CY3215A-DK PSoC In-Circuit Emulation (ICE) Lite Development Kit Quick Start Guide

CY3215A-DK PSoC In-Circuit Emulation (ICE) Lite Development Kit
Quick Start Guide
1
2
Install Software
1. Insert the CY3215A-DK CD/DVD into the
CD/DVD drive of your PC.
Use Pod to Debug
1. Attach the flex cable and pod to the
ICE-Cube (ICE base unit).
2. Install the kit contents, PSoC Programmer,
and PSoC Designer.
2. Create a project in PSoC Designer and
start debugging.
Note: After installation, follow instructions
in step 2 to debug using pod kit OR follow
the instructions in steps 3 and 4 to program
PSoC 1 based target board.
Note: Pod Kit needs to be purchased
separately. Visit www.cypress.com/go/
shop to find the latest list of Pods.
3
4
To Program Target Boards
1. Attach the backward compatibility
adapter to the ICE-Cube in the place
of the flex-pod.
3. Connect the 5-pin connector of the ISSP
cable to your PSoC 1 based target
board's ISSP header.
2. Connect the RJ45 end of the ISSP
cable into the adapter.
4. Program the parts using PSoC Programmer.
CY3215A-DK PSoC In-Circuit Emulation (ICE) Lite Development Kit
Quick Start Guide
CY3215A-DK Kit Details
12-V 1-A
Adapter
European
Plug Adapter
USB 2.0 Cable
ICE Base Unit
Backward
Compatibility
Adapter
CY3250
Flex Cable
ISSP Cable
Blue Cat 5e Cable
For assistance, go to http://www.cypress.com/go/support, or contact our customer support at
+1 (800) 541-4736 Ext. 8 (in the USA) or +1 (408) 943-2600 Ext. 8 (International).
For the latest information about this kit, visit
www.cypress.com/go/CY3215A-DK
© 2012 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks
referenced herein are the properties of their respective owners.
Doc.#: 001-80388 Rev. **
Similar pages