CY8CKIT-043 PSOC® 4 M-SERIES PROTOTYPING KIT QUICK START GUIDE KitProg Programmer and Debugger P0_1 P0_0 P3_6 P3_5 P3_4 P3_0 GND PSoC® 4 M-Series GND VDDA EZ-BLE TX ->/P3_0 EZ-BLE RX <-/P3_1 P3_2 P3_3 P3_4 P3_5 P3_6 P3_7 I2C SCL/P4_0 I2C SDA/P4_1 *CMOD/P4_2 *CTANK/P4_3 P4_4 P4_5 P4_6 KitProg TX ->/P7_0 KitProg RX <-/P7_1 P0_0 P0_1 P0_2 P0_3 *WCO IN/P0_4 *WCO OUT/P0_5 P0_6 SW1/P0_7 GND VDDD Note: * An external capacitor is connected to this pin. P12_7/UART TX P12_6/UART RX P12_1/I2C SDA P12_0/I2C SCL P12_5 GND VBUS VDDIO GND P6_5 P6_4 P6_2 P6_1 P6_0 P2_7 P2_6 P2_5 P2_4 P2_3 P2_2 P2_1 P2_0 P1_7/SAR BYPASS* P1_6/LED1 P1_5 P1_4 P1_3 P1_2 P1_1 P1_0 P5_5 P5_3 P5_2 P5_1 P5_0 RESET 1 • Connect the board to your computer using the USB connector 2 • Amber LED indicates power on • Green LED indicates status • Blue LED glows with breathing effect 3 For more information on the kit, please go to the following web page: www.cypress.com/CY8CKIT-043 Thank you for supporting PSOC! © 2015 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. 001-97739 Rev.** Design the way you think!