Test Procedure for the NV47710PDAJGEVB Evaluation Board Test Procedure: 1. Connect the test setup as shown in Figure 1. See Table 1 with required equipment. - Letter F – Force line - Letter S – Sense line 2. Select output current limit by connecting jumper J5 – J8. - J5 – ILIM0 ~ 10 mA - J6 – ILIM1 ~ 170 mA - J7 – ILIM2 ~ 340 mA - J8 – ILIM3 – RCSO3 position available for individual current limit setting by resistor from range 728 Ω to 25.5 kΩ 3. Set Input Voltage and turn on Power Supply. 4. Enable chip by connecting external Voltage Source on jumper J3. Output voltage must be higher than 2.31 V but maximally 7 V. 5. Set load current (max 350 mA) and turn on Load. 6. Monitor Output voltage, it’s given according to Equation 1. (eq. 1) 7. Monitor CSO voltage on connector J4. It should be max 2.55 V in steady state. The CSO voltage is proportional to output current according to Equation 2. (eq. 2) 8. Compare your results with measured results in Table 2. 5/21/2012 -1- www.onsemi.com Power Supply Load A - meter V - meter Voltage Source V - meter Figure 1. Test Setup Table 1: Required Equipment 5/21/2012 Equipment Ranges Power Supply 0 V – 45 V / 500 mA Voltage Source 0V–7V Load 0 mA – 500 mA V - meter 0 V – 20 V A - meter 0 mA – 500 mA -2- www.onsemi.com Figure 2. PCB Layout Table 2: Measured Results Parameter Output Voltage Output Current Test Conditions Vin = 13.5 V, Vout_nom = 5.02 V, Iout = 5 mA, RCSO = Short to ground Vin = 13.5 V, Vout_nom = 5.02 V, Iout = 350 mA, RCSO = Short to ground Vin = 13.5 V, Vout_nom = 5.02 V, Vout = 0 V, RCSO = 25.5 kΩ Vin = 13.5 V, Vout_nom = 5.02 V, Vout = 0 V, RCSO = 1.5 kΩ Vin = 13.5 V, Vout_nom = 5.02 V, Vout = 0 V, RCSO = 750 Ω 5/21/2012 -3- Value Nominal Measured 5.02 Unit 5.03 V 5.02 5.04 10 170 340 10.45 175.6 353 www.onsemi.com mA