CY3215A-DK PSoC In-Circuit Emulation (ICE) Lite Development Kit Quick Start Guide 1 2 Install Software 1. Insert the CY3215A-DK CD/DVD into the CD/DVD drive of your PC. Use Pod to Debug 1. Attach the flex cable and pod to the ICE-Cube (ICE base unit). 2. Install the kit contents, PSoC Programmer, and PSoC Designer. 2. Create a project in PSoC Designer and start debugging. Note: After installation, follow instructions in step 2 to debug using pod kit OR follow the instructions in steps 3 and 4 to program PSoC 1 based target board. Note: Pod Kit needs to be purchased separately. Visit www.cypress.com/go/ shop to find the latest list of Pods. 3 4 To Program Target Boards 1. Attach the backward compatibility adapter to the ICE-Cube in the place of the flex-pod. 3. Connect the 5-pin connector of the ISSP cable to your PSoC 1 based target board's ISSP header. 2. Connect the RJ45 end of the ISSP cable into the adapter. 4. Program the parts using PSoC Programmer. CY3215A-DK PSoC In-Circuit Emulation (ICE) Lite Development Kit Quick Start Guide CY3215A-DK Kit Details 12-V 1-A Adapter European Plug Adapter USB 2.0 Cable ICE Base Unit Backward Compatibility Adapter CY3250 Flex Cable ISSP Cable Blue Cat 5e Cable For assistance, go to http://www.cypress.com/go/support, or contact our customer support at +1 (800) 541-4736 Ext. 8 (in the USA) or +1 (408) 943-2600 Ext. 8 (International). For the latest information about this kit, visit www.cypress.com/go/CY3215A-DK © 2012 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. Doc.#: 001-80388 Rev. **