Datasheet

D-TYPE ACTIVE MODULE
E5771-01
for 28 mm Side-on PMT
The E5771-01 is a voltage divider to operate a 28 mm Side-on photomultiplier tube. The compact configuration is convenient to attach directly on tracing circuit board. Additionally, the built-in circuit utilizes
transistor devices in the final three stages, so that the E5771-01 can
give superior DC linearity characteristic under a low power consumption.
SPECIFICATIONS
Parameter
Description / Value Unit
28 mm Side-on type —
Applicable PMT
1500
V
Max. Supply Voltage between Case and Pins
V
1500
Max. Supply Voltage between Pin#1 and #11
mA
0.29
Max. Divider Current between Pin#1 and #11
0.44 (at 1500 V)
W
Max. Power Consumption Between Pin#1 and #11
Ω
1 × 1011
Insulation Resistance between Case and Pins Min.
Voltage Distribution Ratio among Pin#1 to #11
1: 1: 1: ...... : 1: 1: 1 —
100
µA
Max. Linear Output in DC Mode
Typ.
Operating Temperature
-20 to +50
°C
Figure 2: Maximum Output under ±1 %
DC Linearity of E5771-01
Figure 1: DC Linearity of E5771-01
TACCB0051EC
(In the case of R928 with negative high voltage usage)
TACCB0053EB
20
E5771-01
ANODE OUTPUT CURRENT (A)
DEVIATION (%)
CONVENTIONAL D-TYPE
: SUPPLY VOLTAGE = -1000 V
10
E5771-01
: SUPPLY VOLTAGE = -300 V
0
E5771-01
: SUPPLY VOLTAGE = -1000 V
-10
10-7
(In the case of R928 with negative high voltage usage)
10-3
10-6
10-5
10-4
OUTPUT ANODE CURRENT (A)
10-3
10-4
10-5
CONVENTIONAL D-TYPE
10-6
10-7
-300 -400 -500 -600 -700 -800 -900 -1000 -1100 -1200 -1300
SUPPLY VOLTAGE (V)
Subject to local technical requirements and regulations, availability of products included in this promotional material may vary. Please consult with our sales office.
Information furnished by HAMAMATSU is believed to be reliable. However, no responsibility is assumed for possible inaccuracies or omissions. Specifications are
subject to change without notice. No patent rights are granted to any of the circuits described herein. ©2011 Hamamatsu Photonics K.K.
D-TYPE ACTIVE MODULE E5771-01
Figure 3: Dimensional Outline and Circuit Diagram
of E5771-01 (Unit: mm)
Figure 4: The Example of Completed Divider Circuit
with E5771-01
(TOP VIEW)
1 2
3
11
HAMAMATSU
4
10
E5771-01
9
5
8 7 6
+0.8
15 -0.2
LEAD
PINS
2
3
4
5
6
7
9
8
10
11
〈 FOR –HV〉
DY1 DY2 DY3 DY4 DY5 DY6 DY7 DY8 DY9
-HV
*A
*A
MARK OF
PIN #1
PIN # 1
2
510 kΩ 510 kΩ 510 kΩ 510 kΩ 510 kΩ 510 kΩ
2
5
6
8
7
E5771-01
10
11
0.01 µF 0.022 µF 0.047 µF
TRANSISTOR
CIRCUIT
E5771-01
0.8
(PCD = 12.2)
9
〈 FOR +HV〉
*A
30°
DY1 DY2 DY3 DY4 DY5 DY6 DY7 DY8 DY9
(BOTTOM VIEW)
SIGNAL
OUTPUT
*A
*A
2
3
4
5
6
7
8
9
10
11
*A
+HV
11
10
9
7
*A
P
PMT
K
1
3
4
5
6
4
510 kΩ 510 kΩ 510 kΩ 510 kΩ 510 kΩ 510 kΩ
PIN # 1
*PIN #
3
TRANSISTOR
CIRCUIT
0.4
12.2
SIGNAL
OUTPUT
P
PMT
K
0.01 µF 0.022 µF 0.047 µF
10 ± 1 12.5 ± 0.5
PLASTIC
CASE
(UL 94V-0)
PIN # 1
510 kΩ 510 kΩ 510 kΩ 510 kΩ 510 kΩ 510 kΩ
8
SUGGESTED PRINTED CIRCUIT BOARD
LAYOUT FOR E5771-01
E5771-01
0.01 µF 0.022 µF 0.047 µF
TRANSISTOR
CIRCUIT
*A: To be installed outside E5771-01
TACCA0180EC
TACCC0108EB
Figure 5: The Example of How to Use
SOLDERING
E5771-01
TRACING CIRCUIT BOARD (TO BE FURNISHD BY USER)
DIRECTLY MOUNTABLE SOCKET
TO TRACING CIRCUIT BOARD
28 mm (1-1/8") SIDE ON PMT TYPE; E678-11M
SOCKET PINS
SOCKET
PMT
TACCC112EB
CAUTION
• When getting output anode current over operating area shown at Figure 2, there may be a sudden change in output.
It would be caused by divider current but not lead E5771-01 to break down.
• When supplying high voltage with opposite polarity by mis-handling in connection with E5771-01 mounted on a printed circuit board, it might
lead an internal damage in E5771-01.
Therefore, please take care to see the polarity of high voltage and correct electro-connections before operation.
• Also, if short-circuit should be produced by mistake or something among pin#1 to #11 in operation, it may lead an internal Damage in
E5771-01.
• The specifications described herein are subject to change without notice.
HAMAMATSU PHOTONICS K.K.
www.hamamatsu.com
HAMAMATSU PHOTONICS K.K., Electron Tube Division
314-5, Shimokanzo, Iwata City, Shizuoka Pref., 438-0193, Japan, Telephone: (81)539/62-5248, Fax: (81)539/62-2205
U.S.A.: Hamamatsu Corporation: 360 Foothill Road, P. O. Box 6910, Bridgewater. N.J. 08807-0910, U.S.A., Telephone: (1)908-231-0960, Fax: (1)908-231-1218 E-mail: [email protected]
Germany: Hamamatsu Photonics Deutschland GmbH: Arzbergerstr. 10, D-82211 Herrsching am Ammersee, Germany, Telephone: (49)8152-375-0, Fax: (49)8152-2658 E-mail: [email protected]
France: Hamamatsu Photonics France S.A.R.L.: 19, Rue du Saule Trapu, Parc du Moulin de Massy, 91882 Massy Cedex, France, Telephone: (33)1 69 53 71 00, Fax: (33)1 69 53 71 10 E-mail: [email protected]
United Kingdom: Hamamatsu Photonics UK Limited: 2 Howard Court, 10 Tewin Road Welwyn Garden City Hertfordshire AL7 1BW, United Kingdom, Telephone: 44-(0)1707-294888, Fax: 44(0)1707-325777 E-mail: [email protected]
North Europe: Hamamatsu Photonics Norden AB: Smidesvägen 12, SE-171-41 SOLNA, Sweden, Telephone: (46)8-509-031-00, Fax: (46)8-509-031-01 E-mail: [email protected]
TACC1050E01
Italy: Hamamatsu Photonics Italia: S.R.L.: Strada della Moia, 1/E, 20020 Arese, (Milano), Italy, Telephone: (39)02-935 81 733, Fax: (39)02-935 81 741 E-mail: [email protected]
OCT. 2011. IP
Similar pages