Test Procedure for the LV8402GPEVB Evaluation Board Two DC Motor Driver: LV8402GP (57.0 mm × 57.0 mm × 1.6 mm, glass epoxy 2-layer board) One Stepper Motor Driver: 1/8/2014 1 www.onsemi.com Supply Voltage: • VCC (2.8 to 5.5V): Control voltage Supply for LSI • VM(1.5 to 15V): Power Supply for LSI • Toggle Switch State: • Upper Side: High (VCC) • Middle: Open, enable to external logic input • Lower Side: Low (GND) Test Procedure for DC Motor Control: 1. Initial Condition Setting: Set the toggle switchs “Open or Low” 2. Motor Connection: Connect the Motor(s) between OUT1 and OUT2. 3. Power Supply: Supply DC voltage to VCC, VM. 4. Charge-pump check: EN1 or EN2 set “H”. Check VG pin voltage. VG=VM+VCC 5. Motor Operation: Set EN1-2, IN1- IN4 terminals according to the purpose (See LV8402GP datasheet). EXTR A H EN1 (EN2) H L L H L IN1 (IN3) H H L L H L - Truth Table IN2 OUT1 (IN4) (OUT3) H Z L L H H L L L L H L OUT2 (OUT4) Z H L L L H L L Charge pump Mode Stand-by Reverse Forward Brake Stand-by Reverse Forward Brake ON OFF ON “-“ : Denotes a don't care value. Z: High-Impedance DC Motor Load VCC = 3V, VM = 6V EN1 = “H”, IN2 = “L” (Current waveform example “brake current”) 1/8/2014 2 www.onsemi.com