Datasheet

Part No: 20625 - A1 Series
Tilt Switch - Mercury
Features:
* Un-Insulated
* Form: NO/NC/SPST/Mount dependent
* Angles Referenced from Horizontal
* Single Electrode
* Hermetically Sealed
* Small Package Size
* Extremely Narrow Included Angle
* High Current Capability
* Low Contact Resistance
* Long Life
Drawing dimensions in millimeters.
Tilt switches “make” when the electrode is tilted below horizontal and
“break” when tilted above the horizontal. Total travel from “make” to
“break” is the “Maximum included angle” shown below. The
component to which the switch is attached must have a total tilt angle
greater than the “Maximum included angle” for proper operation.
Must Break Angle * :
Maximum included Angle:
+ 0.7º
1.4º
* Make/break angles are electrode + (above) / - (below) 0° horizontal
reference
Switch Ratings:
Max Switching Voltage
Max Switching Current
Initial Contact Resistance (Max).
Stand Off Voltage (contact to contact)
Operating Temperature
Storage Temperature
Typical number of operations at specified load
G-Force Activation G-Level/Range
Dimensions:
Weight per 100pcs. Lbs / Kgs:
Body Length (less leads). Inches / Millimeters:
Maximum Diameter. Inches / Millimeters:
Materials:
Lead Wire Type
Lead wire length/skive/termination
Finish:
© American Electronic Components Inc 2006
Specifications are subject to change without notice. E&OE.
240V
120VAC / 1A, 240VAC / 0.7A : 120VDC / 0.5A,
240VDC / 0.4A : Tungsten 240V / 100W
50 milli Ohms
1500 VAC
-38º to 220ºF / -38º to 105ºC
-40º to 356ºF / -40º to 180º C
10,000,000
N/A
1.10 / 0.50
0.71 / 18.05
0.39 / 9.98
N/A
N/A
Tin
American Electronic Components Inc.,
1101 Lafayette Street, Elkhart, Indiana. USA
Tel: +1-574-295-6330 Fax: +1-574-293-8013
Email: [email protected]
http://www.aecsensors.com
20625 110706
Similar pages