CY3217-MINIPROG1KIT QUICK START GUIDE 1 2 Insert the CY3217-MiniProg1 Kit CD into the CD drive of your PC. Remove the CY3217-MiniProg1 from the kit package; plug the USB cable into the USB Mini B connector and connect it to your PC. Install the kit contents, PSoC Designer, and PSoC Programmer. Note: You can download the latest kit related software and documents from www.cypress.com/go/CY3217-MiniProg1. 3 4 Connect the MiniProg1 to the ISSP header on your target PSoC board. Use PSoC Programmer to program hex files on to the PSoC device. You can also use PSoC Programmer to toggle the target power provided by MiniProg1. CY3217-MINIPROG1 KIT QUICK START GUIDE CY3217-MiniProg1 Details Target Power LED ISSP Connector Status LED USB Mini B Connector For the latest information about this kit, visit http://www.cypress.com/go/CY3217-MiniProg1 © 2011 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. DOC#: 001-66480 REV. *A