Suggested settings for WMBUS T mode - Measurements were done on 6 CC1125 EMs @ 40MHz The sensitivity measurements are done with a 3 byte package. 20% PER equals 1% BER. The PER vs level measurements are done with a 30byte package, 50 packages are sent pr level. Operating conditions are 2.0V -3.6V, 3.0V typical, -40° - 85°, 25° typical. Settings SYNC3 SYNC2 SYNC1 SYNC0 SYNC_CFG1 SYNC_CFG0 DEVIATION_M MODCFG_DEV_E DCFILT_CFG PREAMBLE_CFG1 PREAMBLE_CFG0 FREQ_IF_CFG IQIC CHAN_BW MDMCFG1 MDMCFG0 DRATE2 DRATE1 DRATE0 AGC_REF AGC_CS_THR AGC_GAIN_ADJUST AGC_CFG3 AGC_CFG2 AGC_CFG1 AGC_CFG0 PA_CFG2 PA_CFG1 PA_CFG0 IF_MIX_CFG FREQOFF_CFG TOC_CFG SOFT_TX_DATA_CFG AA AA A4 3D 9 B 47 6 C 18 17 0 0 1 C6 5 A4 7A E1 40 FD 0 3 20 A9 C0 7F 56 78 0 20 CB 0 Results Sensitivity: Typical over operating corners: -103.2 @ 88kbps (-12% datarate tolerance) -103.2 @ 100kbps (nominal datarate) -102.3 @ 112kbps (12% datarate tolerance) PER vs level: Typ over operating corners 120.0 100.0 80.0 60.0 40.0 20.0 PER vs level for 88kbps -2.0 -6.0 -10.0 -14.0 -18.0 -22.0 -26.0 -30.0 -34.0 -38.0 -42.0 -46.0 -50.0 -54.0 -58.0 -62.0 -66.0 -70.0 -74.0 -78.0 -82.0 -86.0 -90.0 -94.0 -98.0 -102.0 -106.0 -110.0 0.0 PER vs level for 112kbps -6.0 -2.0 -6.0 -2.0 -30.0 -34.0 -38.0 -42.0 -46.0 -50.0 -54.0 -58.0 -62.0 -66.0 -70.0 -74.0 -78.0 -82.0 -86.0 -90.0 -94.0 -98.0 -102.0 -106.0 -110.0 -10.0 0.0 -10.0 20.0 -14.0 40.0 -18.0 60.0 -14.0 80.0 -18.0 100.0 -22.0 120.0 -22.0 Typ over operating conditions -26.0 PER vs level for 100kbps -26.0 -30.0 -34.0 -38.0 -42.0 -46.0 -50.0 -54.0 -58.0 -62.0 -66.0 -70.0 -74.0 -78.0 -82.0 -86.0 -90.0 -94.0 -98.0 -102.0 -106.0 -110.0 Typ over operation conditions 120.0 100.0 80.0 60.0 40.0 20.0 0.0