Data Sheet No. PD 10063 revB Series PVY117 & PbF Microelectronic Power IC HEXFET® Power MOSFET Photovoltaic Relay Single-Pole, Normally-Open, 0-40V AC/DC, 470mA General Description The PVY117 Series Photovoltaic Relay is a singlepole, normally-open solid-state relay that can replace dry and Mercury-wetted reed relays in many applications. It utilizes International Rectifier’s proprietary HEXFET power MOSFET as the output switch, driven by an integrated circuit photovoltaic generator of novel construction. The output switch is controlled by radiation from a GaAlAs light emitting diode (LED), which is optically isolated from the photovoltaic generator. Features ! ! ! ! ! ! ! Low signal distortion at high frequencies Low Coff * Ron Figure Of Merit High off-state resistance 1,500 VRMS I/O isolation Long operational life Solid-State Reliability ESD Tolerance 2000V Human Body Model The PVY117 is ideally suited for use as matrix relay in low voltage ATE applications and general instrumentation applications involving high frequency test signals. This can be accomplished thanks to the extremely low Figure Of Merit (FOM = Coff * Ron), which is the product of the relay’s off-state output capacitance and on-state resistance. The PVY117 is packaged in a 4-pin, molded small outline package (SOP-4) with surface mount (gull wing) terminals. It is available in plastic shipping tubes or on tape-and-reel. Please refer to Part Identification information. Applications ! Automated Test Equipment ! Instrumentation ! Data Acquisition Part Identification PVY117 & PbF PVY117-T & PbF surface-mount surface-mount, tape-andreel (HEXFET is the registered trademark for International Rectifier’s power MOSFETs) Series PVY117 & PbF Electrical Specifications (-40°C ≤ TA ≤ +85°C unless otherwise specified) INPUT CHARACTERISTICS Units Min Typ Max Minimum control current (see Figure 1) mA 2.0 — — Control current for off-state resistance @TA = +25°C mA — — 0.2 Control current range (caution: current limit input LED, see Figure 8) Reverse voltage mA V 2.0 — — — 20.0 6.0 OUTPUT CHARACTERISTICS Units Min Typ Max Operating voltage range V peak — — 40 Continuous load current @ 40°C, 5mA control (see Figure 1) mA — — 470 Pulsed load current @ 25°C, 5mA control (see Figures 2 and 3) 10ms on, 10% duty cycle mA — — 850 Off-state leakage @ 40V, 25°C, (see Figure 4) nA — 0.05 1.0 On-state resistance @ 5mA control, IL =100mA (see Figures 2 and 3) Ω pF — 0.74 0.95 — 10.1 14.5 Output capacitance Vd=0V, f=1MHz (Cout, see Figure 7) C * R (Cout x RDDon) Turn-on time, 5mA control, 100Ω, 20V (Ton, see Figure 5) 1ms on, 50% duty cycle Turn-off time, 5mA control, 100Ω, 20V (Toff, see Figure 5) 1ms on, 50% duty cycle pF * Ω µS — 7.5 — — 110 200 µS — 30 100 GENERAL CHARACTERISTICS Units Min Typ Max Dielectric strength, Input to Output VRMS 1500 — — Insulation Resistance, Input to Output Ω 1012 — — CI-O (Input to Output Capacitance), Vd = 0V, f = 1MHz pF — 0.8 — Max. pin soldering temperature (10 seconds max.) oC — — +260 Ambient temperature range: Operating oC -40 — +85 Storage oC -40 — +100 International Rectifier does not recommend the use of this product in aerospace, avionics, military or life support applications. Users of this International Rectifier product in such applications assume all risks of such use and indemnify International Rectifier against all damages resulting from such use. 1 4 2 3 Connection Diagram www.irf.com 2 Series PVY117 & PbF 1500.0 500 1000.0 ILED = 5mA Load Current (A) Max Load Current (mA) 600 400 ILED=2mA 300 200 100 500.0 -1.5 -1.0 0.0 -0.5 0.0 -500.0 0.5 1.0 1.5 -1000.0 0 0 20 40 60 80 -1500.0 100 Voltage Drop (VDD) Ambient Temperature (C) Figure 2. Typical On Characteristics 1200 1.0E-06 1000 1.0E-07 800 Leakage Current (A) Load Current (A) Figure 1. Current Derating Curves Pulsed, 25ºC I LED = 5mA 600 25ºC 40ºC 60ºC 85ºC 400 200 0 1.0E-08 40V 1.0E-09 32V 1.0E-10 1.0E-11 1.0E-12 0.0 0.2 0.4 0.6 0.8 1.0 1.2 V DD (Volts) Figure 3. Typical On Characteristics www.irf.com 1.4 20 30 40 50 60 70 80 90 100 Temperature (ºC) Figure 4. Typical Leakage Characteristics 3 Series PVY117 & PbF Delay Time (uS) 1000 Ton Tdly 100 Toff 10 0 5 10 15 ILED (mA) Typical Capacitance (pF) Figure 5. Typical Delay Times Figure 6. Delay Time Definitions 16 14 12 10 8 6 4 2 0 0 5 10 15 20 25 30 35 40 VDD Drain to Drain Voltage Figure 7. Output Capacitance www.irf.com Figure 8. Input Characteristics (Current Controlled) 4 Series PVY117 & PbF Case Outlines - 4 Lead SOP 01-2027 01 IR WORLD HEADQUARTERS: 233 Kansas Street, El Segundo, California 90245 Tel: (310) 252-7105 This product has been designed and qualified for the Industrial Market Data and specifications subject to change without notice. 3/28/2006 www.irf.com 5