LM2595ADPBCKGEVB_TEST_PROCEDURE.PDF

REGULATED DC
SUPPLY
ELECTRONIC
LOAD
Test Procedure for the LM2595ADPBCKGEVB
Figure 1: Test Setup
Test Procedure:
1. Connect the test setup as shown in Figure 1.
2. Apply an input voltage, Vcc = 24 V
3. Apply Iout = 0 mA load.
4. Check that Vout is 5.0 V
5. Increate Iout load to 1 A
6. Check that Vout is 5.0 V
7. Power down the load
8. Power down Vcc
9. End of test

Open as PDF

Similar pages: NCP3063DIPBSTEVB_TEST_PROCEDURE.PDF - 88.0 KB; NCP3063DIPINVEVB_TEST_PROCEDURE.PDF - 96.0 KB; NCP3063SMDBCKEVB_TEST_PROCEDURE.PDF - 107.0 KB; NCP3064PDBCKGEVB_TEST_PROCEDURE.PDF - 301.0 KB; LM2595ADPBCKGEVB_BOM_ROHS.PDF - 44.0 KB; NCP3064DFBCKGEVB_TEST_PROCEDURE.PDF - 152.0 KB; LM2595ATPBCKGEVB_TEST_PROCEDURE.PDF - 364.0 KB; LM2594ASCBCKGEVB_TEST_PROCEDURE.PDF - 95.0 KB; LM2594APDBCKGEVB_TEST_PROCEDURE.PDF - 165.0 KB; NCP1060FLBKGEVB Test Procedure; NCP1060BUCKGEVB Test Procedure; LM2595ADPBCKGEVB_SCHEMATIC.PDF - 23.0 KB; NCP1063BUCKGEVB_TEST_PROCEDURE.pdf - 101 KB; NCP3063SMDBSTEVB_TEST_PROCEDURE.PDF - 305.0 KB; LA5744TPGEVB_TEST_PROCEDURE.PDF - 382.0 KB; NCP4354AADAPGEVB_TEST_PROCEDURE.PDF - 83.0 KB; 40WLEDBULBGEVB Test Procedure

LM2595ADPBCKGEVB_TEST_PROCEDURE.PDF - 398.0 KB