CY8CKIT-003 PSoC 3 FirstTouch Starter Kit Quick Start Guide.pdf

PSOC® 3 FIRSTTOUCH™ STARTER KIT
QUICK START GUIDE
Out of Box Demo: PSoC Rocks!
1
2
Connect the 9-V battery to the board.
Wave the kit and view the message,
as shown.
3
4
Insert the kit CD and run the CD’s
autorun utility.
Open the guide and install software.
PSOC® 3 FIRSTTOUCH™ STARTER KIT
QUICK START GUIDE
CapSense® Proximity Sensor
Voltage Regulator
General-purpose Switch
CY8C3866AXI
PSoC 3 Device Accelerometer
CapSense Slider
J4 Voltage
Regulator
Source Select
8 Red LED Outputs
12-Pin Wireless
Header
9-V Battery
Header
USB Mini B
Port
J1 Vddio Power
Source Select
Thermistor
28-Pin External
I/O (on reverse)
CY7C68013A
FX2LP High-Speed USB
Kit Revision
To know if you are using the latest kit, look for the kit revision in the white sticker at the bottom left
on the back of the kit box. If the revision reads CY8CKIT-003B REV. **, then you own the latest
version. You can also check the silicon marketing part number on the board; the part number
should be CY8C3866AXI-040. This kit is equipped with production PSoC 3 silicon.
For the latest information about this kit, visit
http://www.cypress.com/go/CY8CKIT-003
© 2009-2012 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered
trademarks referenced herein are the properties of their respective owners.
Doc.#: 001-53755 Rev.*D
Similar pages