fR 2.0 to 10.0 2.0 to 10.0 2.0 to 10.0 20 22 30 15 19 19 fL at R fL at I fR at I fL fL fR 10.0 to 20.0 10.0 to 20.0 10.0 to 20.0 25 25 30 19 19 20 Third Order Intercept LO = +19 dBm LO = +21 dBm +18 dBm +18 dBm 5 HARMONICS OF f R Isolation fL at R fL at I fR at I 4 3 2 1 95 94 93 92 72 71 49 48 18 18 94 94 94 94 87 83 54 54 0 0 -12 -12 0 1 0 — — 95 95 93 91 70 68 72 63 37 36 -11 -11 95 95 96 96 82 82 54 54 12 13 5 6 96 97 97 97 73 71 54 54 47 46 9 10 2 3 4 HARMONICS OF f L FR == 2000 MHz @ -10 dBm FLL == 2030 2030 MHz MHz R 2000 MHz @ -10 dBm FLL @ @ +19 +13dBm dBm FL @ @ +22 +16dBm dBm * Measured in a 50-ohm system with nominal LO drive of +19 dBm as a downconverter. 98 98 96 94 95 95 54 54 34 35 5 6 5 Harmonic Intermodulation Products (single tone) ABSOLUTE MAXIMUM RATINGS Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . -65 to +150 °C Peak RF Input Power All Ports . . . . . . . . . . . . . . . . . . . +27 dBm @ 25 °C derate to +18 dBm @ 100 °C HARMONICS OF f R 5 4 3 2 1 90 90 90 90 84 85 55 59 22 22 91 91 92 92 77 77 58 56 0 0 -15 -12 0 1 0 93 93 93 92 86 87 57 59 35 33 -7 0 92 93 93 93 83 89 57 57 13 16 0 3 95 96 98 98 93 83 57 66 32 32 0 6 2 3 4 HARMONICS OF f L FFRR ==4000 FFLL == 4030 4000MHz MHz@@-10 -10dBm dBm 4030MHz MHz @+19 +13dBm dBm @+22 +16dBm dBm FFLL @ FFLL @ 650-691-9800 • Fax: 650-962-6845 • Updates: www.teledynemicrowave.com • [email protected] 98 98 94 94 80 82 58 55 19 23 0 2 5 MMP20294 TYPICAL PERFORMANCE 3 CONVERSION LOSS - dB Conversion Loss vs LO Drive Level Isolation (L to I) vs Frequency1 F L at +19 dBm 30 25 20 15 2 4 5 6 7 8 9 10 11 12 FREQUENCY - GHz 13 14 16 18 ISOLATION - dB 35 F L at +19 dBm 25 20 15 2 4 5 6 7 8 9 10 11 12 FREQUENCY - GHz -12 F L = 12.03 GHz, Hi-Side LO F I = 30 MHz -16 -20 The minimum recommended drive level is +10 dBm. The maximum recommended drive level is +29 dBm. -24 4 13 14 16 18 20 8 10 24 26 28 18 20 18 20 -7 -8 -9 -10 4 6 8 10 11 12 13 14 FREQUENCY - GHz 15 16 Conversion Loss vs RF Frequency -30 -40 -50 2 4 6 7 8 9 10 11 12 FREQUENCY - GHz 13 14 16 18 20 CONVERSION LOSS - dB -20 1 3 F L at +22 dBm -6 -7 -8 -9 -10 -11 2 4 6 8 1Level of the f signal fed through to the R- and I-ports with respect to the level of the f signal L L FREQUENCY L-Port VSWR vs Frequency 2 3 2 1 4 5 6 7 8 9 10 11 12 FREQUENCY - GHz 13 14 16 18 20 INPUT POWER - dBm F L at +19 dBm 4 F L = 12.0 GHz at +19 dBm 2 1 2 4 6 7 8 9 10 11 12 FREQUENCY - GHz 13 14 16 18 20 2 0 IF = 30 MHz, Hi-Side LO -2 4 6 8 2 F L = 2.0 GHz at +19 dBm 1 1 2 3 4 5 6 7 8 9 FREQUENCY - GHz 10 11 12 13 14 2 VSWR of the I- and R-ports in a 50-ohm system. Some variation in the R-port VSWR will occur as a function of the L-port frequency as shown above. 10 11 12 13 14 FREQUENCY - GHz 15 16 18 20 Relative IF Response 0 At LO= +19 dBm -2 -4 F L = 6.0 GHz, Low-Side LO -6 0 0.5 1 2 4 6 7 8 9 IF FREQUENCY - GHz At LO= +22 dBm 10 11 12 13 Intercept Point I-Port VSWR vs Frequency 2 INTERCEPT POINT - dBm 3 GHz +19 dBm LO +22 dBm LO 4 2 REL IF RESPONSE- dB R-Port VSWR vs Frequency 2 4 3 16 6 3 1 15 Power Input at 1 dB Compression 5 2 10 11 12 13 14 FREQUENCY - GHz 3Conversion loss of the mixer when used in an SSB system. The frequency ordinate refers to the R-port (fR) with fI at 30 MHz. at the L-port. VSWR 22 -5 F I = 12 GHz @ +19 dBm -60 VSWR 14 16 18 20 LO DRIVE - dBm F L at +19 dBm -6 Isolation (R to I) vs Frequency VSWR 12 -5 2 -10 ISOLATION - dB 6 Conversion Loss vs RF Frequency 3 Isolation (L to R) vs Frequency1 30 -8 20 CONVERSION LOSS - dB ISOLATION - dB 35 -4 60 I F = 30 MHz RF= –10 dBm Hi-Side LO 50 +19 dBm LO +22 dBm LO 40 IP2 30 20 IP3 10 2 4 6 8 10 11 12 13 14 FREQUENCY - GHz 15 650-691-9800 • Fax: 650-962-6845 • Updates: www.teledynemicrowave.com • [email protected] 16 18 20