Download PDF

superCLIP
superGRIPTMTM
INSTALLATION GUIDE
For all maxiFLOWTM and Straight Fin
superGRIPTM Assemblies
1
Place FC around two corners of
the component. FC will bend
slightly at the “horseshoe” tab.
Note the direction of air flow
when placing your HS.
4
2
Press opposite end of the FC
down until it is secure around
the component’s edges. 5
3
To ensure a secure fit, push
spread apart FC slightly at the
“horseshoe” tabs while pressing down.
6
HEAT SINK (HS)
Place HS over the installed FC
so that the “horseshoe” tabs
of the FC fit within the HS’
notches.
SPRING CLIP (SC)
FRAME CLIP (FC)
7
United States
89-27 Access Road
Norwood, MA 02062
T: 781.769.2800
F: 781.769.9979
[email protected]
www.qats.com
Place spring clip within the HS’
fin field as shown. The ends of
the SC will fit over the “horseshoe” tabs.
8
Push opposite end of the SC
down over the FC with a small
screwdriver until it fits securely
on the assembly.
9
Europe
De Nieuwe Vaart 50
1401 GS Bussum
The Netherlands
T: +31 (0) 3569 84715
F: +31 (0) 3569 21294
www.qats-europe.com
Shown above the is the HS,
FC and SC assembly properly
seated over the component.
To remove, place a small flathead screwdriver between the
spring clip and the frame clip
and pry the spring clip away
from the frame.
Remove the FC by placeing a
small screwdriver within the
“horseshoe” tab and gently
twisting in either direction to
pull the frame clip away from
the component.
Advanced Thermal Solutions is a leading engineering and manufacturing company
supplying complete thermal and mechanical packaging solutions from analysis and
testing to final production. ATS provides a wide range of air and liquid cooling solutions, laboratory-quality thermal instrumentation, along with thermal design consulting
services and training. For more information about Advanced Thermal Solutions, Inc.,
please visit www.qats.com or call 781-769- 2800.
REV2_090209
Similar pages